AMSR1-78Z_1

Series AMSR1-78Z Up to 5 Watt | DC-DC Converter FEATURES: • • • • 3 Pin SIP package Non-isolated regulated output Short circuit protection Pin-out compatible with LM78XX Linear Regulators • • • • No heatsink required Operating temperature -40°C to +85°C High efficiency Up To 94% Low ripple and noise Models Single output Model AMSR1-781.5Z AMSR1-781.8Z AMSR1-782.5Z AMSR1-783.3Z AMSR1-7805Z Input Voltage (V) 4.75-18 4.75-18 4.75-18 4.75-18 6.50-18 Output Voltage (V) 1.5 1.8 2.5 3.3 5 Output Current max (mA) 1000 1000 1000 1000 1000 Efficiency Vin Max (%) 78 82 87 90 94 Efficiency Vin Min (%) 72 76 81 85 89 NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity 4300000 hrs (MIL-HDBK-217F, Ground Benign, t=+25 oC) 1.5 mm from case for 10sec 260 C www.aimtec.com F 051e R11.D Tel: +1 514 620 2722 1 of 3 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMSR1-78Z Up to 5 Watt | DC-DC Converter Pin Out Specifications Pin 1 2 3 Single +Vin GND +Vout Dimensions Front View 0.46 (11.70) 0.29 (7.50) Side View 1 2 3 0.02 (0.5) 0.02 (0.5) Bottom View 0.080 (2.00) 0 .13 (3.30) 0.1 0.1 (2.54) (2.54) 0.13 (3.30) Derating Free Air Convection 60 ºC 100 Output Power (%) 80 60 40 20 0 - 40 - 20 0 20 40 60 80 85 Safe Operating Area 100 Ambient Temperature º C www.aimtec.com F 051e R11.D Tel: +1 514 620 2722 2 of 3 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMSR1-78Z Up to 5 Watt | DC-DC Converter Application Circuits Recommended soft start circuit Wide input isolated (up to 6000VDC) dual outputs with high efficiency +Vin C1 AMSR1-78Z +Vout C2 DC DC COM -Vout GND Isolated Dual Outputs Wide Input Range 6.5V to 18V C1: Optional C2: Required for Decoupling (further decoupling may be required between the two converters). Isolated (up to 6000VDC) single and regulated output NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity