TUP110-S05

TRUMPower D E SCR IPTION T he TUP110 series of AC/DC switching power supplies are for 110 watts of continuous output power. They are enclosed in a 94V-1 rated polyphenylene-oxide case with an IEC 320 inlet to mate with interchangeable cord for world-wide use. An on/off switch can be added at request. All models meet CISPR 22 and FCC class B emission limits, and comply with UL, CSA, IEC and CE requirements. 110 WATT POWER ADAPTERS TUP110 SERIES (LVD+EMC) F EATU R E S ‧ ‧ ‧ ‧ ‧ ‧ ‧ ‧ ‧ S i n g l e , d u a l , t r i p l e o r q u a d r u p l e o u t p u ts Optional output connectors Optional on/off sw itch Optional Power Fail Detect (PFD) signal 100% burn-in W i d e i n p u t r a n g e 8 5 t o 2 6 4 VA C Input surge current protection O v e r v o l ta g e p r o t e c t i o n s Overcurrent protections S af et y Sta n da rd A ppr o va ls ： UL 60950-1 CSA C22.2 No. 60950-1 TÜV EN60950-1 I N PUT S PE C IF ICAT ION S I n p u t v o l ta g e ： 8 5 t o 2 6 4 VA C Input frequency： 47 to 63 Hz Input current： 3 . 2 0 A （ r m s ） f o r 11 5 VA C 1 . 8 0 A （ r m s ） f o r 2 3 0 VA C L e a k a g e c u r r e n t ： 0 . 4 0 m A m a x . @ 11 5 VA C , 6 0 H z 0 . 8 0 m A m a x . @ 2 3 0 VA C , 5 0 H z E N V IR O N M ENTA L SP E C IF ICATI O N S Operating temperature： Storage temperature： Relative humidity： Derating： 0ºC to +70ºC -40ºC to +85ºC 5% to 95% non-condensing Derate from 100% at +50ºC linearly to 50% at +70ºC O UTPUT SPECIFICATIONS O utput voltage/current ： Total output power ： R ipple and noise ： O vervoltage protection ： S ee rating chart 110 watts maximum 1 % peak to peak maximum P rovided on output #1 only; set at 112 – 132% of its nominal output voltage G ENERAL SPECIFICATIONS S witching frequency ： 20K to 250KHz, varies with load and line E fficiency ： 7 0% minimum on single output models with Vo ≥ 12V, 65% minimum on the others H old-up time ： 1 2 msec minimum at 110VAC L ine regulation ： ± 0.5% maximum at full load I nrush current ： 1 5 amps @ 115VAC, or 30 amps @ 230VAC, at 25ºC cold start W ithstand voltage ： 3 000VAC from input to output 1500VAC from input to ground 500VAC from output to ground M TBF ： 5 50,000 hours minimum at full load at 25ºC ambient , calculated per MIL-HDBK-217F, excluding DC fan E MC performance (EN55024) EN55022: C lass B conducted, class B radiated FCC: C lass B conducted, class B radiated VCCI: C lass B conducted, class B radiated EN61000-3-2: H armonic distortion, class A EN61000-3-3: L ine flicker EN61000-4-2: E SD, ±8KV air and ±4KV contact EN61000-4-3: R adiated immunity, 3V/m EN61000-4-4: F ast transient/burst, ±1KV EN61000-4-5: S urge, ±1KV diff, ±2KV com. EN61000-4-6: C onducted immunity, 3Vrms EN61000-4-8: M agnetic field immunity, 1A/m E N 6 1 0 0 0 - 4 - 11 : Voltage dips, 30% reduction for 500ms and >95% reduction for 10ms O vercurrent protection ： A ll outputs protected to short circuit conditions Temperature coefficient ： A ll outputs ±0.04%/ºC maximum Transient response ： M aximum excursion of 4% or better on all models, recovering to 1% of final value within 500µs after a 25% step load change P FD signal (optional) ： T TL logic high for normal operation and TTL logic low upon loss of input power. This signal appears at least 1ms prior to +5V output dropping 5% below its nominal value. This signal also provides a minimum delay of 100ms after +5V is within regulation. Tumbler Technologies + TRUMPower 3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA Phone: 408-988-6616 ● Fax: 408-988-6622 ● email: sales@trumpower.com ● Website: www.TRUMPower.com UNIVERSAL INPUT OUTPUT VOLTAGE/CURRENT RATING CHART Product No. Vnom. TUP110-S05 5V TUP110-S12 12V TUP110-S15 15V TUP110-S24 24V TUP110-S30 30V TUP110-S48 48V TUP110-D23 +5V TUP110-T31 +5V TUP110-T32 +5V TUP110-Q40 +5V TUP110-Q41 +5V TUP110-Q42 +5V TUP110-Q45 +5V TUP110-Q45-1 +5V TUP110-Q45-2 +5V TUP110-Q46 +5V Output #1 Imin. Imax. 0A 22A 0A 9.0A 0A 7.5A 0A 4.5A 0A 3.6A 0A 2.3A 0A 10A 0A 10A 0A 10A 0A 10A 0A 10A 0A 10A 0A 10A 2A 10A 0A 10A 0A 10A Tol. 5% 4% 3% 3% 3% 3% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% Output #2 Vnom. Imin. Imax. Ipeak. (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) +12V 0A 5A 9.0A +12V 0A 5A 9.0A +15V 0A 4A 7.5A +12V 0A 5A 9.0A +15V 0A 4A 7.5A +12V 0A 5A 9.0A +12V 0A 5A 9.0A +12V 0A 5A 9.0A +24V 0A 3A 5.0A +15V 0A 4A 7.5A Tol. Output #3 Vnom. Imin. Imax. (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) -12V 0A 1A -15V 0A 1A -12V 0A 1A -15V 0A 1A -12V 0A 1A -12V 0A 1A -12V 0A 1A -12V 0A 1A -15V 0A 1A Tol. TUP110 SERIES Output #4 Imin. Imax. Tol. (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) (N/A) 0A 1A 5% 0A 1A 5% 0A 1A 5% 0A 1A 5% 15A 3A 10% 0A 1A 5% 0A 1A 5% Maximum Output Power 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W 110W Vnom. 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% 5% -5V +24V +12V +24V +24V +12V -5V Notes: (1) Peak output current with 10% maximum duty cycle for less than 60 seconds. Total peak power must not exceed 130 watts. (2) The output #1 of model TUP110-Q45-1 needs a minimum current of 2A to support the other outputs at their maximum rated loads. MECHANICAL SPECIFICATIONS NOTES: 1. 2. 3. 4. 5. 6. Dimensions show in inch [mm] Tolerance 0.02 [0.5] maximum Weight: 1.40 Kgs (3.08 Lbs.) approx. Standard output connector is a male 8-pin power DIN. Please contact TRUMPower for other options. To order a model with on/off switch, add suffix “S” to the model number, e.g. TUP110-T31-K1-S. To order a model with PFD signal, add suffix “PF” to the model number, e.g. TUP110-T31-K1-PF. PIN CHART PIN 1 Product No. TUP110-S05 TUP110-S15 TUP110-S30 TUP110-D23 TUP110-T31 TUP110-S12 TUP110-S24 TUP110-S48 RETURN COMMON RETURN COMMON RETURN COMMON RETURN RETURN N.C. OUTPUT #3 OUTPUT #3 OUTPUT #1 OUTPUT #1 OUTPUT #1 OUTPUT #1 RETURN N.C. N.C. OUTPUT #4 OUTPUT #1 OUTPUT #2 OUTPUT #2 OUTPUT #2 RETURN COMMON RETURN COMMON RETURN COMMON RETURN OUTPUT #1 OUTPUT #1 OUTPUT #1 OUTPUT #1 N.C. or PFD N.C. or PFD N.C. or PFD N.C. or PFD 2 3 4 5 6 7 8 TUP110-T32 TUP110-Q40 TUP110-Q41 TUP110-Q42 TUP110-Q45 TUP110-Q45-1 TUP110-Q45-2 TUP110-Q46 Tumbler Technologies + TRUMPower 3350 Scott Blvd., Bldg. 13, Santa Clara, California 95054, USA Phone: 408-988-6616 ● Fax: 408-988-6622 ● email: sales@trumpower.com ● Website: www.TRUMPower.com