PL502-04SC-R

PL502-04 Low Phase Noise VCXO (96MHz to 200MHz) FEATURES      Low phase noise VCXO output for the 96MHz to 200MHz range (-128 dBc at 10kHz offset) LVCMOS output 12 to 25MHz crystal input Integrated variable capacitors Selectable High Drive (30mA) or Standard Drive (10mA) output Wide pull range (± 250 ppm typ) Low period jitter: 4ps RMS 3.3V operation Available in 8-Pin SOP XOUT 1 N/C 2 VCON 3 GND 4 PL502-04     PIN CONFIGURATION 8 XIN 7 OE^ 6 VDD 5 CLK SOP-8L OUTPUT RANGE DESCRIPTION The PL502-04 is a low cost, high performance, low phase noise VCXO, providing less than -128dBc at 10kHz offset in the 96MHz to 200MHz operating range. The very low jitter (4 ps RMS period jitter) makes this chip ideal for applications requiring vol tage controlled frequency sources. Input crystal can range from 12MHz to 25MHz (fundamental resonant mode). MULTIPLIER FREQUENCY RANGE OUTPUT BUFFER X8 96 - 200MHz LVCMOS BLOCK DIAGRAM VCO Divider Reference Divider XIN XOUT XTAL OSC Phase Comparator Charge Pump Loop Filter VCO CLK OE VARICAP VCON Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 5/16/11 Page 1 PL502-04 Low Phase Noise VCXO (96MHz to 200MHz) PIN DESCRIPTIONS Name Number Type Description XOUT 1 I Crystal output. See Crystal Specifications on page 4. N/C 2 - Not connected. VCON 3 I Voltage Control input. GND 4 P Ground. CLK 5 O Output clock. VDD 6 P +3.3V power supply. OE 7 I Output Enable. Internal Pull Up. XIN 8 I Crystal input. See Crystal Specifications on page 4. ELECTRICAL SPECIFICATIONS 1. Absolute Maximum Ratings PARAMETERS SYMBOL Supply Voltage MIN. V DD MAX. UNITS 4.6 V Input Voltage, dc VI -0.5 V DD+0.5 V Output Voltage, dc VO -0.5 V DD+0.5 V Storage Temperature TS -65 150 C Ambient Operating Temperature* TA -40 85 C Junction Temperature TJ 125 C Lead Temperature (soldering, 10s) 260 C ESD Protection, Human Body Model 2 kV Exposure of the device under conditions beyond the limits specified by Maximum Ratings for extended periods may cause permane nt damage to the device and affect product reliability. These conditions represent a stress rating only, and functional oper ations of the device at these or any other co nditions above the operational limits noted in this specification is not implied. Note: Operating Temperature is guaranteed by design for all parts (CO MMERCIAL and INDUSTRIAL), but tested for COMMERCIAL grade on ly. 2. AC Electrical Specifications PARAMETERS SYMBOL CONDITIONS Input Crystal Frequency TYP. 12 Output Clock Rise/Fall Time (Standard Drive) t r/t f Output Clock Rise/Fall Time (High Drive) t r/t f Output Clock Duty Cycle MIN. 0.3V ~ 3.0V, 15 pF load MAX. UNITS 25 MHz 2.4 ns 0.3V ~ 3.0V, 15 pF load Measured @ 50% V DD 1.2 45 50 55 % Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 5/16/11 Page 2 PL502-04 Low Phase Noise VCXO (96MHz to 200MHz) 3. DC Specifications PARAMETERS SYMBOL CONDITIONS MIN. F XIN = 25MHz Output load 10pF TYP. MAX. UNITS 20 25 mA 3.63 V Supply Current, Dynamic, with Loaded Outputs I DD Operating Voltage V DD Output Drive Current (High Drive) I OH V OH= V DD -0.4V, V DD =3.3V 30 mA I OL V OL = 0.4V, V DD = 3.3V 30 mA Output Drive Current (Standard Drive) I OH V OH= V DD -0.4V, V DD =3.3V 10 mA I OL V OL = 0.4V, V DD = 3.3V 10 mA 2.97 50 Short Circuit Current VCXO Control Voltage VCON 0 mA 3.3 V 4. Voltage Control Crystal Oscillator PARAMETERS VCXO Stabilization Time * SYMBOL T VCXOSTB CONDITIONS MIN. TYP. From power valid VCXO Tuning Range F XIN = 12 – 25MHz; XTAL C0 /C1 < 250 0V  VCON  3.3V CLK output pullability VCON=1.65V, 1.65V UNITS 10 ms 500 ppm 200 VCXO Tuning Characteristic ppm 165 Pull range linearity ppm/V 10 VCON pin input impedance VCON modulation BW MAX. 0V  VCON  3.3V, -3dB % 2000 kΩ 10 kHz Note: Parameters denoted with an asterisk (*) represent nominal characterization data and are not production tested to any specific limits. 5. Jitter and Phase Noise Specification PARAMETERS CONDITIONS RMS Period Jitter (1 sigma – 1000 samples) At 155MHz with capacitive decoupling between VDD and GND. Phase Noise relative to carrier MIN. TYP. MAX. UNITS 4 ps 155.52MHz @100Hz offset -95 dBc/Hz Phase Noise relative to carrier 155.52MHz @1kHz offset -120 dBc/Hz Phase Noise relative to carrier 155.52MHz @10kHz offset -128 dBc/Hz Phase Noise relative to carrier 155.52MHz @100kHz offset -122 dBc/Hz Phase Noise relative to carrier 155.52MHz @1MHz offset -120 dBc/Hz Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 5/16/11 Page 3 PL502-04 Low Phase Noise VCXO (96MHz to 200MHz) 6. Crystal Specifications PARAMETERS Crystal Resonator Frequency Crystal Loading Capacitance Rating SYMBOL MIN. F XIN 12 TYP. CL (x ta l) UNITS 25 MHz 9.5 pF C0/C1 ESR MAX. RS 250 - 30 Ω Note: Crystal Loading rating: 9.5pF is the loading the crystal sees from the VCXO chip at VCON = 1.65V. It is assumed that the cr ystal will be at nominal frequency at this load. If the crystal requires more load to be at nominal frequency, the additiona l load must be added externally. This however may reduce the pull range. PACKAGE INFORMATION (GREEN PACKAGE COM PLIANT) 8 PIN SOP (in mm) Symbol A A1 B C D E H L e Min. Max. 1.47 1.73 0.10 0.25 0.33 0.51 0.19 0.25 4.80 4.95 3.80 4.00 5.80 6.20 0.38 1.27 1.27 BSC E H D A A1 C e B L Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 5/16/11 Page 4 PL502-04 Low Phase Noise VCXO (96MHz to 200MHz) ORDERING INFORM ATION (GREEN PACKAGE COM PLIANT) For part ordering, please contact our Sales Department: 2180 Fortune Drive, San Jose, CA 95131, USA Tel: (408) 944-0800 Fax: (408) 474-1000 PART NUMBER The order number for this device is a combination of the following: Part number, Package type and Operating temperature range PL502-04 H X X X Part Number Shipping Option Blank=Tube R=Tape & Reel Optional High Drive Package Type S=SOP-8L Part/Order Number PL502-04SC PL502-04SC-R PL502-04HSC PL502-04HSC-R Temperature Range C=Commercial (0°C to 70°C) I=Industrial (-40°C to 85°C) Marking P502-04 SC LLLLL P502-04H SC LLLLL Package Option SOP - Tube SOP - Tape and Reel SOP - Tube SOP - Tape and Reel *Note: “LLL” or “LLLLL” are designates lot number Micrel Inc., reserves the right to make changes in its pr oducts or specifications, or both at any time without notice. The information furnished by Micrel is believed to be accurate and reliable. However, Micrel makes no guarantee or warranty concerning the accuracy of said info rmation and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: Micrel’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of Micrel Inc. Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 5/16/11 Page 5