Amphenol®
Assembly Instructions-C8
Type N
CLAMP TYPES
nut
Amphenol
Number
washer
A
a
B
1
male contact
Cable
RG-/U
plug body
Strip Dims., inches (mm)
a
c
18750
N Angle Plug
58, 141, 142
.484(12.3)
.234(5.9)
34025
N Plug
58, 141, 142
.390(9.9)
.203(5.2)
34025-RFX
N Plug
58, 141, 142
.354(9.0)
.177(4.5)
35275
N Bulkhead Jack
55, 58, 141, 142, 223
.561(14.3)
.172(4.4)
36250
N Panel Jack
55, 58, 141, 142, 223
.375(9.5)
.188(4.8)
82-63
N Jack
8, 9, 87A, 144, 165, 213, 214, 216, 225
.281(7.1)
.156(4.0)
82-67
N Bulkhead Jack
8, 9, 87A, 144, 165, 213, 214, 216, 225
.281 (7.1)
.156(4.0)
82-202
N Plug
8, 9, 144, 165, 213, 214, 216, 225
.359(9.1)
.234(6.0)
Belden 9913
.359(9.1)
.234(6.0)
.177(4.5)
82-202-RFX
Step 1
clamp
Connector
Type
82-202-1006 N Plug
▲
▲
gasket
8, 213, 214
.315(8.0)
82-209-1006 N Jack
N Plug
Belden 9913, Times AA-6146, 8 group
.281(7.1)
.156(4.0)
82-312
N Plug
8, 9, 144, 165, 213
.359(9.1)
.234(5.9)
82-3202
N Plug
8, 9, 144, 165, 213
.270(6.9)
.150(3.8)
Not supplied with part number 36250
Step 1 Place nut, washer and gasket (with "V" groove toward open
end of cable) over cable, and cut off jacket to dim. a.
c
C
Step 2
Step 2 Comb out braid and fold out. Bare center conductor to
dim. c as shown.
2
Step 3
P3
Step 3 Pull braid wires forward and taper toward center conductor.
Place clamp over braid and push back against cable
jacket.
Step 4
solder
SOLDER
Step 4 Fold back braid wires as shown, trim braid to proper length
and form over clamp as shown. Tin center conductor and
solder on contact.
P4
Step 5
STEP 5
Step 5 Insert cable and parts into connector body. Make sure
sharp edge of clamp seats properly in gasket. Tighten nut.
Amphenol Corporation Tel: 800-627-7100
www.amphenolrf.com
280
