SGX-F2-5

Fluorine sensor SGX-F2-5 Datasheet SGX Liquid Electrochemical Gas Sensors These SGX Sensors use a revolutionary innovation in electrochemical sensing, which detects the output signals from the electrochemical reactions of different gases. Furthermore, it accurately measures gas concentration through the magnitude of the signal. These specialised sensors consist of three catalytic electrodes, liquid electrolyte and gas diffusion holes. Through the diffusion holes, the gas reaches the sensor's working electrode, where an electrochemical reaction takes place at the so-called 3-phase boundary. A current signal is generated at the output, which is linearly proportional to the gas concentration. Quality, Safety, Responsibility SGX Europe Sp. z o.o. T: +48 (0) 32 438 4778 Building 11 Ligocka St. 103, 40-568 Katowice, Poland E: sales.is@sgxsensortech.com www.sgxsensortech.com Technical Specifications Performance Sensitivity -260 ± 80 nA/ppm Measurement Range 0 – 5 ppm Zero Current ± 20 nA Maximum Overload 10 ppm Response Time Repeatability Lower Detectable Limit (LDL) Linear Range Resolution (16Bit ADC) SGX-F2-5 T50 < 20s, T90 < 60s 2% ≤ 0.05 ppm 5 ppm < 0.01ppm Features • Small size • Water based electrolyte • High selectivity • High sensitivity • Excellent sensitivity at low temperatures Environmental Details Temperature Range Pressure Range Operating Humidity Range Storage Temperature -20°C to +40°C 800 to 1200 hPA 15-95% RH 0 to 20℃ • Double sealed housing for advanced leakage protection Key applications • General Industry • Environmental Monitoring Lifetime Details Long-Term Drift Expected Lifetime < 1 %/month 24 months • Leak detection • Emissions Zero Drift in Clean Air < 1 ppm • TLV-monitoring Storage conditions 0-20°C • Semiconductor Industry Storage Life 6 months • Portable and Fixed Point Applications Warranty 12 months • Water Treatment, Plants, Swimming, Pools, Chemical Industry Operation Operating Principle Important Notes Amperometric • All performance is based on conditions at 20°C, 50% RH and 1 atm, flow rate>150qcm/min, using SGX recommended circuitry. Bias Voltage 0 mV Recommended Load Resistor 220 Ω Warm Up Time < 60 s • Sensor performance is temperature dependant; please contact SGX for temperature performance other than 20°C. PPO • Do not solder to the connector pins as this may damage the sensor and thereby invalidate the warranty. Housing Housing Material Weight < 8g • Details on recommended connector pins can be found in the Frequently Asked Questions within the Gas Sensor section of the SGX website. © SGX Sensortech 2012-2022 DS-0405-SGX-F2-5, Issue 1, 10-Feb-2022, Page 1/3 SGX Europe Sp. z o.o. T: +48 (0) 32 438 4778 Building 11 Ligocka St. 103, 40-568 Katowice, Poland E: sales.is@sgxsensortech.com www.sgxsensortech.com Dimensions W R C Cross Sensitivity Gas Formula Test Concentration Sensor Reading Ammonia NH3 100ppm 0ppm Carbon Monoxide CO 100ppm 0ppm Diborane B2H 6 0.6ppm 0.3ppm Hydrogen H2 1000ppm 0ppm Hydrogen Chloride HCL 20ppm 0ppm Hydrogen Fluoride HF 3ppm 0ppm Hydrogen Sulphide H 2S 10ppm 0ppm 0.25ppm 0.05ppm Ozone O3 Note: 1) The above interference factors may vary due to different sensors and service life, please refer to the actual test results. 2) This table is not complete for all cross gases, other gas please contact with us. © SGX Sensortech 2012-2022 DS-0405-SGX-F2-5, Issue 1, 10-Feb-2022, Page 2/3 SGX Europe Sp. z o.o. T: +48 (0) 32 438 4778 Building 11 Ligocka St. 103, 40-568 Katowice, Poland E: sales.is@sgxsensortech.com www.sgxsensortech.com Temperature Curve 0 -50 -100 -150 -200 average -250 std. dev. -300 -350 -400 -450 -40 -30 -20 -10 0 10 20 30 40 50 60 Temperature(℃) DISCLAIMER: SGX Europe Sp. z o.o. reserves the right to change design features and specifica�ons without prior no�fica�on. We do not accept any legal responsibility for customer applica�ons of our sensors. SGX Europe Sp. z o.o. accepts no liability for any consequen�al losses, injury or damage resul�ng from the use of this document, the informa�on contained within or from any omissions or errors herein. This document does not cons�tute an offer for sale and the data contained is for guidance only and may not be taken as warranty. Any use of the given data must be assessed and determined by the user thereof to be in accordance with federal, state and local laws and regula�ons. All specifica�ons outlined are subject to change without no�ce. SGX Europe Sp. z o.o. sensors are designed to operate in a wide range of harsh environments and condi�ons. However, it is important that exposure to high concentra�ons of solvent vapours is to be avoided, both during storage, fi�ng into instruments and opera�on. When using sensors on printed circuit boards (PCBs), degreasing agents should be used prior to the sensor being fi�ed. SGX Europe Sp. z o.o. makes every effort to ensure the reliability of its products. Where life safety is a performance requirement of the product, we recommend that all sensors and instruments using these sensors are checked for response to gas before use. Copyright© 2012-2022 SGX Sensortech All rights reserved. Trademarks and registered trademarks are the property of their respective owners. No part of this publication may be reproduced, distributed, or transmitted in any form or by any means, including photocopying, recording, or other electronic or mechanical methods, without the prior written permission of the publisher, except in the case of brief quotations embodied in critical reviews and certain other non-commercial uses permitted by copyright law. For permission requests or technical support please contact or write to the publisher, addressed “Attention: Permissions Coordinator,”. © SGX Sensortech 2012-2022 DS-0405-SGX-F2-5, Issue 1, 10-Feb-2022, Page 3/3