AZ767-1C-24D

AZ767 SPDT SUBMINIATURE POWER RELAY FEATURES • • • • Low cost 10 Amp switching Epoxy sealed version available UL, CUR file E44211 CONTACTS Arrangement Ratings SPST-NO Standard coil Sensitive coil SPDT GENERAL DATA SPST (1 Form A) SPDT (1 Form C) Resistive Load: Max. Max. Max. Max. switched switched switched switched power: 150 W or 1250 VA current: 5 ADC or 10 AAC power: 90 W or 750 VA current: 3 A Life Expectancy Mechanical Electrical Operate Time (typical) Release Time (typical) Minimum operations 1 x 107 1 x 105 at 5 A 250 VAC Res. 8 ms at nominal coil voltage 5 ms at nominal coil voltage (with no coil suppression) Max. switched power: 90 W or 750 VA Max. switched current: 3 A Max. switched voltage: 150 VDC* or 380 VAC * Note: If switching voltage is greater than 30 VDC, Dielectric Strength 2500 Vrms coil to contact (at sea level for 1 min.) 1000 Vrms between open contacts Insulation Resistance Dropout Ambient Temperature Operating Storage Vibration Shock Enclosure Terminals Max. Solder Temp. Max. Solder Time Max. Solvent Temp. Max. Immersion Time Weight 1000 megohms min. at 20°C 500 VDC 50% RH Greater than 5% of nominal coil voltage At nominal coil voltage -40°C (-40°F) to 70°C (158°F) standard -40°C (-40°F) to 85°C (185°F) sensitive -40°C (-40°F) to 105°C (221°F) 0.062" (1.5 mm) DA at 10–50 Hz 10 g operating, 100 g damage P.B.T. polyester Tinned copper alloy, P. C. 270°C (518°F) 5 seconds 80°C (176°F) 30 seconds 6 grams 50 per plastic tray / 500 per carton box special precautions must be taken. Please contact the factory Rated Load UL, CUR Standard coil Form A 10 A at 125 VAC, Res., 30k cycles 5 A at 30 VDC / 250 VAC, 100k cycles 10 A LRA / 1.5 A FLA at 120 VAC, 100k cycles 1/ 10 HP at 125 VAC, 100k cycles 1/ HP at 250 VAC, 100k cycles 6 5 A at 125 VAC, Res., 100k cycles 3 A at 30 VDC / 250 VAC, 100k cycles Form C 3 A at 30 VDC / 250 VAC, 100k cycles Sensitive coil Material Resistance Silver cadmium oxide < 100 milliohms initially COIL Power At Pickup Voltage (typical) Max. Continuous Dissipation Temperature Rise (at nominal voltage) Temperature 253 mW standard coil 113 mW sensitive coil 1.25 W at 20°C (68°F) ambient 41°C (74°F) standard coil 22°C (40°F) sensitive coil Max. 130°C (266°F) Packing unit in pcs NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Specifications subject to change without notice. ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-08 Junkersstrasse 3, D-82178 Puchheim, Germany AZ767 RELAY ORDERING DATA STANDARD RELAYS COIL SPECIFICATIONS Nominal Coil VDC 3 5 6 9 12 18 24 Must Operate VDC 2.25 3.75 4.5 6.75 9.0 13.5 18.0 Max. Continuous VDC 5.0 8.3 10.0 15.0 20.0 30.0 40.0 Coil Resistance Ohm ± 10% 20 55 80 180 320 720 1,280 ORDER NUMBER* Form A (SPST) AZ767–1A–3D AZ767–1A–5D AZ767–1A–6D AZ767–1A–9D AZ767–1A–12D AZ767–1A–18D AZ767–1A–24D Form C (SPDT) AZ767–1C–3D AZ767–1C–5D AZ767–1C–6D AZ767–1C–9D AZ767–1C–12D AZ767–1C–18D AZ767–1C–24D SENSITIVE RELAYS COIL SPECIFICATIONS Nominal Coil VDC 3 5 6 9 12 18 24 Must Operate VDC 2.25 3.75 4.5 6.75 9.0 13.5 18.0 Max. Continuous VDC 7.5 12.5 15.0 22.4 30.0 44.7 59.2 Coil Resistance Ohm ± 10% 45 125 180 400 720 1,600 2,800 ORDER NUMBER* Form A (SPST) AZ767–1A–3DS AZ767–1A–5DS AZ767–1A–6DS AZ767–1A–9DS AZ767–1A–12DS AZ767–1A–18DS AZ767–1A–24DS * Add suffix “E” for epoxy sealed version. MECHANICAL DATA PC BOARD LAYOUT .073 [1.85] .059 [1.50] .100 [2.54] .417 MAX. [10.59] .058 [1.49] .300 [7.62] .740 MAX. [18.80] 5 x ø .052 [ø1.3] .441 [11.20] FORM C ONLY Viewed toward terminals WIRING DIAGRAMS .614 MAX. [15.59] Form A Form C .147 [3.73] .073 [1.85] Viewed toward terminals Dimensions in inches with metric equivalents in parentheses. Tolerance: ± .010" ZETTLER electronics GmbH Tel. +49 89 800 97 0 Fax +49 89 800 97 200 office@ZETTLERelectronics.com www.ZETTLERelectronics.com 2005-03-08 Junkersstrasse 3, D-82178 Puchheim, Germany