AMSR2-786.5-NZ

Series AMSR2-78-NZ Up to 13 Watt | DC-DC Converter FEATURES: • • • • 3 Pin SIP Package Pin-out compatible with LM78XX Linear Regulators Continuous Short Circuit Protection Non-Isolated Regulated Outputs • • • • Operating temperature -40°C to +85°C Wide input range Very High Efficiency Up To 92% Low ripple and noise Models Single output Model AMSR2-782.5-NZ AMSR2-783.3-NZ AMSR2-7805-NZ AMSR2-786.5-NZ Input Voltage (V) 4.75-18 4.75-18 7-18 8.5-18 Output Voltage (V) 2.5 3.3 5 6.5 Output Current max (A) 2 2 2 2 Efficiency Vin Min (%) 85 87 91 92 Efficiency Vin Max (%) 83 86 88 91 NOTE: All specifications in this datasheet are measured at an ambient temperature of 25°C, humidity 2 000 000 hrs (MIL-HDBK-217F, Ground Benign, t=+25°C) 1.5 mm from case for 10 sec 300 C www.aimtec.com F 051e R12 Tel: +1 514 620 2722 1 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMSR2-78-NZ Up to 13 Watt | DC-DC Converter Pin Out Specifications Pin 1 2 3 Single +Vin GND +Vout Dimensions 2.54 (0.10) Footprint Ø 1.0 +0.15/-0 (Ø 0.04 + 0.006/-0 2.54 (0.10) DIV: 2.54 (0.1) Dimensions are typical values: mm (inch) General Tolerance: ± 0.25 (± 0.01) Pin Tolerance: ± 0.1 (± 0.004) www.aimtec.com F 051e R12 Tel: +1 514 620 2722 2 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMSR2-78-NZ Up to 13 Watt | DC-DC Converter Derating Free Air Convection 71º C 100 Output Power (%) 80 60 40 20 0 - 40 - 20 0 20 40 60 80 85 Safe Operating Area 100 Ambient Temperature º C Typical Application Circuit C1: A low ESR capacitor is required to keep the noise of the converter to a minimum. Ceramic capacitors are recommended with typical value is 10µF / 25V. C2: Installation of C2 is recommended with typical value of 22µF / 16V ceramic for 5V and 6.5V output signal and 22µF / 6.3V ceramic for 2.5V and 3.3V output signal. NOTE: This part is not designed for parallel operation. www.aimtec.com F 051e R12 Tel: +1 514 620 2722 3 of 4 Toll free: + 1 888 9 AIMTEC (924 6832) North America only Series AMSR2-78-NZ Up to 13 Watt | DC-DC Converter Dual Output Connection Input Filter 10uH ~ 47uH 1 C1 10uF GND Output Filter 3 +Vout AMSR2-78Z 2 C2 22uF GND C1 10uF 10uH ~ 47uH 1 C1 10uF GND AMSR2-78Z 2 3 C1 10uF C1 10uF +Vout C2 22uF GND NOTE: 1. Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled by Aimtec; refer to www.aimtec.com for the most current product specifications. 2. Product labels shown, including safety agency certifications on labels, may vary based on the date manufactured. 3. Mechanical drawings and specifications are for reference only. 4. All specifications are measured at an ambient temperature of 25°C, humidity