NLP65-3300J

NLP65-3300J LOW POWER AC/DC POWER SUPPLIES • • • • • • • Single output 33 W AC/DC Universal Input Switch Mode Power Supplies 1 5.0 x 3.0 inch card and 1.26 inch package (1U applications) EN61000-3-2 compliance option (HCC) Overvoltage and short circuit protection EN55022, EN55011 conducted emissions level B EN61000-4-2, -3, -4, -5, -6 immunity compliant Enclosure and cover kit options Available RoHS compliant The NLP65-3300J is a 33 W universal input ac-dc power supply on a 5 x 3 inch card with a maximum component height of 1.26 inches for use in 1U applications. This model has the option of input harmonic current correction in the same package size making the series ideal for product designs that will need to comply with EN61000-3-2 legislation. The NLP65-3300J provides 33 W of output power with free air convection cooling. The NLP65, with full international safety approval and the CE mark, meets conducted emissions EN55022 level B and has immunity compliance to EN61000-4-2, -3, -4, -5, -6. The series is available in a factory installed enclosure with an IEC connector and output connector on flying leads plus a cover kit for self-installation is also available as an accessory. The NLP65 series is designed for use in low power data networking, computer and telecom applications such as hubs, routers, POS terminals, internet servers, cable modems and PABX’s. This list is not exclusive as the generic feature set of the NLP65 series with industry standard output configurations provides a solution for most low power applications including many industrial applications. All specifications are typical at nominal input, full load at 25 °C unless otherwise stated 2 YEAR WARRANTY SPECIFICATIONS (4, 10) OUTPUT SPECIFICATIONS Total regulation Rise time Transient response Line and load At turn-on Main output 25% step at 0.1 A/µs ±3.0% max. 1.0 s, max. @ 230 Vac 5.0% or 165 mV max. dev., 1 ms max. recovery to 1% ±0.02%/°C 125%, ±10% Cyclic operation Single Yes, indefinite (See Note 6) EMC CHARACTERISTICS Conducted emissions Radiated emissions ESD air ESD contact Surge Fast transients Radiated immunity Conducted immunity Temperature coefficient Overvoltage protection Short circuit protection Minimum output current INPUT SPECIFICATIONS Input voltage range (See Note 1) Input frequency range Input surge current (cold start) Safety ground leakage current Inrush current Input current 120 Vac 230 Vac 120 Vac, 60 Hz 230 Vac, 50 Hz 230 Vac 120 230 120 230 Vac, Vac, Vac, Vac, with PFC with PFC without PFC without PFC Nominal EN55022, FCC part 15, (Note 3) Level B EN55022, FCC part 15 Level A EN61000-4-2, level 3 Perf. criteria 1 EN61000-4-2, level 4 Perf. criteria 1 EN61000-4-5, level 3 Perf. criteria 1 EN61000-4-4, level 3 Perf. criteria 1 EN61000-4-3, level 3 Perf. criteria 2 EN61000-4-6, level 3 Perf. criteria 2 GENERAL SPECIFICATIONS Hold-up time Efficiency Isolation voltage Input/output Input/chassis Fixed 230 Vac, 50 Hz 78 ms @ 33 W 64% typical 3000 Vac 1500 Vac 100 kHz, ±5 kHz EN60950, VDE0805, IEC950 UL1950, CSA C22.2 No. 950 EN41003 (BABT) 283 g (10 oz) MIL-HDBK-217F 150,000 hours min. 85-264 Vac 120-370 Vdc 47-63 Hz 17 A max. 32 A max. 0.7 mA 1.4 mA 32 A max. 0.5 0.25 0.7 0.4 A A A A rms rms rms rms Switching frequency Approvals and standards (See Notes 9 and 11) Weight MTBF ENVIRONMENTAL SPECIFICATIONS Thermal performance (See Notes 1 and 2) Operating temperature 0 °C to +50 °C Non-operating -40 °C to +85 °C 50 °C to 70 °C ambient, 0.65 W/°C convection cooled Peak (0 °C to +50 °C, 60 s) See table Non-condensing Operating Non-operating 5-500 Hz per MIL-STD-810E 5% to 95% RH 10,000 feet max. 30,000 feet max. 2.4 G rms peak 516.4 Part IV Input fuse UL/IEC127 250 Vac S 3.15 A Relative humidity Altitude Vibration (See Note 5) Shock File Name: nlp65-3300j.pdf Rev (02): 08 Nov 2005 NLP65-3300J LOW POWER AC/DC POWER SUPPLIES OUTPUT VOLTAGE +3.3 V Notes 1 Single output 33 W AC/DC Universal Input Switch Mode Power Supplies 2 For the most current data and application support visit www.artesyn.com/powergroup/products.htm OUTPUT CURRENT RIPPLE MAX 10 A PEAK 13 A (2) (3) TOTAL REGULATION OVP 125%, ±10% MODEL NUMBER (12,13) 50 mV N 8 9 10 ±99 mV NLP65-3300J 2 3 4 5 6 7 When the input voltage is less than 90 Vac the operating temperature range is 0 °C to +40 °C. The ripple and regulation specifications may not be met. Peak output current lasting less than 60 seconds with duty cycle less than 5%. During peak loading, output voltage may exceed total regulation limits. Figure is peak-to-peak for convection power rating. Output noise measurements are made across a 20 MHz bandwidth using a 6 inch twisted pair, terminated with a 10 µF electrolytic capacitor and a 0.1 µF ceramic capacitor. For EMI compliance, the unit must be used in a system application where the earth pads are connected to a metal chassis. Three orthogonal axes, random vibration 10 minutes for each axes, 2.4 G rms 5 Hz to 500 Hz. To maintain stated regulation then: I ≥ 1.0 A For optimum reliability, no part of the heatsink should exceed 120 ºC, and no semiconductor case temperature should exceed 130 ºC. 11 12 13 CAUTION: Allow a minimum of 1 second after disconnecting line power when making thermal measurements. This product is only for inclusion by professional installers within other equipment and must not be operated as a stand alone product. For system EMI compliance, a ground choke may be required before connecting the ground wire to the chassis. It is recommended that, when used, this ground choke be placed as close as possible to the systems ac inlet to eliminate noise pick-up in the system. Require a minimum mounting stand-off of 0.25 inches (6.35 mm) in the end use product. The ‘J’ suffix indicates that these parts are Pb-free (RoHS 6/6) compliant. TSE RoHS 5/6 (non Pb-free) compliant versions may be available on special request, please contact your local sales representative for details. NOTICE: Some models do not support all options. Please contact your local Artesyn representative or use the on-line model number search tool at http://www.artesyn.com/powergroup/products.htm to find a suitable alternative. 12A 11A 10A 9A 8A 7A 6A 5A 4A 3A 2A 1A 0°C 10°C 20°C 30°C 40°C 50°C 60°C 70°C NATURAL CONVECTION COOLING 20CFM FORCED AIR COOLING 50ºC 70ºC File Name: nlp65-3300j.pdf Rev (02): 08 Nov 2005 NLP65-3300J LOW POWER AC/DC POWER SUPPLIES Mechanical Notes A All dimensions are in inches (mm). Single output 33 W AC/DC Universal Input Switch Mode Power Supplies 3 For the most current data and application support visit www.artesyn.com/powergroup/products.htm 5.00 (127.00) 4.550 (115.57) 0.225 (5.715) J1 3N 1L 3.00 (76.20) J2 C19 T1 J3 1 6 2.550 (64.770) Mounting Hole Diameter 0.156 (4.00) ALL DIMENSIONS IN INCHES (mm) MAXIMUM COMPONENT HEIGHT 1.26 (32.00) TOLERANCE: .xxx ± 0.005" .xx ± 0.02" PIN Pin 1 Pin 2 Pin 3 Pin 1 INPUT CONNECTIONS J1 AC Line No Pin AC Neutral J2 Safety Ground OUTPUT PIN CONNECTIONS J3 SINGLE Pin 1 Vout Pin 2 Vout Pin 3 Vout Pin 4 Return Pin 5 Return Pin 6 Return Input and output connectors AC (J1) connector type Molex 26-60-4030 type. Mating connectors AC (J1) mating connector type Molex 09-50-3031 or equivalent with Molex 08-50-0105 or equivalent crimp terminals. DC (J3) mating connector type Molex 09-50-3061 with Triurcon 6838 or equivalent crimp terminals. DC (J3) connector type Molex 26-60-4060 type. International Safety Standard Approvals VDE0805/EN60950/IEC950 File No. 10401-3336-1096 Licence No. 93678 UL1950 File No. E136005 CSA C22.2 No. 950 File No. LR41062C Designed to meet, approval pending Datasheet © Artesyn Technologies® 2005 The information and specifications contained in this datasheet are believed to be correct at time of publication. However, Artesyn Technologies accepts no responsibility for consequences arising from printing errors or inaccuracies. Specifications are subject to change without notice. No rights under any patent accompany the sale of any such product(s) or information contained herein. www.artesyn.com File Name: nlp65-3300j.pdf Rev (02): 08 Nov 2005