PCM-9386F-S0A2E

PCM-9386 Audio LVDS ATX Power MIO Interface FDD SODIMM (Solder side) GPIO LPT HDD LED LAN SIR COM1 COM2 KB/Mouse CF (Solder side) USB Primary IDE LCD converter 3.5" SBC with Intel® ULV Celeron® M, VGA, LVDS, LAN, USB, MIO Features  Embedded Intel® ULV Celeron® M 600 MHz and 1.0 GHz processor  Supports 36-bit LVDS (48-bit LVDS optional)/VGA  100 Mbps Ethernet; Gigabit Ethernet (optional)  +5 V and +12 V power; or single +5 V power  Supports Embedded Software API and Utility Software APIs: GPIO H/W Monitor Watchdog Backlight On/Off SMBus CPU Speed System Throttling CRT FAN USB Utility: BIOS flash Monitoring Specifications Processor System CPU Front Side Bus L2 Cache Chipset BIOS Technology Max. Capacity Socket CompactFlash VGA COM RJ-45 USB K/B, Mouse LPT RS-232 RS-232/422/485 K/B Mouse USB Audio IrDA GPIO SMBus Mode Channel MIO 160 Speed Ethernet Controller Interface Controller VRAM LVDS LCD TV-Out Dual Independent Display Environment Operating Temperature Operating Humidity Power Type Power Supply Voltage Power Power Consumption Power Management Battery Output Interval Dimensions (L x W) Weight Intel Celeron M 600 MHz Intel Celeron M 1 GHz 400 MHz 400 MHz 512 KB Intel 852GM + ICH4 Intel 852GM + ICH4 Award 4 Mbit Award 4 Mbit DDR 200/266 MHz 1 GB 200-pin SODIMM Card Type I/II 1 1 1 1 1 1 1 2 x USB 2.0 AC97, Line-in, Line-out, Mic-in 115 kbps, SIR, IrDA 1.0 complaint (optional) 8-bit general purpose Input/Output Supported UDMA33 1 1 10/100 Mbps 10/100/1000 Mbps (optional) Intel 82551QM (with Wake on LAN) Intel 82541PI (Gigabit, Optional) 1 x RJ-45 Intel 852GM Optimized Shared Memory Architecture up to 64 MB system memory 1 x 36-bit LVDS (48-bit LVDS optional), Panel 16:9 wide screen panel supported Optional, by MIO-6254 module CRT + LVDS CRT + DVI / LVDS+ DVI (w/MIO-6254) 0 ~ 60° C (32 ~ 140° F) 10% ~ 90% relative humidity, non-condensing AT / ATX ATX: +5 V ± 5%, ±12 V ± 5% AT: 5V only to boot up (12 V is optional for LCD inverter and add on card) Max (Test in HCT): +5 V @ 2.0 A +12 V @ 0.02 A (Celeron M 600) APM1.2, ACPI2.0, wake on LAN, and modem ring-in functions Lithium 3 V / 196 mAH System reset Programmable 1 ~ 255 sec 146 x 102 mm (5.7" x 4") 0.85 kg (1.87 lb), weight of total package Memory SSD Coastline I/O Internal I/O EIDE Expansion Slot Display Watchdog Timer Physical Characteristics Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009 PCM-9386 Board Diagram Celeron M 400MHz PSB MIO Connector LVDS Connector 12-bit (DVOC) Analog RGB CRT Connector Intel GMCH (852GM) DDR200/266 DDR SDRAM 200pin SODIMM x 1 MIO Connector Audio Connector AC97 ALC203 AC97 CODEC Primary IDE Connector CompactFlash Intel ICH4 (82801DB) PCI BUS MIO Connector LAN Connector USB Connector MIO Connector 10/100/1000M (82551/82541) USB 2.0 x 3 MIO Connector FWH GPIO IRDA Floppy Watchdog LPC Super I/O (W83627HF) LPC Bus USB 2.0 x 1 COM1/COM2 LPT PS/2 KB&MS Ordering Information Part No. PCM-9386F-M0A2E PCM-9386F-S0A2E CPU Celeron M 600 MHz (512 KB) Celeron M 1 GHz (0 KB) CRT 1 1 LVDS 1 1 DVI LAN 1 FE 1 FE Giga optional optional USB 3 3 RS-232 1 1 RS-232/422/485 1 1 LPT 1 1 GPIO 4 in, 4 out 4 in, 4 out IrDA optional optional CF 1 1 MIO 1 1 Packing List Part No. 9689000002 1703100152 1701440351 1703100121 1700260250 1700060202 9681000044 1701260125 1701340700 1701140201 1700000265 Description PCM-9386 SBC Mini jumper pack Startup manual Utility CD Audio cable IDE 44 pin USB 2 port cable Parallel port cable Keyboard/mouse cable 26-34 pin FDD adapter FDD cable for slim FDD Flat cable 34 pins for FDD Second serial port cable ATX power cable 20P-12P cable Quantity 1 1 1 1 1 1 1 1 1 1 1 1 1 1 Embedded OS Part No. 2070000584 2070000585 2070000586 2070000765 2070000605 Description Win CE 4.2 P-M Core Image, PCM-938x, 2 COM, English, V 1.10 (17.2 MB) (Optional) Win CE 4.2 P-M Pro Image, PCM-938x, 2 COM, English, V 1.10 (29.1 MB) (Optional) Win CE 4.2 P-M Plus Image, PCM-938x, 2 COM, English, V 1.10 (29.9 MB) (Optional) Image CE 5.0 Pro Plus English for P-M, 2COM (Optional) Win XPE SP2 Image, PCM-938x, English, V2.10 (440 MB) (Optional) Optional Accessories Part No. MIO-6251 MIO-6253 MIO-6254 MIO-6255 MIO-6260 Description MIO module w/2 x Mini PCI, Audio MIO module with 4 COM ports MIO module w/DVI, S-Video, Audio MIO module w/2 x Cardbus MIO module w/4 x USB, 2 x COM, 1 x LAN Online Download www.advantech.com/products Value-Added Software Services Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications. Software APIs Control General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel® Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control. Monitor A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds. GPIO Watchdog SMBus Hardware Monitor The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage. I2C Hardware Control The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness. Display Power Saving The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading. The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. Backlight System Throttling Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%. Software Utilities The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers’ disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can “Lock” SQFlash via the Flash Lock function and “Unlock” it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the “Unlock” feature. BIOS Flash eSOS Embedded Security ID Flash Lock Monitoring Embedded Single Board Computers All product specifications are subject to change without notice Last updated : 09-Nov-2009