ATWILC1000-MR110UB

ATWILC1000-MR110xB IEEE® 802.11 b/g/n Link Controller Module Introduction The ATWILC1000-MR110xB module is a low-power consumption IEEE 802.11 b/g/n IoT (Internet of Things) module, which is specifically optimized for low-power IoT applications. The ATWILC1000-MR110xB modules feature small form factor (21.7 mm x 14.7 mm x 2.1 mm) while fully integrating Power Amplifier (PA), Low Noise Amplifier (LNA), Transmit/Receive (T/R), switch and power management. The ATWILC1000-MR110PB includes a PCB antenna, whereas the ATWILC1000-MR110UB module includes a U.FL connector to use with an external antenna. With advanced security, it is interoperable with various vendors using IEEE 802.11b/g/n Access Points in wireless LAN. The module provides Serial Peripheral Interface (SPI) and Secure Digital Input Output (SDIO) to interface with the host controller. Notes:  All references to the ATWILC1000-MR110xB module include all the modules listed below unless otherwise noted: • ATWILC1000-MR110PB • ATWILC1000-MR110UB Features • • • • • • • • • • • • • • • • • Compliant with IEEE 802.11 b/g/n 20 MHz (1 x 1) Solution Supports Single Spatial Stream in 2.4 GHz ISM Band Integrated Power Amplifier (PA) and Transmit/Receive (T/R) Switch Superior Sensitivity and Range through Advanced PHY Signal Processing Advanced Equalization and Channel Estimation Advanced Carrier and Timing Synchronization ® Wi-Fi Direct and Soft-AP Support Supports IEEE 802.11 WEP, WPA, WPA2 and WPA2-Enterprise Security Superior Medium Access Control (MAC) Throughput through Hardware Accelerated Two-Level A-MSDU/AMPDU Frame Aggregation and Block Acknowledgement On-Chip Memory Management Engine to Reduce the Host Load SPI and SDIO Host Interfaces Operating Temperature Ranges from -40°C to +85°C Input/Output Operating Voltage (VDDIO) of 1.62V to 3.6V Power supply for DC/DC Convertor (VBAT) has a range of 3.0V to 4.2V Built-In 26 MHz Crystal Power-Save Modes: –