AIMB-224G2-01A1E

AIMB-224 Mobile AMD R-series Quad Core/Dual Core Mini-ITX with VGA/LVDS/HDMI/DP/eDP, 6COM and Dual LAN Features ƒƒ Supprt AMD Mobile eTrinity Quard core/Dual Core processor ƒƒ Two 204-pin SODIMM up to 16 GB DDR3 1066/1333/1600 MHz SDRAM ƒƒ Supports VGA/LVDS/HDMI/DP/eDP ƒƒ Daul LANs, 6COM, 2Mini PCIe ƒƒ Supports embedded software APIs and Utilities Software APIs: SMBus H/W Monitor Watchdog GPIO Brightness Utilities: BIOS flash Monitoring Specifications Processor System Expansion Slot Memory Graphics Ethernet SATA EIDE Rear I/O Internal Connector Watchdog Timer Power Requirement Environment Physical Characteristics CPU Max. Speed L2 Cache Chipset BIOS PCI Mini-PCIe PCIe Technology Max. Capacity Socket Controller VRAM VGA LVDS HDMI Triple Display Interface Controller Connector Max Data Transfer Rate Channel Mode Channel VGA HDMI Ethernet USB Audio Serial DCjack KB/MB LVDS & Inverter USB Serial IDE SATA Parallel GPIO Output Interval Typical Temperature Dimensions AMD Quad Core R-464L AMD Quad Core R-460H AMD Dual Core R-272F 2.3 GHz (quard core 35W) 2.1 GHz (quard core 35W) 2.6 GHz (dual core 35W) 1M/per core AMD R-series+A70M AMI 32 Mbit SPI None 2 PCIex16 Dual Channel DDR3 1066/1333/1600 MHz 16 GB 2 x 204 pin SODIMM AMD Radeon™ GPUs, support DX11, UVD3 None Supports up to 4096 x 2400 @ 60 Hx Supports 24-bit dual channel up to 1920 x 1200. co-lay eDP (by BOM option). 1920 x 1200 @ 60 MHz co-lay Display port (by BOM option) Support triple display of any three display device (CRT, LVDS or eDP, HDMI or DP) 10/100/1000 Mbps GbE LAN1: Realtek 8111E; GbE LAN2: Realtek 8111E RJ-45 x 2 600 MB/s 3 None None 1 1 colay DP (by BOM option) 2 4 (four USB 3.0) 3 (Mic-in, Line-out, Line-in) 2 (2 RS-232) 1 (2.5 mm) 1 1 4 (USB2.0) 4 (3 RS-232; 1 RS-232/422/485; COM3 support 5v/12V by jumper selection) None 4 None 8 bit System reset Programmable 1 ~ 255 sec/min Single Voltage 12V DC input by 1x External DC phone Jack or 1x Internal 2x2-pin Power Connector; AT/ATX Supported by Jumper max power consumption: 90W(R-464L/R-460H+16G DDR3 RAM) Operating Non-Operating 0 ~ 60° C (32 ~ 140° F) -40 ~ 85° C (-40 ~ 185° F) 170 mm x 170 mm (6.69" x 6.69") Industrial Motherboards All product specifications are subject to change without notice Last updated : 21-Sep-2012 AIMB-224 Block Diagram Chrontel CH7511 eDP/LVDS DDR3 1333 MHz Dual channel dual channel 24-bit LVDS AMD R-series DP/HDMI Direct Media Interface 20-Gbit/s bandwidth PCIE x16 slot CRT 3 SATA ports 600MB/s 4 USB 2.0 ports; 4 USB 3.0 ports USB3.0/2.0 Realtek ALC892 HD Audio A70M PCIe x1 GbE LAN1: RTL8111E PCIe x1 GbE LAN2: RTL8111E PCIe x1 2mini-PCIe TPM SLB9635 LPC SPI BIOS Super IO Winbond W83627DHG-P FINTEK F81216AD PS/2, WDT, 8-bit GPIO, 2 RS-232 4 RS232, COM3 5V/12V, COM6 with RS422/485 auto flow control Ordering Information Part Number AIMB-224G2-00A1E AIMB-224G2-01A1E Display VGA/LVDS/DP VGA/eDP/HDMI Optional Accessories LAN 2 2 COM 6 6 TPM Yes Yes Packing List Part Number AIMB-224 SBC SATA HDD cable Serial port cable I/O port bracket Startup manual Driver CD CPU cooler Quantity 1 2 1 1 1 1 1 Part Number 1700003195 1700002204 1700008461 1757003064 Description USB cable with two ports, 17.5 cm USB cable with two ports, 27 cm USB cable with four ports, 30.5 cm Adapter AC100-240V, 84W, +12V/ 7A FSP Embedded OS/API OS/API Win XPE Software API WES7E Description WES 2009 SUSI V3.0 WIN 7 Embedded Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control GPIO SMBus I2C Monitor General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Display Watchdog Hardware Monitor Hardware Control A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Power Saving Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. System Throttling Backlight Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities BIOS Flash The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. Embedded Security ID The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. Monitoring The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. All product specifications are subject to change without notice eSOS The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature. Last updated : 21-Sep-2012