PCM-9377

PCM-9377 Audio Audio Power Power Switch Mini PCI USB 3/4 PC/104 USB 1/2 GPIO COM 2 COM1 Clear COMS LAN Watchdog IrDA KB/MS VGA HDD & PWR LED CPU Fan LCD 2 IDE LVDS TV enable Print Port Inverter Power LCD Power 3.5" SBC with VIA Mark, VGA/ LCD/ LVDS/ LAN/ USB Features  VIA® Mark 533/800 MHz Processor  Supports 18-bit TTL/ 36-bit LVDS/VGA/TV-out  Supports Mini PCI type III and PC/104 for expansion  Supports up to 2 COM ports, 4 USB ports, 8-bit GPIO LCD 1  Supports Embedded Software API and Utility SMBus Power Stand-by Power Software APIs: SMBus H/W Monitor Watchdog GPIO Backlight On/Off Utility: BIOS flash Monitoring Specifications CPU 2nd Cache Memory System Chipset BIOS System Memory Power Management SSD WatchDog Timer Expansion Interface Battery VGA COM RJ-45 K/B, Mouse LPT FDD RS-232 RS-232/422/485 K/B Mouse USB Audio IrDA GPIO SMBus Chipset Speed Interface Standard Chipset Memory Size Resolution Panel type Dual Simultaneous Display Dimension (L x W) Weight Operating Temperature Operating Humidity Power Supply Voltage Power Consumption Embedded VIA Mark CoreFusion 533/800 MHz processor, 128 M B L1 cache memory on die 64 KB on the processor VIA Mark processor AWARD 2 Mbit Flash BIOS SDRAM 144-pin SODIMM x1, Max. 512 MB with both PC100 and PC133 memory type ACPI supported Supports CompactFlash Card Type I/II 1 ~ 62 sec, 62-level time intervals system reset or IRQ11. PC/104 & Mini PCI type III Lithium 3 V/196 mAH 1 1 1 1 1 1 1 4 x USB1.1 AC97 CD-in, Line-in, Line-out, MIC-in 115 kbps, SIR, IrDA 1.0 compliant 8-bit general purpose input output Supported Intel 82551QM 10/100 Mbps RJ-45 connector IEEE 802.3u (100 Mbps) protocol compatible VIA Mark processor 8/16/32 MB frame buffer using system memory Support for all resolutions up to 1600 x 1200. CRT panel LCD panel Support for 18, 24, 36-bit TTL TFT LCD panels LVDS Interface 2-Channel (2 x 18-bit) LVDS interface TV-Out (optional) Supports both NTSC/PAL, S-video and Composite Video via PCM-232 TV-out module (with optional BIOS) CRT+ LVDS, CRT+ TTL, CRT+TV-out (w/PCM-232) 146 mm x 105 mm (5.7" x 4") 0.85 kg (weight of total package) 0 ~ 60° C (32 ~ 140° F) 10% ~ 90% Relative Humidity, non condensing AT/ATX, +5 V ±5%, +12V ±5%, or supports single +5 V power only Max (Test in HCT): 3.0 A @ +5 V (with 256 MB DRAM, VIA Mark 800) Typical (WinXP Idle Mode): 2.21A @ +5 V (with 256 MB DRAM, VIA Mark 800) General Coastline I/O Internal I/O Ethernet Display Mechanical and Environmental Power Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009 PCM-9377 Board Diagram Watch-Dog PC104 connector ISA bus CD-in , Line-in , MIC-in Line-out connector ALC650 AC97 CODEC Primary IDE connector Memory bus CompactFlash Type-II connector Floppy connector COM1 (RS-232) COM2 (RS-232/422/485) Print port (SPP/EPP/ECP Mode) USB connector Keyboard & PS2 mouse connector 8 bit GPIO/ Thermal Sensor VIA VT82C686B PCI bus SO-DIMM connector VGA connector TTL Panel connector LVDS Panel connector VIA Mark Intel 82551QM 10/100Mb Ethernet LAN connector Ordering Information Part No. PCM-9377F-M0A1E PCM-9377F-Q0A1E CPU CRT LVDS 1 1 TTL 1 1 LAN 1 FE 1 FE USB 4 4 RS-232 1 1 RS-232/422/485 1 1 LPT 1 1 GPIO 8-bit 8-bit PC/104 1 1 Thermal Passive Passive VIA Mark 533 1 VIA Mark 800 1 Operating Temp. 0 ~ 60° C 0 ~ 60° C Packing List Description 1 x PCM-9377 SBC 1 x Mini jumper pack 1 x Startup manual 1 x Utility CD 1 x Audio cable 1 x IDE 44 pin cable 1 x USB 2 port cable 1 x Keyboard/mouse cable 1 x Serial cable 1 x Printer port cable Part No. (p/n: 9689000002) Optional Accessories Part No. PCM-232-00A1E FDD cable Kit 9681000044 1701260125 1701340700 Embedded OS 2070000449 2070000450 2070000451 2070000607 2066002300 Description TV out module 1 x 26-34 pin FDD adapter 1 x slim FDD cable 1 x 34pin flat cable for FDD Image Win CE 5.0 Core Eng V1.1 PCM-9373/72 (19 MB) Image Win CE 5.0 Pro Eng V1.1 PCM-9373/72 (30 MB) Image Win CE5.0 ProPlus Eng V1.1PCM-9373/72 (32 MB) Image XPE SP2 V2.10 (ENG) (430 MB) SUSI Library V1.0 (p/n: 1703100152) (p/n: 1701440351) (p/n: 1703100121) (p/n: 1700060202) (p/n: 1701140201) (p/n: 1700260250) Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Monitor A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. GPIO Watchdog SMBus Hardware Monitor The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. I2C Hardware Control The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Display Power Saving The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. Backlight System Throttling Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature. BIOS Flash eSOS Embedded Security ID Flash Lock Monitoring Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009