SIL06-05SADJ-V

SIL06 Series DC/DC CONVERTERS • • • • • • • • • • Single output 1 NEW Product 6A Non-isolated DC/DC Converters Ultra wide trim range 0.9V to 3.3V/5.0V Current sink capability for termination application Horizontal and vertical-mount options available High power density design means reduced board space requirement Power good output signal (open collector) Operating ambient temperature up to +80ºC with suitable derating and forced air cooling Remote ON/OFF (active high) 0A minimum load Input under-voltage lockout Over-current and short-circuit protection The SIL06 Series is a new high density open frame non-isolated converter for space sensitive applications. Each model has a wide input range (4.5 - 5.5VDC or 10.2 13.8VDC) and offer a wide 0.9 - 5V output voltage range with a 6A load. An external resistor adjusts the output voltage from its pre-set value of 0.9V to any value up to the 5V maximum. Typical efficiencies for the models are 89% for the 5V input version and 91% for the 12V input version. The SIL06 series offers remote ON/OFF and overcurrent protection as standard. With full international safety approval including EN60950 and UL/cUL60950, the SIL06 reduces compliance costs and time to market. All specifications are typical at nominal input, full load at 25°C unless otherwise stated 2 YEAR WARRANTY SPECIFICATIONS OUTPUT SPECIFICATIONS Voltage adjustability (See Note 7) 5V input models 12V input models 0.9V to 3.3V 0.9V to 5.0V ±2.5% ±0.2% max. INPUT SPECIFICATIONS Contd. Turn ON threshold Turn OFF threshold 5Vin model 12Vin model 5Vin model 12Vin model 4.5V 9.0V 4.3V 7.5V Output setpoint accuracy With 1.0% trim resistors Line regulation Load regulation Min./max. load Overshoot (at turn on) Undershoot Ripple and noise Transient response (See Note 1) 5Hz to 20MHz (See Note 2) Deviation 5V input models 12V input models Low line to high line Full load to min. load GENERAL SPECIFICATIONS ±0.5% max. Efficiency 0A/6A Switching frequency 3.0% max. 1.0% max. 100mV max. See table Approvals and standards (See Note 4) Material flammability Weight MTBF Representative model: Fixed 200kHz TÜV Product Service IEC60950, UL/cUL60950 UL94V-0 9.3g (0.3oz) MIL-HDBK-217F 1,307,257 hours 12V model @ 40ºC 100% load, ground benign Bellcore 332 7, 562,142 hours See table 75mV 150µs recovery to within regulation band INPUT SPECIFICATIONS Input voltage range Input current Input current (max.) (See Note 9) Input reflected ripple (See Note 2) Remote ON/OFF Logic compatibility ON OFF Start-up time (See Note 3) Power up Remote ON/OFF 5V input model 12V input model No load Remote OFF 5V input model 12V input model 5V input model 12V input model 4.5 to 5.5VDC 10.2 to 13.8VDC 50mA 5mA 5.1A @ Io max. 1.6A @ Io max. 52mA (pk-pk) 56mA (pk-pk) Active high >2.4VDC