PL602-04SC

PL602-04 Low Phase Noise CMOS XO (96MHz to 200MHz) FEATURES     Low phase noise XO output for the 96MHz to 200MHz range (-125 dBc at 10kHz offset). 12 to 25MHz crystal input. Integrated crystal load capacitor: no external load capacitor required. Selectable High Drive (30mA) or Sta ndard Drive (10mA) output. 3.3V operation. Available in 8-Pin TSSOP or SOIC. CLK 1 VDD 2 OE^ 3 XIN 4 PL602-04   PIN CONFIGURATION 8 GND 7 GND 6 N/C 5 XOUT Note: ^ denotes internal pull up OUTPUT RANGE DESCRIPTION The PL602-04 is a low cost, high performance and low phase noise XO, providing less than -125dBc at 10kHz offset in the 96MHz to 200MHz operating range. The very low jitter makes this chip ideal for applications requiring clean reference frequency sources. Input crystal can range from 12 to 25MHz (fundamental resonant mode). FREQUENCY RANGE 96 - 200MHz MULTIPLIER X8 OUTPUT BUFFER CMOS BLOCK DIAGRAM VCO Divider Reference Divider XIN XOUT Phase Comparator Charge Pump Loop Filter VCO CLK OE XTAL OSC Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 1 PL602-04 Low Phase Noise CMOS XO (96MHz to 200MHz) PIN DESCRIPTIONS Name Number Type Description CLK 1 O Output clock. VDD 2 P power supply. OE 3 I Output enable input. Disables (tri-state) output when low. Internal pull-up enables output by default if pin is not connected to low. XIN 4 I Crystal input. See Crystal Specification on page 3. XOUT 5 I Crystal output. See Crystal Specification on page 3. N/C 6 - Not connected. GND 7, 8 P Ground. ELECTRICAL SPECIFICATIONS 1. Absolute Maximum Ratings PARAMETERS SYMBOL MIN. MAX. UNITS 4.6 V V V Supply Voltage VDD Input Voltage, dc Output Voltage, dc Storage Temperature VI VO TS -0.5 -0.5 -65 VDD +0.5 VDD +0.5 150 C Ambient Operating Temperature* Lead Temperature (soldering, 10s) ESD Protection, Human Body Model TA -40 85 260 2 C C kV Exposure of the device under conditions beyond the limits specified by Maximum Ratings for e xtended periods may cause permanent damage to the device and affect product reliability. These conditions represent a stress rating only, and functional operations of the dev ice at these or any other co nditions above the operational limits noted in this specification is not implied. * Note: Operating Temperature is guaranteed by design for all parts (COMMERCIAL and INDU STRIAL), but tested for COMMERCIAL grade only. 2. DC Specifications PARAMETERS Supply Current, Dynam ic, with Loaded Outputs Operating Voltage SYMBOL IDD CONDITIONS MIN. F XIN = 12 - 25MHz Output load of 10pF VDD 2.97 TYP. MAX. UNITS 35 mA 3.63 V Output drive current (High Drive) I OH VOH = VDD -0.4V, V DD =3.3V 30 mA I OL VOL = 0.4V, V DD = 3.3V 30 mA Output drive current (Standard Drive) I OH VOH = VDD -0.4V, V DD =3.3V 10 mA I OL VOL = 0.4V, V DD = 3.3V 10 mA Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944-0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 2 PL602-04 Low Phase Noise CMOS XO (96MHz to 200MHz) 3. AC Specifications PARAMETERS SYMBOL CONDITIONS Input Crystal Frequency Output Clock Rise/Fall Time (Standard Drive) Output Clock Rise/Fall Time (High Drive) Output Clock Duty Cycle MIN. TYP. 12 0.3V ~ 3.0V with 15 pF load 2.4 0.3V ~ 3.0V with 15 pF load 1.2 Measured @ 50% V DD 45 50 MIN. TYP. MAX. UNITS 25 MHz ns 55 % 4. Jitter and Phase Noise Specification PARAMETERS CONDITIONS MAX. UNITS RMS Period Jitter (1 sigma – 1000 samples) Phase Noise relative to carrier at 80MHz, with capacitive decoupling between VDD and GND. 155.52MHz @100Hz offset 20 ps -100 dBc/Hz Phase Noise relative to carrier 155.52MHz @1kHz offset -115 dBc/Hz Phase Noise relative to carrier 155.52MHz @10kHz offset -125 dBc/Hz Phase Noise relative to carrier Phase Noise relative to carrier Phase Noise relative to carrier 155.52MHz @100kHz offset 155.52MHz @1MHz offset 155.52MHz @10MHz offset -116 -114 -132 dBc/Hz dBc/Hz dBc/Hz 5. Crystal Specifications PARAMETERS Crystal Resonator Frequency Crystal Loading Capacitance Rating Driving power ESR SYMBOL MIN. F XIN C L (xtal) 12 TYP. MAX. UNITS 25 MHz pF mW 30  20 1 RS PACKAGE INFORMATION 8 PIN ( dimensions in mm ) TSSOP Min. A Narrow SOIC Max . 1.34 1.74 - Max . 1.20 A1 0.10 0.25 0.05 0.15 B 0.33 0.51 0.19 0.30 C 0.19 0.25 0.09 0.20 D 4.80 4.95 2.90 3.10 Symbol Min. E 3.80 4.00 4.30 4.50 H 5.80 6.20 6.20 6.60 L 0.38 1.27 0.45 e 1.27 BSC E H D A 0.75 0.65 BSC A1 C L B e Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944-0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 3 PL602-04 Low Phase Noise CMOS XO (96MHz to 200MHz) ORDERING INFORM ATION For part ordering, please contact our Sales Department: 2180 Fortune Drive, San Jose, CA 95131, USA Tel: (408) 944-0800 Fax: (408) 474-1000 PART NUMBER The order number for this device is a combination of the following: Device number, Package type and Operating temperature range PL 602-04 (H ) X C PART NUMBER TEMPERATURE C=COMMERCIAL I=INDUSTRAL Optional High Drive PACKAGE TYPE S=SOIC, O=TSSOP Part/Order Number (Commercial) PL602-04OC PL602-04OC-R PL602-04HOC PL602-04HOC-R PL602-04SC PL602-04SC-R PL602-04HSC PL602-04HSC-R Marking* Package Option P602-04 OC LLLLL 8-Pin SOP Tube P602-04 HOC LLLLL 8-Pin SOP Tube 8-Pin SOP (Tape and Reel) 8-Pin SOP (Tape and Reel) P602-04 SC LLLLL 8-Pin SOP Tube P602-04 HSC LLLLL 8-Pin SOP Tube 8-Pin SOP (Tape and Reel) 8-Pin SOP (Tape and Reel) *Note: LLLLL designates lot number Micrel Inc., reserves the right to make changes in its products or specifications, or both at any time without notice. The in formation furnished by Micrel is believed to be accurate and reliable. However, Micrel makes no guarantee or warranty concerning the accuracy of said info rmation and shall not be responsible for any loss or damage of whatever nature resulting from the use of, or reliance upon this product. LIFE SUPPORT POLICY: Micrel’s products are not authorized for use as critical components in life support devices or systems without the express written approval of the President of Micrel Inc. Micrel Inc. • 2180 Fortune Drive • San Jose, CA 95131 • USA • tel +1(408) 944 -0800 • fax +1(408) 474-1000 • www.micrel.com Rev 11/16/11 Page 4