VSC7424EV

VSC7424 10-Port Layer-2 Gigabit Ethernet Switch with 8 Fully Integrated Copper PHYs and Embedded 416 MHz CPU Microsemi’s next-generation switch delivers the industry’s lowest power GbE switching solution. The VSC7424 is the industry’s first fully integrated 10-port Gigabit Ethernet switch with eight copper PHYs in a single package. The VSC7424 leverages Microsemi’s new 65 nm SimpliPHY™ technology, resulting in the one of the most cost-effective and lowest power consumption devices in the industry. The single-chip solution combines the most advanced Ethernet energy efficiency features for bringing green technology solutions to market. The VSC7424 provides a rich set of Small Medium Enterprise (SME) Ethernet switching features such as Layer-2 forwarding with advanced TCAM-based VLAN and QoS processing, enabling the delivery of differentiated services. Security is ensured through frame processing using a TCAM-based Versatile Content Aware Processor (VCAP-II). The VSC7424 contains a powerful 416 MHz CPU, enabling full management of the switch. Highlights • Supports IEEE 802.3az and green energy efficiency modes with ActiPHY™ and PerfectReach™ • Lowest BOM solution requires only one IC • Up to two SGMII ports with 100 Mbps and 1 Gbps fiber support Applications • Ethernet switches • Edge and Access platforms • Customer-premises equipment (CPE) and network termination equipment (NTE) A comprehensive application programming interface (API) and software development package is available for Layer-2 Managed Ethernet applications for faster time-to-market. The software API package integrates easily with third-party software, preserving existing software investments. RAM SPI Flash DDR2 SI VSC7424 SparX-III 2× SGMII 10× 1G Switch with 8 Copper PHYs 8 SFP SFP MagJacks Fiber Modules Copper Microsemi makes no warranty, representation, or guarantee regarding the information contained herein or the suitability of its products and services for any particular purpose, nor does Microsemi assume any liability whatsoever arising out of the application or use of any product or circuit. The products sold hereunder and any other products sold by Microsemi have been subject to limited testing and should not be used in conjunction with mission-critical equipment or applications. Any performance specifications are believed to be reliable but are not verified, and Buyer must conduct and complete all performance and other testing of the products, alone and together with, or installed in, any end-products. Buyer shall not rely on any data and performance specifications or parameters provided by Microsemi. It is the Buyer’s responsibility to independently determine suitability of any products and to test and verify the same. The information provided by Microsemi hereunder is provided “as is, where is” and with all faults, and the entire risk associated with such information is entirely with the Buyer. Microsemi does not grant, explicitly or implicitly, to any party any patent rights, licenses, or any other IP rights, whether with regard to such information itself or anything described by such information. Information provided in this document is proprietary to Microsemi, and Microsemi reserves the right to make any changes to the information in this document or to any products and services at any time without notice. VSC7424 10-Port Layer-2 Gigabit Ethernet Switch with 8 Fully Integrated Copper PHYs and Embedded 416 MHz CPU Best-In-Class Power Consumption • Jumbo frame support up to 12.2 kilobytes with per-port programmable MTU • Q-in-Q tagging support • 4 megabits of integrated shared packet memory • Lowest power 10-port Gigabit Ethernet switch available in the market • Green energy efficiency modes including ActiPHY™, PerfectReach™, and Draft IEEE 802.3az • Single IC reduces overall power requirements • Optimal power consumption for all link speeds • Audio and video bridging (AVB) QoS • Eight QoS queues per port with strict or deficit-weighted round robin scheduling • QoS classification based on IEEE 802.1p, EtherType, VID, MAC/IP addresses, IPv4/IPv6 DSCP, and UDP/TCP ports and ranges • Data rate shaper and policer per-queue, per-port for both ingress and egress directions • Full-duplex flow control (IEEE 802.3x) and half-duplex backpressure, symmetric and asymmetric Features • Eight integrated IEEE 802.3ab-compliant 10/100/1000BASE-T Ethernet copper transceivers with VeriPHY™ cable diagnostics • Integrated 416 MHz MIPS CPU with DDR2 and serial Flash interface • Advanced Access and QoS Control Lists (ACL and QCL) support through TCAM-based match patterns • Integrated temperature monitoring circuit • Integrated fan controller • 8 K MAC addresses and 4 K VLAN support • Supports IEEE 1149.1 JTAG boundary scan, IEEE 1149.6 ACJTAG, 1 Gbps SGMII, and 100BASE-FX and 1000BASE-X • Multicast and broadcast storm control with flooding control Key Specifications • 1 V core power supply • 1.8 V and 2.5 V I/O power supplies • 27 mm × 27 mm thermally enhanced plastic BGA package Layer 2 Switching • 10-port Gigabit Ethernet switch with nonblocking wire-speed performance • Link aggregation (IEEE 802.3ad) with programmable traffic distribution based on Layer 2 through Layer 4 information • Wire-speed hardware-based learning and CPU-based learning configurable per port • Independent and shared VLAN learning Related Products Visit www.microsemi.com for information about these related products: • Ethernet switches • 1G copper PHYs L2 Forwarding and Policers Shared Queue System 4 Mb Memory MIPS CPU Audio Video Bridging Ingress and Egress Statistics DDR2 Controller TCAM-based Security DWRR Scheduler and Shapers TCAM-based Classification, TCAM-based VLAN Editing, Translation, and Remarking Translation, and Remarking 10× 1G MAC Microsemi Corporate Headquarters One Enterprise, Aliso Viejo, CA 92656 USA Within the USA: +1 (800) 713-4113 Outside the USA: +1 (949) 380-6100 Sales: +1 (949) 380-6136 Fax: +1 (949) 215-4996 email: sales.support@microsemi.com www.microsemi.com 8× Copper PHY 1× 1G SGMII 1× 1G SGMII 8× 10/100/1000 Mbps 1× SGMII 1000BASE-X 100BASE-FX 1× SGMII 1000BASE-X 100BASE-FX JTAG, SPI, MIIM 32× GPIO: PI LED UART SIO Two-Wire Serial Fan Controller Signal Detect Microsemi Corporation (Nasdaq: MSCC) offers a comprehensive portfolio of semiconductor and system solutions for communications, defense and security, aerospace, and industrial markets. Products include high-performance and radiationhardened analog mixed-signal integrated circuits, FPGAs, SoCs, and ASICs; power management products; timing and synchronization devices and precise time solutions; voice processing devices; RF solutions; discrete components; enterprise storage and communications solutions, security technologies, and scalable anti-tamper products; Ethernet solutions; Power-over-Ethernet ICs and midspans; custom design capabilities and services. Microsemi is headquartered in Aliso Viejo, California, and has approximately 4,800 employees worldwide. Learn more at www.microsemi.com. ©2010–2016 Microsemi Corporation. All rights reserved. Microsemi and the Microsemi logo are registered trademarks of Microsemi Corporation. All other trademarks and service marks are the property of their respective owners. VPPD-02600. 1.0. 4/16