U8803

UNISONIC TECHNOLOGIES CO., LTD U8803 PIR INFRARED REMOTE CONTROL CIRCUIT DESCRIPTION The UTC U8803 is a integrated circuit that design for infrared PIR controlling. It needs only few external components in application circuit. It can be applied as controller of light, electric switching and burglar alarm, and so on. CMOS IC D IP-16 FEATURES *High Noise Immunity *Output drivable RELAY or TRIAC. *contain two OP amps, gain adjustable. *Control time adjustable. *steady voltage inside output 3.1 V to drive the PIR directly. *Integrate zero cross detect, the AC power supply triggers synchronously, lowering the power supply pollution. *Pb-free plating product number: U8803L ORDERING INFORMATION Order Number Normal Lead Free Plating U8803-D16-T U8803L-D16-T Package DIP-16 Packing Tube U8803L-D16-T (1)Packing Type (2)Package Type (3)Lead Plating (1) T: Tube (2) D16: DIP-16 (3) L: Lead Free Plating, Blank: Pb/Sn www.unisonic.com.tw Copyright © 2005 Unisonic Technologies Co., Ltd 1 of 7 QW-R502-094,A U8803 PIN CONFIGURATION CMOS IC UOU1 NII 1 II 1 VREF GND TB QTEST TC1 1 2 3 4 5 6 7 8 UTC U8803 16 15 14 13 12 11 10 9 UOU2 NII 2 II 2 VDD ZCD RELAY TRIAC CDS PIN DESCRIPTION PIN NO. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 PIN NAME UOU1 NⅡ1 Ⅱ1 VREF GND TB QTEST TCI CDS TRIAC RELAY ZCD VDD Ⅱ2 NⅡ2 UOU2 FUNCTION First stage OP amp output First stage OP amp positive input First stage OP amp negative input Reference voltage Ground Time base for System Clock. The periods TTb =(1±20%)RC/1.1 Test Timer clock generator. The periods TTci =(1±20%)RC/1.1 CDS detect, inhibitory output in the daytime. TRIAC output, active low RELAY output, active high Detect zero cross of AC line, synchronously pin TRIAC Power supply Second stage OP amp negative input Second stage OP amp positive input Second stage OP amp output UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 7 QW-R502-094,A U8803 BLOCK DIAGRAM CMOS IC UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 7 QW-R502-094,A U8803 FUNCTIONAL DESCRIPTION CMOS IC 1. The PIR amplifier (the first and second stage Op Amp) amplifies PIR signal. Its multiple can be adjust through resistance and capacitance outside. 2. If the amplificatory PIR signal voltage is higher than VH (Typ 1.8V) or lower than VL (Typ 1.15V), the Window Comparer outputs high level. 3. The Pulse Width Detector detects the Window Comparer’s pulse width, if the high pulse width is more than 768*TTb, this pulse is in effect, and the RELAY or the traic is triggered. Otherwise, it is ignored. 4. When an availability PIR signal is detected, the RELAY outputs high level, and the TRAIC outputs pulse, and the Counter starts to count, but if a new availability PIR signal appears, the Counter restarts to count. After 245760*TTci, the RELAY and TRIAC stop output. 5. Pin CDS connect a CDS, it can control pin RELAY to keep low level in the daytime. 6. When the AC power crosses zero line, the Zero Cross Detector generates a pulse, and permits the TRIAC to be triggered, after 32*TTb. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 7 QW-R502-094,A U8803 ABSOLUTE MAXIMUM RATINGS PARAMETER Power Supply VDD with Repect to VSS Voltage on any Pin SYMBOL VDD - VSS CMOS IC RATINGS UNIT 5.6 V V -0.3 ~ 5.6 ℃ Operating Temperature TOPR 0 ~ 70 ℃ Storage Temperature TSTG -65 ~ 150 Note: Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS PARAMETER Power Supply Voltage Keep Current Reference Voltage Reference Voltage Output Current Gain of OP Amp TRIAC Sink Current TRIAC Source Current RELAY Source Current RELAY Sink Current SYMBOL VDD IDD VREF IREF ISINK(TRIAC) ITSOURCE(TRIAC) ISOURCE(RELAY) ISINK(RELAY) TEST CONDITONS VDD＝5V 3.1±0.3V 200 60 15 50 5 5 MIN TYP 5.0±10% MAX 1 UNIT V mA V µA dB mA µA mA mA UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 7 QW-R502-094,A U8803 TYPICAL APPLICATION CIRCUIT 1. TRIAC CONTROL CMOS IC 15k 47u 1 UOU1 820k 33n 2 NII1 15k 3 II1 33u 100u 4 VREF 5 GND 6 TB {RES2} 100 p 7 QTEST 8 TCI 0.01u UOU2 16 NII2 15 II2 14 FUSE VDD 13 1M ZCD 12 470 K RELAY 11 TRIAC 10 CDS 9 470u 5.1V 22u 560k 0.047 u PIR 47k 0.01u 330 CDS LOAD 47 1M 4.7K U8803 10u 100k 1M 0.47u/250V 2. RELAY CONTROL 15k 47u 1 UOU1 820k 33n 2 NII1 15k 3 II1 33u 100u VDD 6 TB {RES2} 100 p 7 QTEST 8 TCI 0.01u 4 VREF 5 GND UOU2 16 NII2 15 II2 14 VDD VDD 13 100 u ZCD 12 RELAY 11 5.6K TRIAC 10 CDS 9 47K 0.47u FUSE 100 0.047u LOAD 22u 560k 0.047 u PIR 47k 0.01u 2.4k 5.1V 470u RELAY 20V/1W 1M 4.7K U8803 10u CDS 1M UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 6 of 7 QW-R502-094,A U8803 CMOS IC UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 7 of 7 QW-R502-094,A