BXB150-48S12FLT

BXB150 Series DC/DC CONVERTERS • • • • • • • • • Single output 100-150W Wide Input DC/DC Converters 1 Industry standard footprint MTBF >1.4 million hours (Bellcore 332) Input voltage to ETS300-132-2 Adjustable output voltage No minimum load required Separate case ground pin 2:1 input range for battery powered applications Undervoltage lockout (UVLO) UL, VDE and CSA safety approvals The BXB150 Series are high power density DC/DC converters packaged in the industry standard footprint (2.40 x 2.28 x 0.50 inches) to give designers optimum choices when specifying for both new and replacement designs. Suitable for a wide range of applications in nearly any industry, the BXB150 was particularly designed with communication and distributed power applications in mind. Using Bellcore 332, the MTBF is greater than 1,400,000 hours. Aluminum baseplate technology with four threaded M3 inserts makes heatsink attachment and optimum thermal management easy. The BXB150 series is approved to IEC950 by UL, CSA and VDE. 2 YEAR WARRANTY All specifications are typical at nominal input, full load at 25°C unless otherwise stated SPECIFICATIONS OUTPUT SPECIFICATIONS Voltage adjustability Set point accuracy Line regulation Load regulation Minimum load Overshoot Undershoot Ripple and noise (5Hz to 20MHz) (See Note 1) Temperature coefficient Transient response (See Note 2) Remote sense INPUT SPECIFICATIONS Input voltage range Input current Input current (max.) (See Note 4) 24Vin nominal 48Vin nominal No load Remote OFF 24Vin 48Vin Input reflected ripple (See Note 6) 18 to 36VDC 36 to 75VDC 130mA max. 20mA max. 9.0A max. @ Io max. and Vin = 0 to 75V 6.5A max. @ Io max. and Vin = 0 to 75V 5mA pk-pk (See Note 7) Open collector ref to -input 1.2VDC max. Open circuit 3.3V and 5V 12V and 15V At turn-on and turn-off Low line to high line Full load to min. load 60% to 110% ±1.0% ±0.05% ±0.10% 0% None None 75mV pk-pk, 20mV rms 100mV pk-pk, 30mV rms ±0.01%/°C ±2.0% max. deviation 170µs recovery to within ±1.0% 0.5VDC transmission line drop compensation INPUT SPECIFICATIONS (continued) Undervoltage lockout 24Vin: 24Vin: 48Vin: 48Vin: power power power power up down up down 17V 16.3V 34V 32.5V 20ms 20ms Start-up time (See Note 8) Power up Remote ON/OFF EMC CHARACTERISTICS Conducted emissions (See Note 3) Bellcore 1089 FCC part 15 EN55022, CISPR22 Level A Level A Level A GENERAL SPECIFICATIONS Efficiency Isolation voltage Input/case Input/output Output/case Fixed See table 1500VDC 1500VDC 1500VDC 500kHz typ. VDE0805, EN60950, IEC950 UL1950, CSA C22.2 No. 950 Aluminum baseplate with plastic case UL94V-0 110g (3.88oz) Bellcore 332 MIL-HDBK-217F @ 40°C, 100% FL 1,400,000 hours 580,000 hours min. Switching frequency Approvals and standards (See Note 5) Case material Material flammability Weight MTBF ENVIRONMENTAL SPECIFICATIONS Thermal performance Altitude Vibration Operating case temp. -40°C to +100°C Non-operating -55°C to +125°C Operating Non-operating 5Hz to 500Hz 10,000 feet max. 40,000 feet max. 2.4G rms (approx.) Active low remote ON/OFF Logic compatibility ON OFF File Name: BXB150.PDF Rev: 01 Jan 2000 BXB150 Series DC/DC CONVERTERS OUTPUT POWER (MAX.) 100W 100W 150W 150W 150W Notes 1 2 3 4 5 6 7 Single output 100-150W Wide Input DC/DC Converters 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm OUTPUT CURRENT (MIN.) 0A 0A 0A 0A 0A OUTPUT CURRENT (MAX.) 30A 30A 30A 12.5A 10A INPUT VOLTAGE 18-36VDC 36-75VDC 36-75VDC 36-75VDC 36-75VDC OVP 4.3VDC 4.3VDC 6.5VDC 14.5VDC 17.5VDC OUTPUT VOLTAGE 3.3V 3.3V 5V 12V 15V EFFICIENCY (TYP.) 77% 79% 84% 84% 88% REGULATION LINE ±0.05% ±0.05% ±0.05% ±0.05% ±0.05% LOAD ±0.1% ±0.1% ±0.1% ±0.1% ±0.1% MODEL NUMBER (7) BXB150-24S3V3FLT BXB150-48S3V3FLT BXB150-48S05FLT BXB150-48S12FLT BXB150-48S15FLT PROTECTION Short circuit protection Overvoltage protection Undervoltage protection Thermal protection TELECOM SPECIFICATION Central office interface A EXTERNAL OUTPUT TRIMMING Output can be externally trimmed by using the method shown. 8 8 Measured with 10µF tantalum capacitor and 1µF ceramic capacitor across output. di/dt = 0.1A/1µs, Vin = 48VDC, Tc = 25°C, load change = 0.5 lo max. to 0.75 lo max. and 0.75 lo max. to 0.5 lo max. Units should be characterised within systems. External components required. Input fusing is recommended based on surge current and maximum input current. This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. Simulated source impedance of 12µH. 12µH inductor in series with +Vin. Active high remote on/off option is available (standard product is active low), designate with the suffix ‘FHT’ e.g. BXB150-48S05FHT. Consult factory for further details and options. Start-up into resistive load. Continuous, automatic recovery Non-latching Non-latching 110°C baseplate, automatic recovery ETS300-132-2 International Safety Standard Approvals VDE0805/EN60950/IEC950 File No. 10401-3336-1095 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062C TRIM UP 7 RT1 OR RT2 TRIM DOWN 6 PIN CONNECTIONS PIN NUMBER 1 2 3 4 5 6 7 8 9 FUNCTION + Vin Remote ON/OFF Case - Vin - Vout - Sense Trim + Sense + Vout 7 x Ø.040 (1.02) ±0.002 (0.05) 0.190 (4.83) ±0.010 (0.25) 2.28 (57.91) Max. 0.500 (12.69) ± 0.010 (0.25) CASE VIEW SHOWN PIN SIDE UP 1.90 (48.26) 0.190 (4.83) ± 0.010 (0.25) 0.200 (5.08) Min. Length for all Input and Output Pins +SEN TRIM -SEN 1.000 (25.40) 0.400 (10.16) 1.400 (35.56) VI (-) Vo (-) 0.700 (17.77) 0.400 (10.16) 1.000 (25.40) 2.000 (50.80) 2.40 (60.96) Max. ON/OFF 1.400 (35.56) Vo(+) VI(+) 2 x Ø.080 (2.03) ± 0.002 (0.05) 4 x M3 x 0.5 Through 0.500 (12.70) ALL DIMENSIONS IN INCHES (mm) Tolerance : x.xx ±0.02in. (0.51mm) x.xxx ±0.010in. (0.254mm) Data Sheet © Artesyn Technologies® 2002 The information and specifications contained in this data sheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. Specifications are subject to change without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. www.artesyn.com File Name: BXB150.PDF Rev: 01 Jan 2000