AM3G-1205S-NZ

Series AM3G-NZ 3 Watt | DC-DC Converter FEATURES: • RoHS compliant • Very low No load consumption • Remote On/Off Control • 8 pin SIP package • • • • Operating temperature -40oC to + 85oC Continuous Short circuit protection Wide 2:1 input range High efficiency up to 81% Models Single output Model AM3G-1205S-NZ AM3G-1209S-NZ AM3G-1212S-NZ AM3G-1215S-NZ AM3G-2405S-NZ AM3G-2409S-NZ AM3G-2412S-NZ AM3G-2415S-NZ Input Voltage (V) 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 Output Voltage (V) 5 9 12 15 5 9 12 15 Output Current max (mA) 600 333 250 200 600 333 250 200 Isolation (VDC) 1500 1500 1500 1500 1500 1500 1500 1500 Capacitor Load (μF) 2200 1000 820 680 2200 1000 820 680 Efficiency 78 79 80 80 78 79 80 81 Models Dual output Model AM3G-1205D-NZ AM3G-1209D-NZ AM3G-1212D-NZ AM3G-1215D-NZ AM3G-2405D-NZ AM3G-2409D-NZ AM3G-2412D-NZ AM3G-2415D-NZ Input Voltage (V) 9-18 9-18 9-18 9-18 18-36 18-36 18-36 18-36 Output Voltage (V) ±5 ±9 ±12 ±15 ±5 ±9 ±12 ±15 Output Current max (mA) ±300 ±167 ±125 ±100 ±300 ±167 ±125 ±100 Isolation (VDC) 1500 1500 1500 1500 1500 1500 1500 1500 Capacitor Load (μF) ±560 ±470 ±330 ±220 ±560 ±470 ±330 ±220 Efficiency (%) 78 79 80 80 78 79 80 81 Input Specifications Parameters Voltage range Filter Maximum Rating Peak Input Voltage time On/Off Control 12 Vin 24 Vin Nominal 12 24 Typical Maximum Units VDC VDC ms 9-18 18-36 Capacitor 22 40 100 ON – low or open; OFF - high Isolation Specifications Parameters Tested voltage Resistance Capacitance Conditions 60 sec 100kHz, 1V Typical 1500 > 1000 80 Maximum Units VDC MOhm pF www.aimtec.com F 051e R2.A Tel: +1 514 620 2722 1 of 3 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3G-NZ 3 Watt | DC-DC Converter Output Specifications Parameters Voltage accuracy Voltage balance Short Circuit protection Line voltage regulation Load voltage regulation Temperature coefficient Ripple & Noise Conditions Dual Output 25~100% load Auto recovery LL~HL load 10~100% At 20MHz Bandwidth Typical ±3 ±5 Continuous ±0.5 ±1 ±0.03 100 Maximum Units % % % % %/oC mV p-p General Specifications Parameters Switching frequency Operating temperature Storage temperature No load power consumption Cooling Humidity Case material Weight Dimensions (L x H x W) MTBF Conditions 100% load With derating above 71oC Typical >200 -40 to +85 -50 to +125 100 Free air convection Maximum 500 Units KHz o C o C mW Non condensing % 95 Non-conductive black plastic (UL94V-0 rated) g 6 22 x 9.5 x 12 mm 0.87 x 0.37 x 0.47 inch >1 000 000 hrs (MIL-HDBK -217F, Ground Benign, t=+25oC) Pin Out Specifications Pin 1 2 3 5 6 7 8 Dimensions Dual Single - V Input + V Input On/Off Control N.C. + V Output - V Output CS - V Input + V Input On/Off Control N.C. + V Output Common - V Output Derating Vout CS CS Capacitor Table 5V 9V 12V 15V 24V 47uF – 100uF 10uF – 47uF www.aimtec.com F 051e R2.A Tel: +1 514 620 2722 2 of 3 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AM3G-NZ 3 Watt | DC-DC Converter Control ON/OFF pin connection example: The voltage could be applied through a limiting resistor and a switching diode. The converter is in a low power mode during high level phase. NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. Aimtec may not have conducted destructive testing or chemical analysis on all internal components and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release. 5. This product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate specific safety and regulatory standards other the ones listed in this datasheet. www.aimtec.com F 051e R2.A Tel: +1 514 620 2722 3 of 3 Toll free: + 1 888 9 AIMTEC (924 6832) North America only