A5303SLETR-T

A5303 Photoelectric Smoke Detector with Interconnect, Timer, and Latching Alarm Indicator Not for New Design These parts are in production but have been determined to be NOT FOR NEW DESIGN. This classification indicates that sale of this device is currently restricted to existing customer applications. The device should not be purchased for new design applications because obsolescence in the near future is probable. Samples are no longer available. Date of status change: October 1, 2022 Recommended Substitutions: For existing customer transition, and for new customers or new applications, contact factory. NOTE: For detailed information on purchasing options, contact your local Allegro field applications engineer or sales representative. Allegro MicroSystems reserves the right to make, from time to time, revisions to the anticipated product life cycle plan for a product to accommodate changes in production capabilities, alternative product availabilities, or market demand. The information included herein is believed to be accurate and reliable. However, Allegro MicroSystems assumes no responsibility for its use; nor for any infringements of patents or other rights of third parties which may result from its use. A5303 Photoelectric Smoke Detector with Interconnect, Timer, and Latching Alarm Indicator FEATURES AND BENEFITS ▪ Low average standby current allows 10-year battery life ▪ 2.3 to 5.5 V operating range ▪ Interconnect option ▪ Logic outputs to control an external sound IC ▪ Low battery detection and warning ▪ Chamber sensitivity test and warning ▪ Triple horn-chirp to distinguish chamber warning ▪ Power-on reset (POR) ▪ Digital filter on I/O provides significant noise immunity ▪ Timer (hush) mode for enabling reduced sensitivity period ▪ Built-in circuits to reduce false triggering ▪ ESD protection circuitry on all pins ▪ Temporal Horn Pattern, per UL217, NFPA72, ISO8201 ▪ Latching alarm indicator identifies alarm-initiating devices PACKAGE: 20-pin TSSOP (suffix LE) Not to scale DESCRIPTION The A5303 is a low-current BiCMOS photoelectric smoke detector circuit with ultra-low standby current and can operate for 10 years powered by inexpensive batteries. This device can be used with an infrared optical chamber to sense light scattered from smoke particles. A networking capability allows units to be interconnected so that if any unit senses smoke all units will sound an alarm. Special features are incorporated in the design to facilitate calibration and testing of the finished detector. A variable-gain photoamplifier can be directly interfaced to an infrared emitter-detector pair. The amplifier gain levels are determined by two external capacitors and are internally selected depending on the operating mode. Low gain is selected during standby and timer modes. During a local alarm, this low gain is increased (internally) by approximately 45% to provide hysteresis. High gain is used during pushbutton test and to periodically monitor the chamber sensitivity during standby. The internal oscillator and timing circuitry minimize standby power by sensing for smoke for only 100 μs once every 10 seconds. A special three-stage-speedup sensing scheme is incorporated to minimize the time to an audible alarm and also to reduce false triggering. Chamber sensitivity is periodically monitored, and two consecutive cycles of degraded sensitivity are required for a warning signal to occur. The A5303 is supplied in a thin profile (