AM15C-1215S-NZ

Series AM15C-NZ 15 Watt | DC-DC Converter FEATURES: • • • • • • • • • • Wide 2:1 Input Voltage Range High efficiency up to 91% 1500 VDC Isolation Over Current Protection Remote On/Off control Operating Temperature -40ºC to +105ºC Output Over Voltage protection Continuous Short Circuit Protection Input Under Voltage Protection Bare Part Meet CISPR32/EN55032 Class A Models Single output Model Input Voltage (VDC) Output Voltage (VDC) Input Current max Full/No Load (mA) Output Current max (mA) Isolation (VDC) Max Capacitive Load (uF) Efficiency Typ. (%) 9-18 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 18-36 36-75 36-75 36-75 36-75 36-75 3.3 5 12 15 24 3.3 5 12 15 24 3.3 5 12 15 24 1280/65 1421/65 1421/22 1405/22 1405/22 647/50 711/50 711/15 703/15 703/20 320/30 356/30 352/11 352/11 352/11 4000 3000 1250 1000 625 4000 3000 1250 1000 625 4000 3000 1250 1000 625 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 1500 4700 4700 1000 820 270 4700 4700 1000 820 270 4700 4700 1000 820 270 88 90 90 91 91 88 90 90 91 91 88 90 91 91 91 AM15C-1203S-NZ AM15C-1205S-NZ AM15C-1212S-NZ AM15C-1215S-NZ AM15C-1224S-NZ AM15C-2403S-NZ AM15C-2405S-NZ AM15C-2412S-NZ AM15C-2415S-NZ AM15C-2424S-NZ AM15C-4803S-NZ AM15C-4805S-NZ AM15C-4812S-NZ AM15C-4815S-NZ AM15C-4824S-NZ NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity1,000,000 hours (MIL-HDBK -217F, Ground Benign, t=+25 C) 1.5mm from case for 10 sec 300 % RH g o C Safety Specifications Parameters Standards Designed to meet EN62368 CISPR32 / EN 55032, Class A, Class B with the recommended EMC circuit Electrostatic Discharge Immunity IEC 61000-4-2, Contact ±6KV, Air ±8KV, Criteria B RF, Electromagnetic Field Immunity IEC 61000-4-3, 10V/m, Criteria A Electrical Fast Transient / Burst Immunity IEC 61000-4-4, ±2KV with the recommended EMC circuit, Criteria A Surge Immunity IEC 61000-4-5, L-L ±2KV with the recommended EMC circuit, Criteria B RF, Conducted Disturbance Immunity IEC 61000-4-6, 3 Vrms, Criteria A Pin Out Specifications Pin 1 2 3 4 5 6 Single +V Input -V Input On/Off Control +V Output Trim -V Output www.aimtec.com F 051e R1 REV: 04/22/A Tel: +1 514 620 2722 2 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM15C-NZ 15 Watt | DC-DC Converter Dimensions Bottom View Top View 2.54 (0.10) 25.40 (1.00) 2.54 10.16 (0.10) (0.40) 10.16 (0.40) 5 4 6 20.32 (0.80) 25.40 (1.00) +V Output Trim +V -V Input Input CTRL 2.54 (0.10) 1 Side View -V Output 10.16 (0.40) 2 3 7.62 (0.30) 5.08 (0.20) 9.90 (0.39) Printed Face 2.54 (0.10) Dimensions mm (inch) Case Tolerance ±0.50 (±0.02) Pin Diameter 1.0 ± 0.10 (0.04 ± 0.004) 1.00 (0.39) Derating Free Air Convection 3.3V/5V Output 12V/15V/24V Output Output Power (%) 100 80 60 Safe Operating Area 40 20 0 - 20 - 40 0 20 40 60 75 95 80 105 100 Ambient Temperature º C Typical Application Circuits + Vin + Vin C1 100uF DC - Vin - Vin Model C2 www.aimtec.com F 051e R1 REV: 04/22/A 3.3V/5V/12V/15V Vout 100µF + Vout DC +Vout C2 - Vout - Vout 24V Vout 47µF Tel: +1 514 620 2722 3 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM15C-NZ 15 Watt | DC-DC Converter Recommended EMC Circuits CY1 1nF/2KV LDM FUSE + Vin + Vout + Vin + + C2 C1 DC C4 C3 DC - Vin - Vin +Vout C5 - Vout - Vout CY2 1nF/2KV Model FUSE C1, C4 C2, C3 LDM C5 12V/24V Vin 48V Vin Choose based on actual input current 330µF/50V 330µF/100V 4.7µF/50V 4.7µF/100V 2.2µh/4A 2.2µH/2A Refer to the C2 in typical application circuit Trimming Output voltage can be externally trimmed by utilizing the methods as shown below Fixed Resistor Variable Potentiometer Leave open if not used. 3.3V output models Trim down % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) Rt down (KΩ) 3.267 141.768 3.234 85.296 3.201 58.08 3.168 42.063 3.135 31.512 3.102 24.036 3.069 18.463 3.036 14.148 3.003 10.708 2.97 7.902 Trim up % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 3.333 1280.954 3.366 143.632 3.399 69.487 3.432 42.576 3.465 28.667 3.498 20.17 3.531 14.442 3.564 10.318 3.597 7.208 3.63 4.778 Rt up (KΩ) www.aimtec.com F 051e R1 REV: 04/22/A Tel: +1 514 620 2722 4 of 5 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM15C-NZ 15 Watt | DC-DC Converter 5V output models Trim down % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 4.95 4.9 4.85 4.8 4.75 4.7 4.65 4.6 4.55 4.5 Rt down (KΩ) 89.996 47.446 29.793 20.131 14.036 9.840 6.775 4.439 2.598 1.111 Trim up % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 5.05 5.1 5.15 5.2 5.25 5.3 5.35 5.4 5.45 5.5 Rt up (KΩ) 238.676 81.473 46.044 30.398 21.581 15.923 11.985 9.085 6.861 5.101 12V output models Trim down % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 11.88 11.76 11.64 11.52 11.4 11.28 11.16 11.04 10.92 10.8 Rt down (KΩ) 493.692 299.052 210.127 159.185 126.173 103.042 85.932 72.764 62.316 53.823 Trim up % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 12.12 12.24 12.36 12.48 12.6 12.72 12.84 12.96 13.08 13.2 Rt up (KΩ) 704.035 156.520 81.479 51.675 35.677 25.695 18.874 13.917 10.152 7.195 15V output models Trim down % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 14.85 14.7 14.55 14.4 14.25 14.1 13.95 13.8 13.65 13.5 Rt down (KΩ) 632.483 398.237 286.114 220.359 177.137 146.560 123.787 106.169 92.132 80.687 Trim up % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 15.15 15.3 15.45 15.6 15.75 15.9 16.05 16.2 16.35 16.5 Rt up (KΩ) 1457.699 190.174 94.242 58.954 40.616 29.381 21.791 16.321 12.190 8.961 24V output models Trim down % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 23.76 23.52 23.28 23.04 22.8 22.56 22.32 22.08 21.84 21.6 Rt down (KΩ) 1284.000 789.923 563.667 433.904 349.754 290.763 247.115 213.514 186.847 165.170 Trim up % 1 2 3 4 5 6 7 8 9 10 Vout (VDC) 24.24 24.48 24.72 24.96 25.2 25.44 25.68 25.92 26.16 26.4 Rt up (KΩ) 814.689 177.714 92.138 58.264 40.107 28.788 21.057 15.440 11.176 7.827 NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity