MX575ABA25M0000

MX575ABA25M0000 Ultra-Low Jitter 25MHz LVPECL XO ClockWorks® FUSION General Description Features The MX575ABA25M0000 is an ultra-low phase jitter XO with LVPECL output optimized for high line rate applications. • 25MHz LVPECL • Typical phase noise: - 88fs (Integration range: 1.875MHz-5MHz) • ±50ppm total frequency stability • -40°C to +85°C temperature range • Industry standard 6-Pin 7mm x 5mm LGA package Absolute Maximum Ratings¹ Operating Ratings² Supply Voltage (VIN)..................................................+4.6V Lead Temperature (soldering, 10s)..............................260°C Case Temperature........................................................115°C Storage Temperature (T )............................-65°C to +125°C S ESD Machine Model.....................................................200V ESD Rating (HBM).........................................................2kV Supply Voltage (VIN).......................+2.375V to +3.63V Ambient Temperature (TA)....................-40°C to +85°C Junction Thermal Resistance LGA (T ) Still Air.....................................53°C/W JC Electrical Characteristics VDD = 2.375 - 3.63V, TA = -40°C to +85°C, outputs terminated with 50Ω to VDD - 2V.³ Symbol Parameter IDD Supply Current F0 Center Frequency Condition Min. Typ. Max. Units 120 mA 25 Frequency Stability Note 4 Øj Phase Noise Integration Range (12kHz to 5MHz) Integration Range (1.875MHz to 5MHz) Tstart Start-Up Time TR/TF Rise/Fall time Duty Cycle MHz ±50 152 88 ppm fsRMS 20 ms 85 350 ps 45 55 % VOH Output High Voltage LVPECL output levels VDD - 1.35 VDD - 1.01 VDD - 0.8 V VOL Output Low Voltage LVPECL output levels VDD - 2.0 VDD - 1.78 VDD - 1.6 V Vswing Peak to Peak Output Voltage Swing 0.65 0.77 0.95 V Notes: 1. Exceeding the absolute maximum ratings may damage the device. 2. The device is not guaranteed to function outside its operating ratings. 3. Guaranteed after thermal equilibrium. 4. Inclusive of initial accuracy, supply voltage, temperature drift, aging (5yrs), shock, vibration. ClockWorks is a registered trademark of Microchip Technology Inc. Microchip Technology Inc. May 20, 2021 MX575AB1-4363 http://www.microchip.com Revision 1.0 tcghelp@microchip.com Microchip Technology Inc. MX575ABA25M0000 Ordering Information Ordering Part Number Marking Line 1 Marking Line 3 Shipping Package MX575ABA25M0000 MX575AB A25M0000 Tube 6-Pin 7mm x 5mm LGA MX575ABA25M0000-TR MX575AB A25M0000 Tape and Reel 6-Pin 7mm x 5mm LGA Devices are Green and RoHS compliant. Sample material may have only a partial top mark. Pin Configuration OE VDD DNC /Q GND Q Pin Description Pin Number Pin Name Pin Type Pin Level 1 OE I, SE LVCMOS 2 DNC 3 GND PWR 4, 5 Q, /Q O, Diff 6 VDD PWR Pin Function Output Enable, disables output to tri-state, 0 = Disabled, 1 = Enabled, 50kΩ Pull-Up (Internal) Make no connection, leave floating. Power Supply Ground LVPECL Clock Output Frequency = 25MHz Power Supply Environmental Specifications Thermal Shock MIL-STD-883, Method 1011, Condition A Moisture Resistance MIL-STD-883, Method 1004 Mechanical Shock MIL-STD-883, Method 2002, Condition C Mechanical Vibration MIL-STD-883, Method 2007, Condition B Resistance to Soldering Heat J-STD-020C, Table 5-2 Pb-free devices (except 2 cycles max) Hazardous Substance Pb-Free / RoHS / Green Compliant Solderability JESD22-B102-D Method 2 (Preconditioning E) Terminal Strength MIL-STD-883, Method 2004, Test Condition D Gross Leak MIL-STD-883, Method 1014, Condition C Fine Leak MIL-STD-883, Method 1014, Condition A2, R1=2x10-8 atm cc/s MSL Level Crystal - MSL-1, Package MSL-3 Solvent Resistance MIL-STD-202, Method 215 May 20, 2021 MX575AB1-4363 2 Revision 1.0 tcghelp@microchip.com Microchip Technology Inc. MX575ABA25M0000 Figure 1. LVPECL Output 25MHz 1.875MHz-5MHz 88fs Figure 2. LVPECL Output 25MHz 12kHz-5MHz 152fs May 20, 2021 MX575AB1-4363 3 Revision 1.0 tcghelp@microchip.com Microchip Technology Inc. MX575ABA25M0000 Figure 3. PK-PK jitter (5.56pSec) May 20, 2021 MX575AB1-4363 4 Revision 1.0 tcghelp@microchip.com Microchip Technology Inc. MX575ABA25M0000 Package Information and Recommended Land Pattern for 6-Pin LGA³ 6-Pin LGA (7x5mm) Note: 3. Package information is correct as of the publication date. For updates and most current information, go to www.microchip.com. Microchip Technology Inc. http://www.microchip.com Microchip makes no representations or warranties with respect to the accuracy or completeness of the information furnished in this data sheet. This information is not intended as a warranty and Microchip does not assume responsibility for its use. Microchip reserves the right to change circuitry, specifications and descriptions at any time without notice. No license, whether express, implied, arising by estoppel or otherwise, to any intellectual property rights is granted by this document. Except as provided in Microchip's terms and conditions of sale for such products, Microchip assumes no liability whatsoever, and Microchip disclaims any express or implied warranty relating to the sale and/or use of Microchip products including liability or warranties relating to fitness for a particular purpose, merchantability, or infringement of any patent, copyright or other intellectual property right. © 2021 Microchip Technology Inc. May 20, 2021 MX575AB1-4363 5 Revision 1.0 tcghelp@microchip.com