MASW-007921-001SMB

MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Features Rev. V1 Functional Schematic  Ideal for high power SPDT switch applications including WiMAX, WLAN, Mesh Networks, and Fixed Wireless Access  Broadband Performance: DC - 7.0 GHz  Low Insertion Loss: 0.65 dB @ 3.5 GHz, RFC to TX 0.70 dB @ 3.5 GHz, RCF to RX  High P0.1dB Compression: 40 dBm @ 3V, 3.5 GHz, RFC to TX  Fast Settling for Low Gate Lag requirements  Lead-Free 2 mm 8-Lead PDFN Package  100% Matte Tin Plating over Copper  Halogen-Free ―Green‖ Mold Compound  RoHS* Compliant and 260°C Reflow Compatible  Asymmetrical Design for optimized performance Pin 1 Ordering Information 1,2 Part Number Package MASW-007921-TR3000 3000 piece reel MASW-007921-001SMB Sample Board 2.0 - 6.0 GHz Tuning MASW-007921-002SMB Sample Board 0.05 - 2.0 GHz Tuning 1. Reference Application Note M513 for reel size information. 2. All sample boards include 5 loose parts. 1 N/C RFC N/C VC2 RX GND Pin No. Pin Name Description 1 TX RF Output 1 2 N/C No Connection 3 N/C No Connection 4 RX RF Output 2 5 GND RF and DC Ground 6 VC2 Voltage Control 2 7 RFC RF Common 8 VC1 M/A-COM’s MASW-007921 is a broadband GaAs pHEMT MMIC SPDT switch available in a lead-free 2 mm 8-lead PDFN package. The MASW-007921 is ideally suited for applications where very small size and high linearity are required. The MASW-007921 is fabricated using a 0.5 micron gate length GaAs pHEMT process. The process features full passivation for performance and reliability. VC1 Pin Configuration 3 Description Typical applications include WiMAX, WLAN, Mesh networks, fixed wireless access, and other higher power systems. This switch has a very high initial compression point, ideal for complex modulations such as OFDM, with large peak average power levels. TX 9 Paddle Voltage Control 1 4 RF and DC Ground 3. M/A-COM recommends connecting unused pins to ground. 4. The exposed pad centered on the package bottom must be connected to RF and DC ground. Absolute Maximum Ratings 5,6,7 Parameter Absolute Maximum Input Power @ 5 V Control (RFC to RX Path) +38 dBm Input Power @ 5 V Control (RFC to TX Path) +40 dBm Voltage  8.5 volts Operating Temperature -40°C to +85°C Storage Temperature -65°C to +150°C 5. Exceeding any one or combination of these limits may cause permanent damage to this device. 6. M/A-COM does not recommend sustained operation near these survivability limits. 7. Maximum Input Power applies for 0.5 to 7.0 GHz range. * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 Electrical Specifications: TA = 25°C, Z0 = 50 Ω, VC = 0 V / 3 V, 4.7 pF Capacitor 8,9 Parameter Test Conditions Units Min. Typ. Max. 10 Insertion Loss RFC to RX 0.05 - 2 GHz 2.4 GHz 3.5 GHz 5.8 GHz dB dB dB dB — — — — 0.5 0.6 0.70 0.8 — 0.85 — — Insertion Loss RFC to TX 0.05 - 2 GHz10 2.4 GHz 3.5 GHz 5.8 GHz dB dB dB dB — — — — 0.5 0.65 0.65 1.2 — 0.85 — — Isolation 0.05 - 2 GHz10 2.4 GHz 3.5 GHz 5.8 GHz dB dB dB dB — 21 — — 27 25 26 30 — — — — Return Loss DC - 6.0 GHz dB — 15 — Input IP2 RX 10 MHz Spacing, +20 dBm 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 102 99 84 — — — Input IP2 TX 10 MHz Spacing, +20 dBm 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 104 101 88 — — — Input IP3 RX 10 MHz Spacing, +20 dBm 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 59 57 51 — — — Input IP3 TX 10 MHz Spacing, +20 dBm 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 62 58 52 Input P0.1dB RX 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 38 37 39 — — — Input P0.1dB TX 2.4 GHz 3.5 GHz 5.8 GHz dBm dBm dBm — — — 38 40 39 — — — Trise, Tfall 10% to 90% RF 90% to10% RF nS nS — — 21 18 — — Ton, Toff 50% control to 90% and 50% control to 10% RF nS — 40 — Transients mV — 100 — Control Current µA — 2.0 10.0 8. For positive voltage control, external DC blocking capacitors are required on all RF ports. 9. Performance can be optimized by varying the DC blocking capacitor value. See application schematic for details. 10. 0.05 - 2.0 GHz specifications apply with 1000 pF blocking capacitors. See applications section for typical data. 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support — — — MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 Typical Performance Curves Over Temp.: Z0 = 50 Ω, 4.7 pF Blocking Caps on all RF Ports RFC to Rx Insertion Loss RFC to Tx Insertion Loss 0.0 0.0 -0.5 -0.5 -1.0 -1.0 +25°C -40°C +85°C -1.5 -2.0 2 3 -1.5 4 5 6 7 8 -2.0 +25°C -40°C +85°C 2 3 6 7 8 7 8 0 0 +25°C -40°C +85°C -15 -30 -45 -45 2 3 4 +25°C -40°C +85°C -15 -30 5 6 7 8 -60 2 3 0 0 -10 -10 -20 -20 -30 6 4 5 6 Frequency (GHz) +25°C -40°C +85°C -30 +25°C -40°C +85°C 3 5 Tx Return Loss Rx Return Loss 2 4 Frequency (GHz) Frequency (GHz) -40 5 RFC to Tx Isolation RFC to Rx Isolation -60 4 Frequency (GHz) Frequency (GHz) 7 8 -40 2 3 4 5 6 7 8 Frequency (GHz) 3 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 Application Schematic 11 Truth Table 12,13 VC1 TX C1 N/C RFC C2 N/C VC2 RX GND C3 Frequency Recommended Value C1 - C3 0.05 - 2.0 GHz 1000 pF 2.4 - 2.5 GHz 8 pF 2.0 - 6.0 GHz 4.7 pF 4.9 - 7.0 GHz 1.5 pF 11. M/A-COM recommends connecting unused package pins (N/C) to ground as shown. Control VC1 Control VC2 RFC - TX RFC - RX 1 0 On Off 0 1 Off On 12. Differential voltage, V (state 1) - V (state 0), must be +2.7 V minimum and must not exceed 8.0 V. 13. Positive Control: 1 = +2.9 V to +8 V, 0 = 0 V + 0.2 V. Negative Control: 1 = 0 V + 0.2 V, 0 = -2.9V to –8.0 V. Qualification Qualified to M/A-COM specification REL-201, Process Flow –1. Handling Procedures Please observe the following precautions to avoid damage: Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. 4 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 Lead Free 2 mm 8-lead PDFN † † Reference Application Note M538 for lead-free solder reflow recommendations. Meets JEDEC moisture sensitivity level 1 requirements. 5 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 Applications Section Typical Low Frequency Performance Curves: TA = 25°C, Z0 = 50 Ω 1000 pF Blocking Caps on all RF Ports RFC Return Loss Insertion Loss 0.00 -10 -0.25 RFC to TX RFC to RX RFC to TX RFC to RX -20 -0.50 -30 -0.75 -1.00 0.0 0.5 1.0 1.5 2.0 2.5 -40 0.0 0.5 Frequency (GHz) 1.0 1.5 2.0 2.5 2.0 2.5 Frequency (GHz) Isolation Tx and Rx Return Loss 0 -10 RFC to TX RFC to RX -10 TX Rx -20 -20 -30 -30 -40 -50 0.0 0.5 1.0 1.5 Frequency (GHz) 2.0 2.5 -40 0.0 0.5 1.0 1.5 Frequency (GHz) 6 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support MASW-007921 High Power GaAs SPDT Switch DC - 7.0 GHz Rev. V1 M/A-COM Technology Solutions Inc. All rights reserved. Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM") products. These materials are provided by MACOM as a service to its customers and may be used for informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM assumes no responsibility for errors or omissions in these materials. MACOM may make changes to specifications and product descriptions at any time, without notice. MACOM makes no commitment to update the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise, to any intellectual property rights is granted by this document. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS, WHICH MAY RESULT FROM THE USE OF THESE MATERIALS. MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM customers using or selling MACOM products for use in such applications do so at their own risk and agree to fully indemnify MACOM for any damages resulting from such improper use or sale. 7 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support