A2557ELB

A2557ELB

  • 厂商:

    ALLEGRO(埃戈罗)

  • 封装:

    SOIC16

  • 描述:

    IC PWR DRIVER BIPOLAR 1:1 16SOIC

  • 详情介绍
  • 数据手册
  • 价格&库存
A2557ELB 数据手册
2557 A2557xLB (SOIC) OUT 1 K OUT 2 GROUND GROUND OUT 3 FAULT OUT 4 1 2 3 4 5 6 7 8 16 15 14 13 12 11 10 9 IN 1 IN 2 ENABLE GROUND GROUND V CC IN 3 IN 4 PROTECTED QUAD LOW-SIDE DRIVER WITH FAULT DETECTION and SLEEP MODE The A2557xB, A2557xEB, and A2557xLB have been specifically designed to provide cost-effective solutions to relay-driving applications with up to 300 mA drive current per channel. They may also be used for driving incandescent lamps in applications where turn-on time is not a concern. Each of the four outputs will sink 300 mA in the on state. The outputs have a minimum breakdown voltage of 60 V and a sustaining voltage of 40 V. A low-power Sleep Mode is activated with either ENABLE low or all inputs low. In this mode, the supply current drops to below 100 µA. Over-current protection for each channel has been designed into these devices and is activated at a nominal 500 mA. It protects each output from short circuits with supply voltages up to 32 V. When an output experiences a short circuit, the output current is limited at the 500 mA current clamp. In addition, foldback circuitry decreases the current limit if an excessive voltage is present across the output and assists in keeping the device within its SOA (safe operating area). An exclusive-OR circuit compares the input and output state of each driver. If either a short or open load condition is detected, a single FAULT output is turned on (active low). Continuous or multiple overload conditions causing the channel temperature to reach approximately 165°C will result in an additional linear decrease in the output current of the affected driver. If the fault condition is corrected, the output stage will return to its normal saturated condition. The packages offer fused leads for enhanced thermal dissipation. Package B is 16-pin power DIP with exposed tabs, EB is 28-lead power PLCCs, and LB are 16-lead power wide-body SOICs for surface-mount applications. The lead (Pb) free versions have 100% matte tin leadframe plating. Data Sheet 29317.16H Dwg. PP-017-4 Note that the A2557xB (DIP) and the A2557xLB (SOIC) are electrically identical and share a common terminal number assignment. ABSOLUTE MAXIMUM RATINGS Output Voltage, VO .............................. 60 V Over-Current Protected Output Voltage, VO ..................................................... 32 V Output Current, IO ......................... 500 mA* FAULT Output Voltage, VFLT ............. 60 V Logic Supply Voltage, VCC ................. 7.0 V Input Voltage, VI or VOE ..................... 7.0 V Package Power Dissipation, PD ........................................... See Graph Operating Temperature Range, TA Suffix ‘S-’ ...................... -20°C to +85°C Suffix ‘E-’ ...................... -40°C to +85°C Suffix ‘K-’ ................... -40°C to +125°C Junction Temperature, TJ ............................................... +150°C* Storage Temperature Range, TS ................................. -55°C to +150°C *Outputs are current limited at approximately 500 mA per driver and junction temperature limited if higher current is attempted. FEATURES ■ 300 mA Output Current per Channel ■ Independent Over-Current Protection &Thermal Limiting for Each Driver ■ Output Voltage to 60 V ■ Output SOA Protection ■ Fault-Detection Circuitry for Open or Shorted Load ■ Low Quiescent Current Sleep Mode ■ Integral Output Flyback/Clamp Diodes ■ TTL- and 5 V CMOS-Compatible Inputs 2557 PROTECTED QUAD DRIVER WITH FAULT DETECTION & SLEEP MODE Selection Guide Part Number Pb-free Package Ambient Temperature (°C) –20 to 85 –20 to 85 –20 to 85 –20 to 85 –20 to 85 –20 to 85 –40 to 85 –40 to 85 –40 to 85 –40 to 85 –40 to 85 –40 to 85 –40 to 125 –40 to 125 –40 to 125 –40 to 125 –40 to 125 –40 to 125 A2557SB A2557SB-T A2557SEB A2557SEB-T A2557SLB A2557SLB-T A2557EB A2557EB-T A2557EEB A2557EEB-T A2557ELB A2557ELB-T A2557KB A2557KB-T A2557KEB A2557KEB-T A2557KLB A2557KLB-T – Yes – Yes – Yes – Yes – Yes – Yes – Yes – Yes – Yes 16-pin DIP,exposed tabs 16-pin DIP,exposed tabs 28-lead PLCC 28-lead PLCC 16-lead SOIC 16-lead SOIC 16-pin DIP,exposed tabs 16-pin DIP,exposed tabs 28-lead PLCC 28-lead PLCC 16-lead SOIC 16-lead SOIC 16-pin DIP,exposed tabs 16-pin DIP,exposed tabs 28-lead PLCC 28-lead PLCC 16-lead SOIC 16-lead SOIC 2 115 Northeast Cutoff, Box 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000 255 7 PROTECTED QUAD DRIVER WITH FAULT DETECTION & SLEEP MODE FUNCTIONAL BLOCK DIAGRAM FAULT ENABLE SLEEP CONTROL 60 µA K COMMON CONTROL ONE OF FOUR DRIVERS V CC – + 2.5 V OUTN IN N THERMAL LIMIT CURRENT LIMIT 30 µA
A2557ELB
1. 物料型号: - A2557xB, A2557xEB, A2557xLB是特定设计的四路低侧驱动器,用于继电器驱动应用,每个通道可提供高达300 mA的驱动电流。

2. 器件简介: - 这些器件设计用于驱动继电器或在不考虑启动时间的情况下驱动白炽灯,每个输出在导通状态下能吸收300 mA电流,具有60V的最小击穿电压和40V的维持电压。低功耗睡眠模式可通过使能低或所有输入低来激活,此时供电电流降至低于100 µA。

3. 引脚分配: - A2557xB (DIP) 和 A2557xLB (SOIC) 电气特性相同,共享相同的端子编号分配。

4. 参数特性: - 每个通道设计有独立过流保护,激活于500 mA,保护每个输出免受过压损害,当输出短路时,电流限制在500 mA。过流保护电路在检测到短路或开路时激活FAULT输出(低电平有效)。

5. 功能详解: - 这些器件监控输出以检测故障(开路或短路)条件,FAULT输出仅在使能高时有效。所有输出都有内部飞回二极管,共同的阴极连接在K端子。

6. 应用信息: - 可用于驱动白炽灯和感性负载(如单相步进电机),内部二极管可防止在感性负载关闭时产生的高电压尖峰损害输出晶体管。

7. 封装信息: - 提供多种封装选项,包括16脚DIP(带暴露的引脚)、28脚PLCC和16脚宽体SOIC,所有封装均提供有铅和无铅版本。
A2557ELB 价格&库存

很抱歉,暂时无法提供与“A2557ELB”相匹配的价格&库存,您可以联系我们找货

免费人工找货