APL5523KAC-TR

APL5523 Dual-Channel, 3.3V/500mA and 1.8V/300mA Linear Regulator Features • Fixed Output Voltage : VOUT1=3.3V/500mA VOUT2=1.8V/300mA Low Dropout Voltage (defined as the minimum input/output voltage difference): Output 1 Dropout Voltage : 0.6V (at 500mA) Output 2 Dropout Voltage : 0.9V (at 300mA) Stable with 4.7uF Output Capacitor(at VOUT1) Stable with 2.2uF Output Capacitor(at VOUT2) Built in Thermal Protection Built in Current Limit Protection Fast transient Response Short Setting Time SOP-8 and SOP-8-P Package Available General Description The APL5523 is a dual low dropout regulator with output1 with 3.3V/0.5A and output2 with 1.8V/0.3A output capability. In order to obtain lower dropout voltage and faster transient response, which is critical for low voltage applications, the APL5223 has been optimized. The dropout voltages are guaranteed at 0.6V at 0.5A for output1 and 0.9V at 0.3A for output 2. Current limit is trimmed to ensure specified output current and controlled short-circuit current. On-chip thermal limiting provides protection against any combination of overload that would create excessive junction temperatures. The APL5523 regulator comes in a SOP-8 and SOP-8-P package. • • • • • • • Pin Configuration SOP−8 (Top View) V O UT1 SOP-8-P (Top View) V O UT1 1 2 3 4 8 7 6 5 Applications V GND GND GND GND 1 2 3 4 8 7 6 5 NC GND NC NC V V IN V V V IN IN IN O UT2 O UT2 • • • Desktop Computer Networking Systems Optical Data Storage Systems = Thermal Pad (connected to GND plane for better heat dissipation) Ordering and Marking Information APL5523 L e ad F re e C o d e H a n d lin g C o d e T e m p. R an g e P ackage C ode P ackage C ode K : S O P -8 K A : S O P -8-P O pe ra ting J u nc tio n T e m p . R a ng e C : 0 to 1 5 0° C H a n d lin g C o d e T U : T u be TR : Tape & Reel L e ad F re e C o d e L : L e a d F re e D e v ic e B la n k : O rigin a l D ev ic e A P L 5 5 2 3 K /K A : APL5523 XXXXX X X X X X - D a te C od e ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and advise customers to obtain the latest version of relevant information to verify before placing orders. Copyright  ANPEC Electronics Corp. Rev. A.1 - July., 2004 1 www.anpec.com.tw APL5523 Pin Description No. 1 2 3 4 5 6 7 8 PIN Name VOUT1 VIN VIN VOUT2 GND GND GND GND I/O O I I O Description VOUT1 output Voltage 3.3V. sources up to 500 mA. Supply Voltage. Supply Voltage. VOUT2 output Voltage 1.8V. sources up to 300 mA. Ground also functions as a heatsink. Solder to the ground plane to maximize thermal dissipation Absolute Maximum Ratings S ymbol V IN , V OUT R TH,JA Parameter Input Voltage or Out Voltage T herm al Resistance – Junction to Am bient S OP-8 S OP-8-P R TH,JC T herm al Resistance – Junction to Case S OP-8 S OP-8-P PD TJ Power Dissipation Operating Junction Tem perature C ontrol Section P ower Transistor T STG TL Storage Tem perature Range Lead Tem perature (Soldering, 10 second) 150 75 30 5 Internally Lim ited 0 to 125 0 to 150 -65 to +150 260 °C °C W °C ° C/W ° C/W Rating 6 Unit V Electrical Characteristics Unless otherwise noted these specifications apply over full temperature, CIN=1µF, COUT1=4.7µF, COUT2=2.2µF, TJ=0 to 125°C. Typical values refer to TJ=25°C. Symbol VIN ISHORT OTS Parameter Input Voltage Short Current VOUT=0V Over Temperature Shutdown Over Temperature Hysteresis Shutdown Hysteresis Output Voltage Temperature Coefficient Quiescent Current IOUT1=500mA, IOUT2=300mA IOUT1=0mA, IOUT2=0mA 2 Test Conditions APL5523 Min. 2.7 50 150 20 Typ. Max. 6 Unit V mA °C °C ppm/°C TC 100 900 100 1000 200 IQ µA Copyright  ANPEC Electronics Corp. Rev. A.1 - July., 2004 www.anpec.com.tw APL5523 Electrical Characteristics (Cont.) Unless otherwise noted these specifications apply over full temperature, CIN=1µF, COUT1=4.7µF, COUT2=2.2µF, TJ=0 to 125°C. Typical values refer to TJ=25°C. Symbol Parameter Test Conditions APL5523 Min. VOUT -2% Typ. 3.3 900 Max. VOUT +2% Unit Output1 (500mA) VOUT ILIMIT IOUT Output Voltage Circuit Current Limit Load Current VIN=5V VIN=VOUT+1V VIN=VOUT+1V VOUT+1V< VCC 2 0 0 V 1 0 m s , I tr > 1 0 0 m A Carrier Tape Po E P1 P D t F W Bo Ao Ko D1 T2 J C A B T1 Application A 330±1 F 5.5 ± 0.1 B 62 ± 1.5 C 12.75 + 0.1 5 J 2 + 0.5 T1 12.4 +0.2 P1 2.0 ± 0.1 T2 2± 0.2 Ao 6.4 ± 0.1 W 12 + 0.3 - 0.1 Bo 5.2± 0.1 P 8± 0.1 E 1.75± 0.1 SOP-8/P D D1 Po 1.55±0.1 1.55+ 0.25 4.0 ± 0.1 Ko t 2.1± 0.1 0.3±0.013 (mm) Copyright  ANPEC Electronics Corp. Rev. A.1 - July., 2004 10 www.anpec.com.tw APL5523 Cover Tape Dimensions Application SOP- 8/P Carrier Width 12 Cover Tape Width 9.3 Devices Per Reel 2500 Customer Service Anpec Electronics Corp. Head Office : 5F, No. 2 Li-Hsin Road, SBIP, Hsin-Chu, Taiwan, R.O.C. Tel : 886-3-5642000 Fax : 886-3-5642050 Taipei Branch : 7F, No. 137, Lane 235, Pac Chiao Rd., Hsin Tien City, Taipei Hsien, Taiwan, R. O. C. Tel : 886-2-89191368 Fax : 886-2-89191369 Copyright  ANPEC Electronics Corp. Rev. A.1 - July., 2004 11 www.anpec.com.tw