FR156

FR151 THRU FR157 FAST RECOVERY RECTIFIER Reverse Voltage - 50 to 1000 Volts Forward Current - 1.5 Amperes DO-204AC FEATURES * * * * * * Fast switching Low leakage Low forward voltage drop High current capability High current surge High reliability 0.140(3.6) 0.104(2.6) DIA. 0.300(7.6) 0.230(5.8) 1.0(25.4) MIN. 1.0(25.4) MIN. MECHANICAL DATA Case : JEDEC DO-204AC molded plastic Epoxy : UL 94V-O rate flame retardant Lead : MIL-STD-202F method 208C guaranteed Mounting Position : Any Weight : 0.38 gram 0.034(0.86) 0.028(0.71) DIA. *Dimensions in inches and (millimeters) MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS Ratings at 25 C ambient temperature SYMBOLS unless otherwise specified. Maximum repetitive peak reverse voltage Maximum RMS voltage Maximum DC blocking voltage Maximum average forward rectified current at TA=75 C Peak forward surge current 8.3ms single half sine-wave superimposed on rated load (JEDEC Method) Maximum instantaneous forward voltage at 1.5 A Maximum Full Load Reverse Current Full Cycle average, 0.375" (9.5mm) lead length at TL=55 C Maximum DC reverse current at rated DC blocking voltage Maximum reverse recovery time (NOTE 1) Typical junction capacitance (NOTE 2) Operating junction and storage temperature range o o o FR151 50 35 50 FR152 100 70 100 FR153 200 140 200 FR154 400 280 400 FR155 600 420 600 FR156 800 560 800 FR157 1000 700 1000 UNITS Volts Volts Volts Amps VRRM VRMS VDC I(AV) 1.5 IFSM VF IR(AV) 60 1.3 100 Amps Volts uA TA=25 C o IR trr CJ TJ,TSTG 150 5.0 250 40 -65 to +150 500 uA nS pF o C NOTES : (1) Reverse recovery test condition : IF 0.5A, IR=1.0A, Irr=0.25A (2) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts REV. : 0 Zowie Technology Corporation RATINGS AND CHARACTERISTIC CURVES FR151 THRU FR157 FIG.1 - FORWARD CURRENT DERATING CURVE 2.0 AVERAGE FORWARD RECTIFIED CURRENT, AMPERES Single Phase Half Wave 60Hz Resistive or Inductive Load FIG.2 - MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT 60 PEAK FORWARD SURGE CURRENT, AMPERES 50 40 30 20 10 0 8.3ms SINGLE HALF SINE-WAVE (JEDEC Method) 1.5 1.0 0.5 0 0 25 50 75 100 125 o 150 175 1 10 NUMBER OF CYCLES AT 60Hz 100 AMBIENT TEMPERATURE, C FIG.3 - TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS 10.00 IINSTANTANEOUS FORWARD CURRENT, AMPERES JUNCTION CAPACITANCE, pF FIG.4 - TYPICAL REVERSE CHARACTERISTICS FIG.5 - TYPICAL JUNCTION CAPACITANCE 200 100 60 40 20 10 6 4 2 1 .1 .2 .4 1.0 2 4 10 TJ = 2 5 C o PULSE WIDTH=300uS 1% DUTY CYCLE 1.00 0.10 20 40 100 REVERSE VOLTAGE, VOLTS 0.01 0.4 0.6 0.8 1.0 1.2 1.4 1.6 INSTANTANEOUS FORWARD VOLTAGE, VOLTS FIG.6 - TEST CIRCUIT DIAGRAM AND REVERSE RECOVERY TIME CHARACTERISTICS 50 NONINDUCTIVE 10 NONINDUCTIVE +0.5A (-) PULSE GENERATOR ( NOTE 2 ) trr (+) 25 Vdc ( approx ) (-) D.U.T. 0 -0.25A 1 NONINDUCTIVE OSCILLOSCOPE ( NOTE 1 ) (+) -1.0A NOTES : 1. Rise Time = 7ns max. Input Impedance= 1 megohm. 22pF. 2. Rise Time = 10ns max. Source Impedance= 50 ohms. SET TIME BASE FOR 50/100 ns/cm REV. : 0 Zowie Technology Corporation