ADAM-5030

ADAM-5202 ADAM-5240 ADAM-5030 NEW NEW 2-port AMONet Master Module 4-axis Stepping/Pulse-type Servo Motor Control Module 2-slot SD Storage Module NEW ADAM-5202 RoHS 2002/95/EC COMPLIANT ADAM-5240 RoHS 2002/95/EC COMPLIANT ADAM-5030 RoHS 2002/95/EC COMPLIANT Specifications General       Certifications Power Consumption Connectors LED Indictors Number of Rings Transmission Speed CE 0.5 W (Max.) RJ-45 Active, Error (Each Port) 2 2.5, 5, 10 or 20 Mbps with automatic data flow control Half duplex RS-485 with transformer isolation CAT5 UTP/STP Ethernet cable 10 kV Max. 100 m (20 Mbps/32 slave modules) or 50 m (20 Mbps/64 slave modules) Distance 2 Rings with Max. 128 (1 Ring with 64 slaves) Module Number 0 ~ 50° C (32 ~ 122° F) Specifications General      Certifications Power Consumption Connectors Operating Temperature Relative Humidity CE 1.1 W (Max.) 100-pin SCSI-II female 0 ~ 60° C (32 ~ 140° F) 5 ~ 95 % RH non-condensing (refer to IEC 68-2-3) 4 Axis DC +12 ~ 24 Vdc 2/3-axis Linear Interpolation/2axis Circular Interpolation ±2, 147, 483, 646 for each axis 1PPS ~ 4MPPS 1PPS ~ 2MPPS 1PPS ~ 4MPPS Pulse /Direction (1-pulse, 1- direction type) Up/Down (2-pulse type) T/S-curve Acceleration/ Deceleration Specifications General Certification CE Power Consumption 0.5 W (Max) Storage Type SD (Secure Digital Card) Storage Number 2 USB Type USB Rev 2.0 (Compliant) USB Number 2 0 ~ 55° C (32 ~ 131° F) Operating Temperature  Max Storage 1 GB x 2  Format FAT-16  Interface PCI Bus Note: only for ADAM-5550 Series         Number of Axis  External Power input  Range  Speed  Speed Motion  Serial Interface  Cable Type  Surge Protection  Communication Continuous Interpolation Drive Output Pulses  Range  Pulse Output Type  Speed Curve Ordering Information  ADAM-5030 2-slot SD Storage Module  Communication Slave  Operating Temperature Note: only for ADAM-5550 Series  Encoder Pulse Input Type Quadrature (A/B phase or Up/Down)  Counts per Encoder Cycle X1, X2 ,X4 (A/B phase only)  Protection 1,000 Vdc isolation  Input Range 5 V ~ 30 V Input Pulse for Encoder Interface External Signals Driving  Input Signal  Max Input Frequency  Protection  Input Signal  Max Input Frequency  Protection  Input Signal Ordering Information  ADAM-5202 2-ring AMONet Master Module nEXOP + and nEXOP 100 Hz 1,000 Vdc Photo coupler isolation nIN1 ~ 3 4 kHz 1,000 Vdc Photo coupler isolation nALArm (servo alarm) nINPOS (position command completed) nOUT4 ~ 7 External Deceleration/Instantaneous Stop Signal Input Pulse for Servo Motor Drives General Purpose Output Signal  Ouput Signal  Input Signal  Protection Note: only for ADAM-5550 Series Emergency Stop EMG – one emergency stop input for ADAM-5240 1000 Vdc Photo coupler isolation and RC filtering Ordering Information  ADAM-5240 4-axis Stepping/Pulse Servo Motor Control Module PC-based Controllers & I/O Modules