SW-313-TB

SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Features          Integral TTL Driver Low DC Power Consumption Fast Switching Speed: 7 ns Typical Hermetic Surface Mount Package 50 Ohm Nominal Impedance MIL-STD-883 Screening Available Lead-Free CR-9 Package 260°C Reflow Compatible RoHS* Compliant Description M/A-COM’s SW-313-PIN is a GaAs FET SPDT absorptive switch with integral silicon ASIC driver. Packaged in a 16-lead ceramic surface mount package, this device offers excellent performance and repeatability from DC to 3 GHz while maintaining low power consumption. The SW-313-PIN is ideally suited for use where fast speed, low power consumption and broadband applications are required. MIL-STD-883 screening available. Functional Block Diagram RFC GND GND GND GND GND RF2 RF1 GND GND GND GND GND Orientation Mark Vcc C1 Vee Pin Configuration Ordering Information Pin No. Function Pin No. Function 1 Vee 9 RFC Part Number Package 2 GND 10 GND SW-313-PIN Bulk Packaging 3 GND 11 GND SW-313-TB Sample Test Board 4 GND 12 RF1 5 RF2 13 GND 6 GND 14 GND 7 GND 15 Vcc 8 GND 16 C1 Note: Reference Application Note M513 for reel size information. The metal bottom of the case must be connected to RF and DC ground. 1 * Restrictions on Hazardous Substances, European Union Directive 2002/95/EC. M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Electrical Specifications: (From –55°C to +85°C), Z0 = 50 1,2 Parameter Test Conditions Frequency Units Min Typ Max Insertion Loss — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz dB dB dB dB — — — — — — — — 1.2 1.1 0.9 0.8 VSWR — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz Ratio Ratio Ratio Ratio — — — — — — — — 1.50:1 1.40:1 1.35:1 1.30:1 Isolation — DC - 3000 MHz DC - 2000 MHz DC - 1000 MHz DC - 500 MHz dB dB dB dB 35 43 48 53 — — — — — — — — Trise, Tfall 10% to 90% — ns — 7 — Ton, Toff 1.3V CTL to 90% / 10% — ns — 18 — Transients In-Band — mV — 25 — 1 dB Compression Input Power 0.05 GHz 0.5 GHz to 3 GHz dBm dBm — — +25 +30 — — IP2 Two-Tone Input Power up to +5 dBm 0.05 GHz 0.5 GHz to 3 GHz dBm dBm — — +60 +65 — — IP3 Two-Tone Input Power up to +5 dBm 0.05 GHz 0.5 GHz to 3 GHz dBm dBm — — +40 +46 — — Vin Low 0V to 0.8V — µA — — 1 Vin High 2.0V to 5.0V — µA — — 1 Vcc +5.0V ± 10% — mA — — 1 Vee -5.0V to -8.0V — mA — — 1 1. All specifications apply when operated with bias voltages of +5V for Vcc and –5V for Vee. 2. When DC blocks are used, a 10K ohm return to GND is required on the RFC port. 2 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Absolute Maximum Ratings 3,4 3. 4. 5. Parameter Absolute Maximum Max Input Power 50 MHz 500 - 3000 MHz +27 dBm +34 dBm VCC -0.5V ≤ VCC ≤ +7.0V VEE -8.5V ≤ VEE ≤ +0.5V VCC - VEE -0.5V ≤ VCC - VEE ≤ 14.5V C1 RF1 RF2 Vin5 -0.5V ≤ Vin ≤ VCC + 0.5V 0 On Off Operating Temperature -55°C to +125°C 1 Off On Storage Temperature -65°C to +150°C Truth Table (Switch) Condition of Switch Control Input Exceeding any one or combination of these limits may cause permanent damage to this device. M/A-COM does not recommend sustained operation near these survivability limits. Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply. RF Common to Each RF Port 0 = TTL Low; 1 = TTL High Typical Performance Curves Insertion Loss vs. Frequency Handling Procedures 2.00 Please observe the following precautions to avoid damage: Static Sensitivity Gallium Arsenide Integrated Circuits are sensitive to electrostatic discharge (ESD) and can be damaged by static electricity. Proper ESD control techniques should be used when handling these devices. Loss (dB) 1.50 1.00 0.50 0.00 0.0 0.5 1.0 1.5 2.0 2.5 3 F re que nc y ( G H z) Isolation vs. Frequency VSWR vs. Frequency V SW R ( On) 80 V SW R ( Of f ) 2.20 2.00 1.80 50 VSWR Isolation dB 70 60 40 30 1.40 20 10 1.20 0 0.0 3 1.60 0.5 1.0 1.5 2.0 F re que nc y ( G H z) 2.5 3 1.00 0.0 0.5 1.0 1.5 2.0 2.5 F re que nc y ( G H z) M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support 3 SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 Lead-Free, CR-9 Ceramic Package† † Reference Application Note M538 for lead-free solder reflow recommendations. 4 M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support SW-313-PIN Matched GaAs SPDT Switch, DC-3.0 GHz with TTL/CMOS Control Input Rev. V6 M/A-COM Technology Solutions Inc. All rights reserved. Information in this document is provided in connection with M/A-COM Technology Solutions Inc ("MACOM") products. These materials are provided by MACOM as a service to its customers and may be used for informational purposes only. Except as provided in MACOM's Terms and Conditions of Sale for such products or in any separate agreement related to this document, MACOM assumes no liability whatsoever. MACOM assumes no responsibility for errors or omissions in these materials. MACOM may make changes to specifications and product descriptions at any time, without notice. MACOM makes no commitment to update the information and shall have no responsibility whatsoever for conflicts or incompatibilities arising from future changes to its specifications and product descriptions. No license, express or implied, by estoppels or otherwise, to any intellectual property rights is granted by this document. THESE MATERIALS ARE PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESS OR IMPLIED, RELATING TO SALE AND/OR USE OF MACOM PRODUCTS INCLUDING LIABILITY OR WARRANTIES RELATING TO FITNESS FOR A PARTICULAR PURPOSE, CONSEQUENTIAL OR INCIDENTAL DAMAGES, MERCHANTABILITY, OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT. MACOM FURTHER DOES NOT WARRANT THE ACCURACY OR COMPLETENESS OF THE INFORMATION, TEXT, GRAPHICS OR OTHER ITEMS CONTAINED WITHIN THESE MATERIALS. MACOM SHALL NOT BE LIABLE FOR ANY SPECIAL, INDIRECT, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, INCLUDING WITHOUT LIMITATION, LOST REVENUES OR LOST PROFITS, WHICH MAY RESULT FROM THE USE OF THESE MATERIALS. MACOM products are not intended for use in medical, lifesaving or life sustaining applications. MACOM customers using or selling MACOM products for use in such applications do so at their own risk and agree to 5 fully indemnify MACOM for any damages resulting from such improper use or sale. M/A-COM Technology Solutions Inc. (MACOM) and its affiliates reserve the right to make changes to the product(s) or information contained herein without notice. Visit www.macom.com for additional data sheets and product information. For further information and support please visit: https://www.macom.com/support