901-10661

NOTES: 1. MATERIALS AND FINISHES: BODY, BODY-REAR, & COUPLING NUT - BRASS, NICKEL PLATING INSULATOR - PTFE, NATURAL INSULATOR DISC - ULTEM, NATURAL CONTACT - BRASS, GOLD PLATING FERRULE - COPPER, NICKEL PLATING RETAINING RING - STAINLESS STEEL, NATURAL CAP - STAINLESS STEEL, PASSIVATED GASKET & O-RINGS - SILICONE RUBBER, RED HEAT SHRINK TUBE - CROSSLINKED POLYOLEFIN, BLACK 2. ELECTRICAL: A. IMPEDANCE: 50 OHM B. FREQUENCY RANGE: DC - 8 GHz C. VSWR: 1.20 MAX. 3. MECHANICAL: A. DURABILITY: 500 CYCLES MIN. B. TEMPERATURE : -65°C TO +165°C 4. THIRD ANGLE PROJ. 7,50 REF [0.295 ] O-RING 6. CAP ASSEMBLY INSTRUCTIONS: A. PLACE O-RING ON CAP AS SHOWN. B. ASSEMBLE CAP TO BODY WITH 5 IN-LBS MAX TORQUE. SHOWS CABLE ENTRY DIMENSIONS. RELEASE TO MFG. 0,20 x45 $ [0.008 ] CAP CABLE ASSEMBLY INSTRUCTIONS: A. TRIM CABLE AS SHOWN. B. SLIDE HEAT SHRINK TUBING, FERRULE AND INSULATOR DISC ONTO CABLE. C. INSERT CABLE, UNTIL IT BOTTOMS, WITH FOIL ENTERING CONNECTOR AND BRAID OVER KNURL. D. SOLDER CABLE CENTER CONDUCTOR TO CONTACT. E. CRIMP FERRULE OVER BRAID WITH 0.213" HEX DIE. F. APPLY HEAT SHRINK TUBING OVER FERRULE. G. HEAT SHRINK TUBING SHOULD FULLY (360 $ ) COVER THE BUMP ON BODY AND END WITHIN AREA "A". 8. A DATE ECN APPR 17-Oct-19 13304 SKP 8,15 [0.321 ] BRAID 3,80 [0.150 ] CENTER CONDUCTOR 5. ADHESIVE LINED HEAT SHRINK TUBE IS INCLUDED (NOT SHOWN). DESCRIPTION 6,60 [0.260 ] DIELECTRIC & FOIL PACKAGING: A. QUANTITY: SINGLE PACK B. MARKING: BAG TO BE MARKED. "AMPHENOL RF, 901-10661 AND DATE CODE" 7. REVISIONS REV AREA "A" 1.50 MAX. [0.059] FROM BODY TO HST M4xP0.7-6g THREAD 19,06 [0.750 ] REF 14,56 [0.573 ] REF 7.20 MM WRENCH SCALE RECOMMENDED CABLE STRIPPING DIMENSIONS 8 4,60 REF [ 0.181 ] TYP(2) 8 3,25 [0.128 ] 8 1,20 [0.047 ] INSULATOR DISC 1.700 5,33 [0.210 ] FERRULE 8.00 MM WRENCH INTERFACE PER MIL-STD-348 SERIES: SMA PLUG UNLESS OTHERWISE SPECIFIED, DIMENSIONS ARE IN METRIC AND TOLERANCES ARE: