ASR-SH240D25ZW

Solid State Relay SH Series Single Phase AC Output • • • • • • Zero-crossing or Random-on Switching Rated Load Current: 25A @ 24-660VAC DC Input SCR Output Built-in RC Snubber Circuit and TVS Optional RoHS Compliant Product Description ASR-SH series industrial single phase relay with SCR output is widely used in industry applications, PCB mounted. The relay can be used for resistive, inductive or capacitive load. The control voltage is 4-32VDC, the load voltage is 240VAC, 480VAC, or 600VAC, output current is rated at 25A. Product Selection ASR — SH 240 D 25 R W Packing: - : Bulk Packing A-Z SH Series Load Voltage 240:240VAC 380:380VAC 480:480VAC 600:600VAC Control Voltage Type D:DC Control A: AC Control Load Current 10:10Amps 25:25Amps Switching Mode Z:Zero Crossing R:Random-on Control Voltage 4-32VDC NOTE: Alternate control voltages: 18-36VAC, 4-15VDC, 15-32VDC are available as well as options for RC circuit and TVS. Consult with engineering to determine which combinations are available. INPUT CIRCUIT Control Voltage Range W 4-32VDC Must Turn-on Voltage 4VDC Must Turn-off Voltage 5/12/24 1.0VDC Maximum Input Current Random-on 25mA@32VDC Zero Crossing 18mA@32VDC 1 Solid State Relay SH Series Single Phase AC Output OUTPUT CIRCUIT Load Voltage Range 240VAC 24~280VAC 380VAC 24~440VAC 480VAC 24~530VAC 600VAC 24~660VAC Maximum Turn-on Time Random-On 1ms Zero Crossing 10ms Maximum Turn-off Time 10ms Maximum Surge 250A Current [@10 ms] Transient Overvoltage 240VAC 600Vpk 380VAC 800Vpk 480VAC/600VAC 1200Vpk Maximum Off-state Leakage Current [@ Rated Voltage] With RC 5mA Maximum On-state Voltage Drop [@ Rated Current] 1.5Vrms Minimum Off-state dv/dt [@ Maximum Rated Voltage] 500V/μs GENERAL INFORMATION Dielectric Strength, [50/60Hz] Input/Output 4000Vrms Input,Output/Base 2500Vrms Power Factor >0.5 Ambient Operating Temperature Range -30˚C +100˚C Ambient Stotage Temperature Range -30˚C +100˚C Weight [Typical] 50g 2 Solid State Relay SH Series Single Phase AC Output Application Note: Wiring Diagram Lighting control, Medical equipment, Elevator, Electric control door. Thermal Curve Important Notice 1. Soldering must be finished within 10 seconds at 260˚C,or finished within 5 seconds at 350˚C. Otherwise it may cause damage to the relay. 2. Terminal polarity must be observed. Otherwise it may cause damage to the relay. 3. When ambient temperature is above 25˚C, the maximum load current decreases. See thermal derating curve. Product Certification 1741 Industrial Drive, No. 14 • Sterling, IL 61081 Tel: 815-632-3150 • Fax: 815-632-3449 www.altranmagnetics.com • sales@altranmagnetics.com 3