UT232A

UNISONIC TECHNOLOGIES CO., LTD UT232A Preliminary CMOS ENHANCED RS-232 LINE DRIVERS/RECEIVERS DESCRIPTION The UTC UT232A is the enhanced versions RS-232 line drivers/receivers. Enhancements of use performance include increased drive current for longer and more flexible cable configurations and 10V/µs slew rate, 120k bits per second guaranteed transmission rate and Ease of use enhancements include enhanced ESD protection, low power dissipation, smaller, 0.1µF charge pump capacitors, and overall ruggedized construction for commercial environments. DIP-16 SOP-16 FEATURES * Receiver input levels:±30V * Single 5V power supply * 0.1µF small charge pump capacitors * High data rate-120kbps * High output slew rate 10V/µs * ≤1µA low power shutdown * 3-State outputs of TTL/CMOS receiver * Multiple drivers and receivers Lead-free: UT232AL Halogen-free: UT232AG ORDERING INFORMATION Normal UT232A-D16-T UT232A-S16-R Ordering Number Lead Free UT232AL-D16-T UT232AL-S16-R Halogen Free UT232AG-D16-T UT232AG-S16-R Package DIP-16 SOP-16 Packing Tube Tape Reel www.unisonic.com.tw Copyright © 2009 Unisonic Technologies Co., Ltd 1 of 5 QW-R502-272.b UT232A PIN CONFIGURATION Preliminary CMOS UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 2 of 5 QW-R502-272.b UT232A ABSOLUTE MAXIMUM RATINGS PARAMETER Supply voltage range Positive-output supply voltage range Negative-output supply voltage range Preliminary CMOS SYMBOL RATINGS UNIT VCC 6 V V+ (VCC-0.3) ~+13.2 V V13.2V V TIN -0.3~(VCC+0.3) V Input Voltages ±30 V RIN TOUT (V+, +0.3) ~(V-, -0.3) V Output Voltages -0.3~(Vcc+0.3) V ROUT Short Circuit Duration TOUT Continuous Power Dissipation PD 375 mW Operating Temperature TOPR 0 ~ +70 °С Note Absolute maximum ratings are those values beyond which the device could be permanently damaged. Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (VCC=+5V±10%; 0.1µF charge pump capacitors; TMIN to TMAX unless otherwise specified.) PARAMETER SYMBOL TEST CONDITIONS MIN TTL INPUT Logic Threshold Logic Pull up Current Maximum Data Rate TTL OUTPUT TTL/CMOS Output Voltage RS-232 OUTPUT Output Voltage Swing Output Resistance Output Short Circuit Current RS-232 INPUT Voltage Range Voltage Threshold Low High VO(SW) RO IO(SC) All transmitter outputs loaded With 3kΩ to Ground VCC=0V; VOUT=±2V Infinite duration ±5 300 ±18 -30 0.8 0.2 3 +30 1.2 1.7 0.5 5 1.5 SR SR CL=10pF, RL=3-7kΩ; TA=+25°С CL=2500pF, RL=3kΩ;measured from +3V ~ -3V or -3V ~ +3V No load, TA=+25°С; VCC=5V All transmitters RL=3kΩ;TA=+25°С 10 25 30 10 15 2.4 1.0 7 ±9 V Ω mA V V V V kΩ µs V/µs V/µs mA mA Low High VOL VOH IOUT=3.2mA; VCC=+5V IOUT=-1.0mA 0.4 3.5 V V Low High VTHR TIN; EN , SD TIN; EN , SD TIN=0V CL=2500pF, RL=3kΩ 2.0 15 120 200 TYP MAX UNIT 0.8 V V µA k Hysteresis Resistance DYNAMIC CHARACTERISTICS Propagation Delay, RS232 to TTL Instantaneous Slew Rate Transition Region Slew Rate POWER REQUIREMENTS VCC Power Supply Current VTHR(L) VTHR(H) VHYS RI VCC=5V, TA=+25°С VCC=5V, TA=+25°С TA=+25°С, -15V≤VIN≤+15V UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 3 of 5 QW-R502-272.b UT232A APPLICATION INFORMATION Preliminary CMOS To operate from a single +5V supply, the UTC UT232A include charge pump voltage converters which can allow it. To generate the RS-232 output levels these converters convert the +5V input power to the ±10V needed. The current drain due to charge pump operation is considerably reduced, typically to 400µA with this power supplied externally. The UTC UT232A can operate over the commercial, industrial and military temperature ranges. Protection from Shorts to ±15V Against shorts to ground, any other driver output, and V+ or V- the driver outputs are protected. If the outputs is connected to voltages higher than ±15V inadvertently, then the external protection is recommended to be provided. While voltages exceeding ±15V ,for protection, two back-to-back zener diodes which is connected from each output to ground will clamp the outputs to an acceptable voltage level. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 4 of 5 QW-R502-272.b UT232A Preliminary CMOS UTC assumes no responsibility for equipment failures that result from using products at values that exceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, or other parameters) listed in products specifications of any and all UTC products described or contained herein. UTC products are not designed for use in life support appliances, devices or systems where malfunction of these products can be reasonably expected to result in personal injury. Reproduction in whole or in part is prohibited without the prior written consent of the copyright owner. The information presented in this document does not form part of any quotation or contract, is believed to be accurate and reliable and may be changed without notice. UNISONIC TECHNOLOGIES CO., LTD www.unisonic.com.tw 5 of 5 QW-R502-272.b