R2860G

Preliminary Data Sheet, Rev. 2 September 2001 R2860G Digital Receiver OC-192/STM-64 Description The R2860G receiver module incorporates a highspeed planar PIN diode and an HBT preamplifier to provide exceptionally high linearity. The receiver is designed to provide very clean pulse response at 12.5 Gbits/s that results in high-quality eye patterns (see Figure 1). Agere Systems Inc. offers several 1R and 2R highspeed receiver components for 10 Gbits/s and 12.5 Gbits/s applications. APD and PIN versions are available in a 6-pin hermetic package with coaxial output. In addition, Agere Systems also offers a PIN receiver with coplanar waveguide in a multisource agreement form-factor or a smaller, space sensitive package. For more information about the complete line of high-speed receiver products, please visit the Agere Systems' website at www.agere.com/opto. Features s s s s s s Linear output up to 0 dBm optical input power High sensitivity, –18 dBm typical High overload, > 2 dBm typical Transimpedance, 500 Ω typical dc-coupled output Hermetically sealed Applications s 12.5 Gbits/s short, intermediate, and long-haul systems DWDM equipment SONET/SDH equipment Return to zero (RZ) and strong forward-error correction (FEC) applications s s s R2860G Digital Receiver OC-192/STM-64 Preliminary Data Sheet, Rev. 2 September 2001 Absolute Maximum Ratings Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are absolute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operational sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability. Parameter Operating Temperature Range Storage Case Temperature Range Preamp Supply Voltage Photodiode Bias Voltage Optical Input Power Symbol TOP Tstg VCC VPD PIN Min –5 –40 — — — Max 70 85 8.5 20 4 Unit °C °C V V dBm Electrical/Optical Characteristics Table 1. Electrical and Optical Characteristics (25 °C case temperature. Test conditions: 10 Gbits/s, NRZ, TA = 25 °C) Parameter Optical Wavelength Range Sensitivity (10-10 BER, PRBS 223 – 1) Overload (10-13 BER, PRBS 223 – 1) Responsivity Dark Current High-Frequency Cutoff Low-Frequency Cutoff Group Delay (0.5 GHz—10 GHz) Transimpedance Average Equivalent Input Noise (30 KHz—8 GHz) RF Output Return Loss* (0.1 GHz—8 GHz) Optical Return Loss Logic Sense Preamp Supply Voltage Photodiode Supply Voltage Supply Current * External dc block required on RF output. Symbol λ — — R ID — — — Z — RLRF RL — VCC VPD ICC Min 1280 — 0 0.7 — 9.5 — — 400 — 9 27 — 8 7 — Typ — –18 2 0.8 — 11 — ±20 500 13 — — Noninverting 8.2 8 110 Max 1580 –15 — — 1.0 — 30 — 600 15 — — — 8.4 12 130 Unit nm dBm dBm A/W nA GHz kHz ps Ω pA/√Hz dB dB — V V mA 2 Agere Systems Inc. Preliminary Data Sheet, Rev. 2 September 2001 R2860G Digital Receiver OC-192/STM-64 Pin Information Table 2. Pin Descriptions Pin No. 1 2 3 4 5 6 Description NC 8 V (VCC) 8 V (VPD) NC NC Ground Characteristic Curve Figure 1. Eye Pattern at 12.5 Gbits/s Block Diagram PIN PHOTODIODE IN TRANSIMPEDANCE AMPLIFIER OUT GND RF OUT PROTECTION DIODE 1 NC 2 8V VCC 3 8V VPD 4 NC 5 NC 6 GND 1-1173(F) Agere Systems Inc. 3 R2860G Digital Receiver OC-192/STM-64 Preliminary Data Sheet, Rev. 2 September 2001 Outline Diagram Dimensions are in inches and (millimeters). 1.24 (31.50) 0.10 (2.50) 4X 0.094 (2.40) 0.19 ± 0.03 (5.00 ± 0.80) 0.08 ± 0.03 (2.00 ± 0.80) 1.04 (26.40) 0.84 (21.30) 0.29 (7.40) 0.31 (7.90) 0.58 (14.70) 0.78 (19.80) 0.26 (7.00) 1 METER MIN. 6X 0.02 (0.50) 0.20 (5.10) 0.33 ± 0.03 (8.00 ± 0.80) 0.20 (5.00) 0.70 ± 0.03 (18.00 ± 0.80) 0.15 (3.80) PIN #1 5X 0.10 (2.50) K-CONNECTOR ™ 0.41 (10.40) 0.17 (4.30) 0.225 (5.70) 0.40 (1.00) 0.174 (4.40) Note: External dc block required on RF output. 1-1169(F)b 4 Agere Systems Inc. Preliminary Data Sheet, Rev. 2 September 2001 R2860G Digital Receiver OC-192/STM-64 Ordering Information Table 3. Ordering Information1 Device Code R2860G023 Description Digital Receiver 400 Ω min. TIA gain, dc-coupled output Digital Receiver 400 Ω min. TIA gain, dc-coupled output Connector FC/SPC Pigtail Comcode TBD SMF-28 ™ or equivalent (1 m min.) SMF-28 or equivalent (1 m min.) R2860G040 SC/UPC TBD 1. Other options available. For additional ordering information, please contact an Agere Systems account manager at Opto West, 1-800-3623891 (for sales staff, please press option 2). Agere Systems Inc. 5 R2860G Digital Receiver OC-192/STM-64 Preliminary Data Sheet, Rev. 1 September 2001 K-Connector is a trademark of Anritsu Company. SMF-28 is a trademark of Corning Incorporated. For additional information, contact your Agere Systems Account Manager or the following: http://www.agere.com INTERNET: docmaster@agere.com E-MAIL: N. AMERICA: Agere Systems Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18109-3286 1-800-372-2447, FAX 610-712-4106 (In CANADA: 1-800-553-2448, FAX 610-712-4106) ASIA: Agere Systems Hong Kong Ltd., Suites 3201 & 3210-12, 32/F, Tower 2, The Gateway, Harbour City, Kowloon Tel. (852) 3129-2000, FAX (852) 3129-2020 CHINA: (86) 21-5047-1212 (Shanghai), (86) 10-6522-5566 (Beijing), (86) 755-695-7224 (Shenzhen) JAPAN: (81) 3-5421-1600 (Tokyo), KOREA: (82) 2-767-1850 (Seoul), SINGAPORE: (65) 778-8833, TAIWAN: (886) 2-2725-5858 (Taipei) Tel. (44) 7000 624624, FAX (44) 1344 488 045 EUROPE: Agere Systems Inc. reserves the right to make changes to the product(s) or information contained herein without notice. No liability is assumed as a result of their use or application. Copyright © 2001 Agere Systems Inc. All Rights Reserved September 2001 DS01-148OPTO-2 (Replaces DS01-148OPTO-1)