A8186SLU

8186 LOW-DROPOUT, 3.3 V REGULATOR 8186 LOW-DROPOUT, 3.3 V REGULATOR — HIGH EFFICIENCY Designed specifically to meet the requirement for extended operation of battery-powered equipment such as cordless and cellular telephones, the A8186SLU voltage regulator offers the reduced dropout voltage and quiescent current essential for maximum battery life. Applicable also to palmtop computers and personal data assistants, the device delivers a regulated, continuous 3.3 V output at up to 75 mA under normal operating conditions, or to 150 mA (transient) under worst-case conditions. A PMOS pass element provides a typical dropout voltage of only 85 mV at 60 mA of load current. The low dropout voltage permits deeper battery discharge before output regulation is lost. Furthermore, quiescent current does not increase as the dropout voltage is approached, an ideal feature in standby/resume power systems where data integrity is crucial. Regulator accuracy and excellent temperature characteristics are provided by a bandgap reference. An ENABLE input gives the designer complete control over power up, standby, or power down. Data Sheet 27468.14 PRELIMINARY INFORMATION (subject to change without notice) ABSOLUTE MAXIMUM RATINGS Input Voltage, VI . . . . . . . . . . . . . . 10 V Output Current, IO . . . . . . . . . 150 mA* Enable Input Voltage, VE . . . . . . . . . . VI Operating Temperature Range, TA . . . . . . . . . . . . . -20°C to +85 °C Junction Temperature, TJ . . . +150°C† Storage Temperature Range, TS . . . . . . . . . . . . -40°C to +150°C * Output current rating is limited by input voltage, duty cycle, and ambient temperature. Under any set of conditions, do not exceed a junction temperature of +150° C. See next page. † Fault conditions that produce excessive junction temperature will activate device thermal shutdown circuitry. These conditions can be tolerated but should be avoided. T C UY DL ON RO PE DC EN UE IN ER TF NE OR CR IS O DF — OUT SUB January 12, 1995 IN 6 5 4 3.3 V SUB VR SUB 1 2 3 GND ENABLE SUB This device is supplied in a 6-lead small-outline plastic package (similar to the SOT-89/TO-243AA) for surface-mount applications. The A8186SLU is rated for operation over a temperature range of -20°C to +85°C. Dwg. PS-021-1 FEATURES AND BENEFITS s High Efficiency Provides Extended Battery Life s 85 mV Typical Dropout Voltage at IO = 60 mA s 45 µA Typical Quiescent Current at V I = 6 V Less Than 1 µA “Sleep” Current s Up to 150 mA Output Current s CMOS-Compatible ON/OFF Control For Power-Up, Standby, or Shutdown s Internal Thermal Protection s Surface-Mount Package APPLICATIONS s s s s Cordless and Cellular Telephones Personal Data Assistants Personal Communicators Palmtop Computers A8186SLU . Always order by complete part number: 8186 LOW-DROPOUT, 3.3 V REGULATOR FUNCTIONAL BLOCK DIAGRAM IN 4 6 OUT BIAS DRIVE ERROR AMP THERMAL PROTECT. ENABLE ENABLE 3 BANDGAP REF. 2 5 SUB SUB 1 GND SUB Dwg. FS-012-3 Terminal numbering is in accordance with EIA/JEDEC convention. Where EIAJ conventions apply, the tab is not numbered, resulting in terminal 6 being designated terminal 5. For proper operation, terminals 1 and 2 must be externally connected together. MAXIMUM ALLOWABLE OUTPUT CURRENT with device mounted on 2.24" x 2.24" (56.9 mm x 56.9 mm) solder-coated copper-clad board in still air. Maximum Allowable Output Current in Milliamperes with VI = 8 V, TJ = 150°C, Period ≤10 s* dc (Duty Cycle) TA 25°C 50°C 70°C 85°C 100% 100 80 65 50 90% 115 90 70 60 80% 125 100 80 65 70% 145 115 90 75 60% 150 135 110 85 50% 150 150 130 105 40% 150 150 150 130 30% 150 150 150 150 20% 150 150 150 150 * IO = (TJ - TA)/([V I - VO ] RθJA • dc) = (150 - TA)/(4.7 • 258 • dc) Output current rating can be increased (to 150 mA maximum) by heat sinking or reducing the input voltage. Conditions that produce excessive junction temperature will activate device thermal shutdown circuitry. These conditions can be tolerated but should be avoided. 115 Northeast Cutoff, Box 15036 W Worcester, Massachusetts 01615-0036 (508) 853-5000 Copyright © 1995 Allegro MicroSystems, Inc. 8186 LOW-DROPOUT, 3.3 V REGULATOR ELECTRICAL CHARACTERISTICS at TA = +25°C (unless otherwise noted). Limits Characteristic Output Voltage Symbol VO Test Conditions 4 V ≤ VI ≤ 8 V, 10 µA ≤ IO ≤ 100 mA* TA = +25°C -20°C ≤ TA ≤ +85°C Min. 3.25 3.20 3.00 — — — — — — — — — — — 2.0 — — 150 Mounted on 2.24" x 2.24" solder-coated copper-clad board in still air — Typ. 3.30 3.30 — — 8.0 10 20 13 8.0 85 190 45 50 0.05 — — — — 258 Max. 3.35 3.40 — ±1.0 12 20 30 25 20 150 300 60 65 1.0 — 0.8 ±0.1 — — Units V V V mV/°C mV mV mV mV mV mV mV µA µA µA V V µA °C °C/W VI = 3.3 V, IO = 60 mA*, -20°C ≤ TA ≤ +85°C Output Volt. Temp. Coeff. Line Regulation αVO ∆VO( ∆VI) VI = 6 V, IO = 10 mA 6 V ≤ VI ≤ 8 V, IO = 1 mA 4 V ≤ VI ≤ 6 V, IO = 1 mA Load Regulation ∆VO(∆IO) 1 mA ≤ IO ≤ 100 mA*, VI = 8 V 1 mA ≤ IO ≤ 100 mA*, VI = 6 V 1 mA ≤ IO ≤ 100 mA*, VI = 4 V Dropout Voltage VImin - VO IO = 60 mA* IO = 125 mA* Quiescent Current (GND terminal current) IQ(off) ENABLE Input Voltage VEH VEL ENABLE Input Current Thermal Shutdown Temp. Thermal Resistance IE TJ Rθ JA IQ VI = 6 V, 1 mA ≤ IO ≤ 100 mA*, VE ≥ 2.0 V VI = 8 V, 1 mA ≤ IO ≤ 100 mA*, VE ≥ 2.0 V 4 V ≤ VI ≤ 8 V, VE ≤ 0.8 V 4 V ≤ VI ≤ 8 V, -20°C ≤ TA ≤ +85° C Output ON Output OFF TA ≤ +85° C, VE = VI = 8 V Typical values are at TA = +25° C and are given for circuit design information only. * Pulse test (≤20 ms). See previous page for duty cycle limitations. 8186 LOW-DROPOUT, 3.3 V REGULATOR TYPICAL CHARACTERISTICS LOAD REGULATION LINE REGULATION 3.36 3.36 TA = -20°C 50 mA INTERVALS 3.34 3.34 OUTPUT VOLTAGE in VOLTS OUTPUT VOLTAGE in VOLTS 3.32 VI = 8 V 3.30 VI = 6 V 3.32 I O = 0 mA IO = 100 mA 3.30 3.28 V =4V I 3.28 3.26 TA = -20°C 3.26 3.24 3.24 3.22 0 25 50 75 100 125 150 OUTPUT CURRENT in mA Dwg. GP-052-6 3.22 2.0 3.0 4.0 5.0 6.0 7.0 8.0 INPUT VOLTAGE in VOLTS Dwg. GP-053-6 3.36 3.36 TA = 25°C 50 mA INTERVALS 3.34 3.34 OUTPUT VOLTAGE in VOLTS 3.32 OUTPUT VOLTAGE in VOLTS 3.32 IO = 0 mA 3.30 VI = 8 V 3.30 3.28 V =4V I 3.28 IO = 100 mA 3.26 TA = 25°C 2 V INTERVALS 3.26 3.24 3.24 3.22 0 25 50 75 100 125 150 OUTPUT CURRENT in mA Dwg. GP-052-7 3.22 2.0 3.0 4.0 5.0 6.0 7.0 8.0 INPUT VOLTAGE in VOLTS Dwg. GP-053-7 CAUTION: Maximum allowable duty cycle will be significantly less than 100% at high temperatures, at high input voltages, or at high output currents. See Maximum Allowable Output Current table. 115 Northeast Cutoff, Box 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000 8186 LOW-DROPOUT, 3.3 V REGULATOR TYPICAL CHARACTERISTICS (cont’d) LOAD REGULATION 3.36 3.36 TA = 85°C 50 mA INTERVALS LINE REGULATION 3.34 OUTPUT VOLTAGE in VOLTS 3.34 OUTPUT VOLTAGE in VOLTS 3.32 3.32 3.30 V =8V I 3.30 IO = 0 mA 3.28 3.28 3.26 TA = 85°C 2 V INTERVALS VI = 4 V 3.26 IO = 100 mA 3.24 3.24 3.22 0 25 50 75 100 125 150 OUTPUT CURRENT in mA Dwg. GP-052-8 3.22 2.0 3.0 4.0 5.0 6.0 7.0 8.0 INPUT VOLTAGE in VOLTS Dwg. GP-053-8 OUTPUT VOLTAGE 3.5 3.0 VI = 6 V 3.31 IO = 0 OUTPUT VOLTAGE in VOLTS 2.0 OUTPUT VOLTAGE in VOLTS 2.5 3.30 1.5 I O = 0 - 100 mA TA = 25°C 3.29 1.0 3.28 0.5 0 0 1.0 2.0 3.0 INPUT VOLTAGE in VOLTS 4.0 -50 0 +50 +100 AMBIENT TEMPERATURE in °C Dwg. GP-059-1 Dwg. GP-050-2 CAUTION: Maximum allowable duty cycle will be significantly less than 100% at high temperatures, at high input voltages, or at high output currents. See Maximum Allowable Output Current table. 8186 LOW-DROPOUT, 3.3 V REGULATOR TYPICAL CHARACTERISTICS (cont’d) QUIESCENT (GROUND TERMINAL) CURRENT 60 QUIESCENT (GROUND TERMINAL) CURRENT in µA 50 VI =6V IO = 0 VE ≥ 2 V QUIESCENT (GROUND TERMINAL) CURRENT in µA IO = 0 50 40 TA = 85°C 45 30 20 40 TA = 25°C TA = -20°C 10 35 -50 0 +50 +100 AMBIENT TEMPERATURE in °C Dwg. GP-051-1 0 0 2.0 4.0 6.0 8.0 INPUT VOLTAGE in VOLTS Dwg. GP-058 DROPOUT VOLTAGE 0.25 0.20 DROPOUT VOLTAGE in VOLTS 0.15 TA = 85°C TA = 25°C TA = -20°C 0.10 0.05 0 0 25 50 75 100 125 150 OUTPUT CURRENT in mA Dwg. GP-054-1 CAUTION: Maximum allowable duty cycle will be significantly less than 100% at high temperatures, at high input voltages, or at high output currents. See Maximum Allowable Output Current table. 115 Northeast Cutoff, Box 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000 8186 LOW-DROPOUT, 3.3 V REGULATOR TYPICAL CHARACTERISTICS (concluded) VI = 3.5 V to 6.5 V, CO as specified, TA = 25°C LOAD TRANSIENT PERFORMANCE ENABLE TRANSIENT PERFORMANCE VI = 3.5 V to 6.5 V, CO = 1 µF, TA = 25 °C 3.55 V VO CO = 10 µF 3.3 V 3.05 V 3.8 V 3.3 V VO 0 VO C O = 1 µF 3.3 V 2.8 V