CL25-7612

CL25 SERIES Single, dual and triple outputs For new design -ins refer to the SCL25 series instead • • • • • • 90VAC to 264VAC Universal Input Short Circuit Protected VDE, UL, CSA and BABT Approved VDE0871 Level B Conducted Noise 25W Continuous, 35W Peak Output Power Stand alone "listed" equipment The CL25 Series of 25W (35W peak) external switching power supplies enables the system specifier to optimise the design for several reasons. Firstly, because the power supply offers pre-approved SELV outputs, the submission of the apparatus for safety approval is simplified. Secondly, the task of integrating the power supply into the mechanical design is eliminated, presenting further savings by ensuring a shorter and simpler design cycle. These advantages are complemented by Universal Input, IEC950, UL, CSA and BABT approvals, to complete a worldwide packaged power solution suitable for a wide variety of low power, desktop applications. [ 2 YEAR WARRANTY ] SPECIFICATION OUTPUT SPECIFICATIONS Line regulation LL to HL, FL Overshoot/undershoot Transient response All specifications are typical at nominal input, full load at 25°C unless otherwise stated GENERAL SPECIFICATIONS ±0.5% ±0.5% ±1.0% 10% Isolation voltage ±250mV max. dev. 1ms recovery to 1% ±0.025%/°C 6.25V ±0.75V 45W Pin max. Continuous with auto restart 0A MTBF MIL-HDBK-217E 150,000 hours ENVIRONMENTAL SPECIFICATIONS Case material Material flammability Weight Input/output Input/chassis Variable Safety 3000VAC 1500VAC 45kHz to 85kHz VDE0805, EN60950 BABT, IEC950, UL1950 CSA C22.2 No. 950 ABS plastic UL94-5V 500g (17.65oz) Hold-up time Efficiency 110VAC 230VAC 110VAC and 230VAC 10ms 60ms 70% typical Single outputs Multi's: +5.1V output Multi's: aux. outputs At turn-on +5.1V (40% to 60% full load step) Switching frequency Approvals and standards Temperature coefficient All outputs Overvoltage protection Output power limit Short circuit protection Minimum output current INPUT SPECIFICATIONS Input voltage range Input frequency range Input surge current Safety ground leakage current 110VAC 230VAC 110VAC, 60Hz 230VAC, 50Hz +5V output only Primary power limited 90 to 264VAC 120 to 370VDC 47 to 440Hz 12A max. 24A max. 1mA max. 2mA max. Thermal performance Operating 0°C to +40°C Non-operating –40°C to +85°C 0°C to +40°C ambient, 25W convection cooled Peak (0°C to 40°C, max. 60s), 35W See Note 1 Non-condensing Operating Non-operating 5Hz to 500Hz 5% to 95% RH 10,000 feet max. 30,000 feet max. 2.4G rms (approx.) Relative humidity Altitude Vibration ELECTROMAGNETIC COMPATIBILITY SPECIFICATIONS Radiated noise EN55022, EN55011, FCC Conducted noise EN55022, EN55011, FCC Electrostatic discharge EN61000-4-2 Electrostat. air discharge IEC801-2 RF field susceptibility IEC801-3 Electrical fast EN61000-4-4 transients/bursts Surge susceptibility EN61000-4-5 Level A Level B Level 4 Level 3 Level 3 Level 3 Level 3 International Safety Standard Approvals geprüfte Sicherhelt VDE0805/EN60950/IEC950 File No. 10401-3336-1071 Licence No. 90353, 79517 and 1071 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062C/LR50913/LR101320 PAGE 1 Certificate No. 606008 AC/DC POWER SUPPLIES | 25W AC/DC 25 Watt AC/DC external power supplies OUTPUT VOLTAGE 5.1V 9.5V 12.0V 16V 24.0V 48.0V +5.1V (A) ±12.0V (B) +5.1V (A) ±15V (B) (4) (4) OUTPUT CURRENT RIPPLE MAX 5.0A 2.5A 2.0A 1.5A 1.0A 0.5A 2.5A 1.0A 2.5A 0.8A 2.5A 0.5A 2.0A 1.0A 0.2A 2.0A 0.5A 0.2A PEAK 6.0A 3.2A 2.5A 2.0A 1.5A 0.7A 4.0A 2.0A 4.0A 1.5A 4.0A 1.0A 4.0A 2.0A 1.0A 4.0A 1.5A 1.0A (1) (2) TOTAL REGULATION ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±4.0% ±3.0% ±3.0% ±3.0% ±3.0% ±3.0% ±3.0% ±4.0% ±5.0% ±5.0% ±4.0% ±5.0% ±5.0% SINGLE OUTPUT VA VA VA VA Return Return Return Return (3) MODEL NUMBER CL25-7605(5) CL25-7614 CL25-7612 CL25-7616 CL25-7624 CL25-7617 CL25-7618 100mV 95mV 120mV 160mV 240mV 240mV 50mV 120mV 50mV 150mV 50mV 240mV 50mV 120mV 120mV 50mV 150mV 150mV PIN NUMBER Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 6.32 ref (160.0 + 0.3 ) - 0.0 CL25-7619(5) +5.1V (A) ±24V (B) (4) CL25 -7620(5) +5.1V (A) +12V (B) – 12V (C) +5.1V (A) +15V (B) –15V(C) Notes 1 2 3 CL25-7608(5) CL25-7610(5) 4 5 6 Peak output current lasting less than 60 seconds with duty cycle