WISE-4610-S672NA

WISE-4610 LoRa Outdoor Wireless I/O Module Features ƒƒ For North America, Europe, and Japan ƒƒ Longer communication range ƒƒ Better penetration through concrete and steel ƒƒ Less interference than 2.4GHz spectrum ƒƒ Application-ready I/O combination with IP65 enclosure ƒƒ Powered by solar rechargeable battery or 10~50VDC input ƒƒ Global Positioning System (GPS) support Introduction LPWAN is a type of wireless telecommunication wide area network designed to allow long range communications at a low data rate among IoT applications, such as sensors operated on a battery. Its benefits is to offer multi-year battery lifetime for sensors/applications to send small amounts of data over long distances a few times per hour suitable for different environments. LoRa and LoRaWAN are one of category of LPWAN which belong to the non-cellular LPWAN wireless communication network protocols enables very long range transmissions with low power consumption, operating in the non-licensed spectrum. What is the difference between LoRa and LoraWAN? LoRa (Long Range) is a patented wireless data communication of IoT technology and acquired by Semtech in 2012 which holds the IP for LoRa transmission methodology. Star Topology The LoRaWAN networks in a star topology have gateway relaying the data between the sensor nodes and the network server. Communication between the sensor nodes and the gateway goes over the wireless channel utilizing the LoRa physical layer, whilst the connection between the gateways and the central server are handled over a backbone IP-based network. The LoRaWAN end nodes(sensors) typically use Low Power and are battery powered (Class A and Class B). LoRa embedded sensors that run on batteries that lasts from 2–5 years typically. The LoRa sensors can transmit signals over distances from 1km — 10km. Wireless IoT Sensing Devices All product specifications are subject to change without notice. Last updated: 4-Mar-2019 WISE-4610 Common Specification ƒƒ Input Impedance ƒƒ ƒƒ ƒƒ ƒƒ Wireless Communication ƒƒ IEEE Standard ƒƒ Frequency Band ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ Spreading Factor Outdoor Range Transmit Power Receiver Sensitivity Data Rate ƒƒ Topology ƒƒ Function IEEE 802.15.4g EU 863-870 (MHz) US 902-928 (MHz) AU (JP) 915-928 (MHz) 7~12 5km with line of sight (with 2 dBi Antenna) Up to +18dBm Up to -136dBm at SF = 12 / 125KHz 50 kbps at FSK mode EU868 21.9 kbps at SF7 mode US915 5.47 kbps at SF7 mode JP923 Star End Node Digital Input ƒƒ Channels ƒƒ Input Type ƒƒ Logic Level ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ GPS1 ƒƒ GNSS Systems ƒƒ Max. Update Rate ƒƒ Accuracy ƒƒ Acquisition > 2M Ω (Voltage) 120 Ω (External resistor for current) Isolation Voltage 3000Vrms Over Voltage Protection ±35 VDC Burn-out Detection Yes (4~20mA only) Supports Data Scaling and Averaging GPS, GLONASS, Galileo, BeiDou, QZSS and SBAS signals Single GNSS: up to 18 Hz Concurrent GNSS: up to 10 Hz Position: 2.5 m CEP (50% confidence) With SBAS: 2.0 m CEP (50% confidence) Cold starts: 57 s Aided starts: 7 s 4 Dry Contact (Wet Contact by request) 0: Open 1: Close to DCOM Isolation Voltage 3,000Vrms Supports 200Hz Counter Input (16-bit + 1-bit overflow) Keep/Discard Counter Value when Power-off Supports 200Hz Frequency Input Supports Inverted DI Status Pin Assignment A General ƒƒ Power Input ƒƒ Battery Life ƒƒ Configuration Interface ƒƒ Connector ƒƒ LED Indicator ƒƒ Mounting ƒƒ Dimension (W x H x D) Built-in 4000mA Lithium rechargeable battery pack or 10~50VDC external power 6 months (1 hour data update and 1 day GPS update) Micro-B USB Power: M12 4-pin code-A male x 1 I/O: M12 8-pin code-D female x 2 Status, Error, Tx, Rx, Battery/Signal Level DIN 35 rail, wall, pole, and stack 82 x 122 x 49 mm (without antenna) 2 B Environment ƒƒ Operating Temperature2 0~60°C No Battery Version: -20~70°C ƒƒ Operating Humidity 5~95% RH 1 No GPS version, can be order by request 2 No battery version, can be order by request Serial Port ƒƒ Serial Signal ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ Data Bits Stop Bits Parity Baud Rate (bps) Protection Protocol WISE-S672 WISE-S614 DI0 DI1 DI2 DI3 DI4 DI5 NC DI COM DATA1DATA1+ TX RX DATA2DATA2+ NC GND +VS -VS SP+ SP- DI0 DI1 DI2 DI3 NC NC NC DI COM IA0+ IA0IA1+ IA1IA2+ IA2IA3+ IA3+VS -VS SP+ SP- Ordering Information Wireless Sensor Node WISE-S672 ƒƒ Port Number ƒƒ Type PWR Model Name Pin Number 1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8 1 2 3 4 2 Port 1: RS-485 Port 2: RS-485/232 RS-485: DATA+, DATARS-232: Tx, Rx, GND 7, 8 1, 2 None, Odd, Even 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200 15 kV ESD Modbus/RTU (Total 32 address) ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ WISE-4610-S672NA WISE-4610-S672EA WISE-4610-S672JA WISE-4610-S614NA WISE-4610-S614EA WISE-4610-S614JA LoRa Outdoor WSN with 6DI & 2COM - NA915 LoRa Outdoor WSN with 6DI & 2COM - EU868 LoRa Outdoor WSN with 6DI & 2COM - JP923 LoRa Outdoor WSN with 4AI & 4DI - NA915 LoRa Outdoor WSN with 4AI & 4DI - EU868 LoRa Outdoor WSN with 4AI & 4DI - JP923 Dimensions Digital Input ƒƒ Channels ƒƒ Input Type ƒƒ Logic Level ƒƒ ƒƒ ƒƒ ƒƒ ƒƒ 6 Dry Contact (Wet Contact by request) 0: Open 1: Close to DCOM Isolation Voltage 3,000Vrms Supports 200Hz Counter Input (16-bit + 1-bit overflow) Keep/Discard Counter Value when Power-off Supports 200Hz Frequency Input Supports Inverted DI Status WISE-4610-S614 Analog Input ƒƒ ƒƒ ƒƒ ƒƒ Channels Resolution Sampling Rate Accuracy ƒƒ Input Range 4 16-bit 1Hz per channel ±0.1% of FSR (Voltage) ±0.2% of FSR (Current) ±5V, ±10V, 0~5V, 0~10V, 0~20mA, 4~20mA, ±20mA Online Download www.advantech.com/products Unit: mm