AMEPR30N-4260Z

Series AMEPR30N-Z up to 700mA | AC-DC LED driver FEATURES: • • • • Models Single output Model Accurate Constant Current Output ±5% Low Output Voltage Ripple. No Flicker Active Power Factor Correction. Low THD Short Circuit, Open Circuit Max Output Power (W) Output Voltage Range (V) 21.0 25.2 29.4 24-42 24-42 24-42 AMEPR30N-4250Z AMEPR30N-4260Z AMEPR30N-4270Z • • • • Output Current (mA) 500 600 700 Class II LED Luminaire Compliance Long Life, High reliability, Low Profile Over Temperature Protection 5 Year Warranty Input Voltage (VAC/Hz) Efficiency (%) 90-305/47-63 90-305/47-63 90-305/47-63 79 80 81 NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity 450,000 hrs (MIL-HDBK-217F at +25°C) g Safety Specifications Parameters Standards Electromagnetic Interference Harmonic Current Emissions Voltage fluctuations and flicker Electrostatic Discharge Immunity RF, Electromagnetic Field Immunity Electrical Fast Transient / Burst Immunity Surge Immunity RF, Conducted Disturbance Immunity Power frequency Magnetic Field Immunity Voltage dips, Short Interruptions Immunity Electromagnetic Immunity Requirements Applies to Lighting Equipment Pin Definition Application Block diagram Recommended Wire gauge Connection 20-24 20-24 14-26 14-26 AC L AC N LED+ LED- www.aimtec.com F 052.1e R0 EN55015 / FCC Part 15, Class B EN61000-3-2, Class B EN61000-3-3 EN61000-4-2, 8kV Air, 4kV Contact, Level 3, Criteria A EN61000-4-3, Test-RS Level 3, Criteria A EN61000-4-4, Burst EFT Level 3, Criteria A EN61000-4-5, Line to Neutral 2kV, Line/Neutral to PE 4kV EN61000-4-6. Test-CS Level 3, Criteria A EN61000-4-8, Test 3A/m, Criteria A EN61000-4-11, Criteria B EN61547 AC1 LED+ 1st LED AC LED AC2 Tel: +1 514 620 2722 2 of 7 LED LED- Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30N-Z up to 700mA | AC-DC LED driver Dimensions 47.0 1.85 25.0 0.98 168.0 6.61 Side View1 25.0 0.98 168.0 6.61 Side View2 47.0 1.85 SCREW HOLE 25.0 0.98 LINE SLOT Efficiency Vs. Input Voltage & Output Current (Constant current load) AMEPR30N-4250Z 95.00% 90.00% Efficiency 85.00% 80.00% 115 VAC 75.00% 230 VAC 70.00% 277 VAC 65.00% 24 27 30 33 36 39 42 Output Voltage(V) www.aimtec.com F 052.1e R0 Tel: +1 514 620 2722 3 of 7 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30N-Z up to 700mA | AC-DC LED driver AMEPR30N-4260Z 95.00% 90.00% Efficiency 85.00% 80.00% 115 VAC 75.00% 230 VAC 70.00% 277 VAC 65.00% 24 27 30 33 36 39 42 Output Voltage (V) AMEPR30N-4270Z 95.00% 90.00% Efficiency 85.00% 80.00% 115 VAC 75.00% 230 VAC 70.00% 277 VAC 65.00% 24 27 30 33 36 39 42 Output Voltage(V) PFC Value vs. Output Load Current (constant current mode) AMEPR30N-4250Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 0.300 277 VAC 0.000 24 27 30 33 36 39 42 Output Voltage (V) www.aimtec.com F 052.1e R0 Tel: +1 514 620 2722 4 of 7 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30N-Z up to 700mA | AC-DC LED driver AMEPR30N-4260Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 0.300 277 VAC 0.000 24 27 30 33 36 39 42 Output Voltage (V) AMEPR30N-4270Z 1.200 PF 0.900 115 VAC 0.600 230 VAC 0.300 277 VAC 0.000 24 27 30 33 36 39 42 Output Voltage (V) www.aimtec.com F 052.1e R0 Tel: +1 514 620 2722 5 of 7 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30N-Z up to 700mA | AC-DC LED driver Constant Curent vs. Constant Voltage Mode AMEPR30N-4250Z 115/230/277… 0.600 Output Current (A) 0.500 0.400 0.300 0.200 0.100 0.000 24 27 30 33 36 39 Output Voltage (V) 42 45 48 51 AMEPR30N-4260Z 115/230/277… 0.700 Output Current (A) 0.600 0.500 0.400 0.300 0.200 0.100 0.000 24 27 30 33 36 39 42 45 48 51 Output Voltage (V) AMEPR30N-4270Z www.aimtec.com F 052.1e R0 Tel: +1 514 620 2722 6 of 7 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMEPR30N-Z up to 700mA | AC-DC LED driver 115/230/277… 0.800 Output Current (A) 0.700 0.600 0.500 0.400 0.300 0.200 0.100 0.000 24 27 30 33 36 39 Output Voltage (V) 42 45 48 51 NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity