UT134G

UTC UT134F/G TRIACS DESCRIPTION Glass passivated triacs in a plastic envelope, intended for use in applications requiring highbidirectional transient and blocking voltage capability and high thermal cycling performance. Typical applications include motor control, industrial and domestic lighting, heating and static switching. TRIAC 1 SYMBOL MT2 TO-126 G 1:MT1 2:MT2 3:GATE MT1 ABSOLUTE MAXIMUM RATINGS PARAMETER Repetitive peak off-state voltages UT134F/G-5 UT134F/G-6 UT134F/G-8 SYMBOL VDRM RATINGS 500 600* 800 4 UNIT V RMS on-state current full sine wave; Tmb ≤107 °C Non-repetitive peak on-state current (Full sine wave; Tj = 25 °C prior to surge) t = 20ms t = 16.7 ms I2t for fusing t = 10 ms Repetitive rate of rise of on-state current after triggering ITM = 6 A; IG = 0.2A;dIG /dt = 0.2A/μs T2+ G+ T2+ GT2- GT2- G+ Peak gate voltage Peak gate current Peak gate power Average gate power (over any 20 ms period) Storage temperature Operating junction temperature IT(RMS) A ITSM I2t 25 27 3.1 A A2s dIT /dt 50 50 50 10 5 2 5 0.5 -40 ~ 150 125 A/μs VGM IGM PGM PG(AV) Tstg Tj V A W W ℃ ℃ UTC UNISONIC TECHNOLOGIES CO., LTD. 1 QW-R401-008,B UTC UT134F/G TRIAC *Although not recommended, off-state voltages up to 800V may be applied without damage, but the traic may switch to the on-state. The rate of rise of current should not exceed 3A/µs. THERMAL RESISTANCES PARAMETER Thermal resistance Junction to mounting base Full cycle Half cycle Thermal resistance Junction to ambient (In free air) SYMBOL Rth j-mb Rth j-a MIN TYP MAX 3.0 3.7 UNIT K/W K/W K/W 100 STATIC CHARACTERISTICS (Tj=25°C, unless otherwise stated) PARAMETER Gate trigger current IGT SYMBOL CONDITIONS VD = 12 V; IT = 0.1 A T2+ G+ T2+ GT2- GT2- G+ VD = 12 V; IGT = 0.1 A T2+ G+ T2+ GT2- GT2- G+ VD = 12 V; IGT = 0.1 A IT = 5 A VD = 12 V; IT = 0.1 A VD = 400V ; IT = 0.1 A; Tj =125°C VD = VDRM(max) ; Tj = 125 °C MIN TYP MAX UT134F UT134G UNIT 5 8 11 30 7 16 5 7 5 1.4 0.7 0.4 0.1 25 25 25 70 20 30 20 30 15 1.7 1.5 50 50 50 100 30 45 30 45 30 mA Latching current IL mA Holding current On-state voltage Gate trigger voltage IH VT VGT 0.25 mA V V V mA Off-state leakage current ID 0.5 DYNAMIC CHARACTERISTICS (Tj=25°C, unless otherwise stated) PARAMETER Critical rate of rise of Off-state voltage Critical rate of change of Commutating voltage Gate controlled turn-on time SYMBOL dVD /dt CONDITIONS VDM = 67% VDRM(max) ; Tj =125°C; exponential waveform; gate open circuit VDM=400V;Tj=95°C;IT(RMS)=4A; dIcom /dt =1.8A/ms; gate open circuit ITM = 6 A; VD= VDRM(max) ; IG=0.1A; dIG/dt=5A/µs MIN UT134F UT134G 50 200 TYP 250 MAX UNIT V/µs dVcom/dt 10 50 V/µs tgt 2 µs UTC UNISONIC TECHNOLOGIES CO., LTD. 2 QW-R401-008,B UTC UT134F/G TYPICAL CHARACTERISTICS 8 Ptot/W 7 6 5 4 3 2 1 0 0 1 α α Tmb(max)/C IT(RMS)/A TRIAC 101 5 4 3 2 1 104 α=180 107 120 110 90 60 113 30 116 119 122 107℃ 125 5 2 3 4 IT(RMS)/A Fig.1. Maximum on-state dissipation,Ptot,versus rms on-state current,IT(RMS)where α=conduction angle. 0 -50 0 50 100 150 Tmb/C Fig.4. Maximum permissible rms current lT(RMS), versus mounting base temperature Tmb IT(RMS)/A 12 ITSM/A 1000 IT T 100 ITSM 10 time 8 6 4 T2-G+ quadrant 10 10us 2 10ms 100ms 0 0.01 0.1 1 10 Tj initial=25℃max dIT/dt limit 100us 1ms T/s Fig.2.Maximum Permissible non-repetitive peak on-state Current ITSM,versus pulse width tp, for sinusoidal currents,tp≦20ms ITSM/A IT T ITSM time surge duration /S Fig. 5.Maximum permissible repetitive rms on-state current lT(RMS),versus surge duration,for sinusoidal currents,f=50HZ;Tmb≦107℃ VGT(Tj) VGT(25℃) 30 25 20 15 10 5 1.6 1.4 Tj initial=25℃max 1.2 1 0.8 0.6 0 0 0 0 10 100 1000 0.4 -50 50 50 100 100 150 150 Number of cycles at 50Hz Fig3.Maximum Permissible non-repetitive peak on-state current ITSM,versus number of cycles,for sinusoidal currents,f=50HZ. Tj/℃ Fig.6. Normalised gate trigger voltage temperature Tj. VGT(Tj)/VGT(25℃),versus junction UTC UNISONIC TECHNOLOGIES CO., LTD. 3 QW-R401-008,B UTC UT134F/G I GT(Tj) IGT(25℃) T2+G+ T2+GT2-GT2-G+ TRIAC IT/A 12 10 8 6 4 2 Tj=125 ℃ Tj=25 ℃ 3 2.5 2 1.5 1 0.5 max typ Vo=1.27V Rs=0.091Ohms 0 -50 0 50 Tj/℃ 100 150 0 0 0.5 1 1.5 VT/V 2 2.5 3 Fig. 7.Normalised gate trigger Current IGT(Tj)/IGT(25℃ ),versus junction temperature Tj. IL(Tj) IL (25℃) Fig.10.Typical and maximum on-state characteristic. 3 2.5 2 1.5 1 0.5 10 Zth j-mb(K/W ) unidirectional bidirectional 1 0.1 PD tp t 0 -50 0 50 Tj/℃ 100 150 0.01 10us 0.1ms 1ms 10ms tp/s 0.1s 1s 10s Fig.8.Normalised latching Current IL(Tj)/IL(25℃ ), versus junction temperature Tj IH(Tj) 3 IH (25℃) 2.5 2 1.5 1 0.5 0 -50 0 50 Tj/℃ Fig. 9.Normalised holding current IH (Tj)/IH (25℃ ), versus junction temperature Tj. 100 150 1 10 100 1000 Fig.11.Transient thermal impedance Zthj-mb,versus pulse width tp. dVcom/dt(V/us) off-state dV/dt limit UT134G UT134F dlcom /dt=5.1 A/ms 3.9 3 2.3 1.8 1.4 0 150 100 Tj/C Fig.12.Typical commutation dV/dt versus junction temperature,parameter commutation dlT/dt.The triac should commutate when the dV/dt is below the value on the appropriate curve for pre-commutation dl T/dt 50 UTC UNISONIC TECHNOLOGIES CO., LTD. 4 QW-R401-008,B UTC UT134F/G TRIAC UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UTC UNISONIC TECHNOLOGIES CO., LTD. 5 QW-R401-008,B