6A2

6A05 6.0 AMP SILICON RECTIFIERS THRU 6A10 VOLTAGE RANGE 50 TO 1000 Volts CURRENT FEATURES * Low forward voltage drop * High current capability * High reliability * High surge current capability 6.0 Amperes R-6 .360(9.1) .340(8.6) DIA. 1.0(25.4) MIN. MECHANICAL DATA * Case: Molded plastic * Epoxy: UL 94V-0 rate flame retardant * Lead: Axial leads, solderable per MIL-STD-202, method 208 guranteed * Polarity: Color band denotes cathode end * Mounting position: Any * Weight: 1.65 grams .360(9.1) .340(8.6) .052(1.3) .048(1.2) DIA. 1.0(25.4) MIN. Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Rating 25 C ambient temperature uniess otherwies specified. Single phase half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%. TYPE NUMBER Maximum Recurrent Peak Reverse Voltage Maximum RMS Voltage Maximum DC Blocking Voltage Maximum Average Forward Rectified Current .375"(9.5mm) Lead Length at Ta=60 C Peak Forward Surge Current, 8.3 ms single half sine-wave superimposed on rated load (JEDEC method) Maximum Instantaneous Forward Voltage at 6.0A Maximum DC Reverse Current Ta=25 C at Rated DC Blocking Voltage Ta=100 C Typical Junction Capacitance (Note 1) Typical Thermal Resistance RqJA (Note 2) Operating and Storage Temperature Range TJ, TSTG NOTES: 6A05 50 35 50 6A1 100 70 100 6A2 200 140 200 6A4 400 280 400 6.0 400 0.95 10.0 400 100 10 -65 +175 6A6 600 420 600 6A8 800 560 800 6A10 1000 700 1000 UNITS V V V A A V A A pF C/W C 1. Measured at 1MHz and applied reverse voltage of 4.0V D.C. 2. Thermal Resistance from Junction to Ambient .375" (9.5mm) lead length. RATING AND CHARACTERISTIC CURVES (6A05 THRU 6A10) FIG.1-TYPICAL FORWARD CHARACTERISTICS AVERAGE FORWARD CURRENT,(A) FIG.2-TYPICAL FORWARD CURRENT DERATING CURVE 500 INSTANTANEOUS FORWARD CURRENT,(A) 6 5 4 3 2 1 0 0 20 40 60 80 Single Phase Half Wave 60Hz Resistive Or Inductive Load Ground Plane 1" X 1" Copper surface area PC BOARD Standard PC Board Mounting PC BOARD Recommended PC Board Mounting 100 40 10 Tj=25 C Pulse Width 300us 1% Duty Cycle 100 120 140 160 180 200 AMBIENT TEMPERATURE,( C) 1 FIG.4-MAXIMUM NON-REPETITIVE FORWARD SURGE CURRENT PEAK FORWARD SURGE CURRENT,(A) 500 .6 .8 1.0 1.2 1.4 1.6 1.8 2.0 400 FORWARD VOLT AGE,(V) 300 Tj=25 C 8.3ms Single Half Sine Wave JEDEC method 200 100 FIG.3 - TYPICAL REVERSE CHARACTERISTICS 100 0 1 5 10 50 100 NUMBER OF CYCLES AT 60Hz REVERSE LEAKAGE CURRENT, ( A) 10 Tj=100 C FIG.5 - TYPICAL THERMAL RESISTANCE VS. LEAD LENGTH 1.0 THERMAL RESISTANCE, ( C/W) 25 20 15 10 5 .1 Tj=25 C .01 0 20 40 60 80 100 120 140 0 .1 .2 .3 .4 .5 .6 .7 .8 .9 1.0 PERCENT OF RATED PEAK REVERSE VOLT AGE,(%) EQUAL LEAD LENGTH TO HEAT SINK, INCHES