3282

CAT IV 600V 3282 (1000A AC, ø46mm max.) 3281 (600 A AC, ø33mm max.) DIGITAL CLAMP ON HiTESTER Field measuring instruments Easy to lamp! c Multi on! functi n-fuse No e! typ Beats distorted waveform Current waveform of the inverter (primary side) RMS True NORMAL A MEAN value method 3261 APS The MEAN value is HOLD AUTO MON 40% lower than the true RMS 0 1 2 3 RMS A True RMS method 3281/3282 Value Peak HOLD APS AUTO PEAK Peak value B 0 1 2 3 A Peak value factor Crest HOLD MON APS AUTO C.F. CAT IV 600V ADJ B 0 1 2 3 Crest factor 3281 = Peak value/ RMS value = 18.99 A/6.35 A = 2.99 http://www.hioki.co.jp/ HIOKI company overview, new products, environmental considerations and other information are available on our website. Actual-size Designed for ease of use on the site ! The HAND STRAP fits the device neatly to the hand The HAND STRAP not only prevents the device from being dropped when working, but also effectively imparts strength when parting crowded wiring to clamp. Prevents careless mistakes qAuto-power off to conserve battery life qNon-fuse type protects up to 600V AC NOT The photograph is 3281. SE FU NEEDED ! WARNING Inspect the unit and check that it is operating correctly before use. When carrying out measurement on live lines, wear proper protective gear, insulating rubber gloves, insulating rubber boots and safety helmet, and use extreme caution to avoid electric shock accidents. ! Even if voltage is mistakenly applied to the resistance range, the internal excessive voltage protection element ( PTC thermister) protects the circuits for up to 600 V AC. (optional) 9462 THERMISTER TEMPERATURE PROBE q Measuring range:-50 to 150˚C/-58 to 302˚Fq Measuring accuracy: -50 to 50 ˚C±3˚C/50 to 100˚C±4˚C/100 to 150˚C±5˚C Note: the temperature accuracy given above is only the accuracy for the temperature probe. ±2%rdg.±2˚C(˚F) is added for the actual accuracy of the 3281/3282 themselves. Cord length approx 1.2 m DANGER 1. In order to prevent short-circuits and injury, use the clamp product on electrical circuits with a voltage less than the maximum operation circuit voltage. 2. In order to prevent short-circuits and injury when the clamp core tip is open, do not use bare conductors. s Specifications Function Mode Range 30.00 RMS Effective value [ ] in the Specification :3281 23˚C±5˚C, 80% or less. Accuracy Maximum permissible input 300.0 1000 [600] 30.0 ±1.0%rdg.±0.7%f.s. (40 to 1 kHz) 600A rms continuous 1700A max. ±1.0%rdg.±5dgt.*1 (45 to 66 Hz) ±1.0%rdg.±5dgt.*1(45 to 66 Hz) 1000A rms 5 minutes [600A rms continuous [±1.0%rdg.±5dgt.*1(45 to 66 Hz)] 1000A max.] ±5.0%rdg.±5dgt. ±3.0%rdg.±5dgt. ±3.0%rdg.±5dgt. [±3.0%rdg.±5dgt.] 600A rms continuous 1700A max. 1000A rms 5 minutes [600A rms continuous 1000A max.] 600V rms continuous 1000V max. Effective in the voltage and current functions Overload protection : 600V rms Open terminal voltage: 3.0V DC max. (resistance,continuity functions) AC current A PEAK Peak value 300 1000 [600] AC voltage V RMS 300.0/600 ±1.0%rdg.±3dgt.*2(45 to 66 Hz) PEAK 300/600 1.00 to 5.00 100.0 1000 1k/10.00k -50 to 150˚C -58 to 302˚F 1kΩ ±3.0%rdg.±5dgt. ±10.0%rdg.±5dgt. ±0.3%rdg.±1dgt. (30 to 99.9 Hz) ±1.0%rdg.±1dgt. (95 to 1000 Hz) ±1.5%rdg.±5dgt. ±2.0%rdg.±2dgt. Add the accuracy of the 9462 Buzzer sounds at 30 Ω ± 5 Ω or less Crest factor Frequency Hz Resistance Ω Temperature probe sold separately ˚C ˚F continuity Display LCD, digital (3000 counts, 999 counts (peak)), bar graph (35 segments) *1. 40 to 45Hz , 66 to 1kHz ±1.5%rdg.±5dgt. *2. 40 to 45Hz , 66 to 1kHz ±1.5%rdg.±3dgt. Measurement accuracy applies to input of at least 10% of the current, voltage and resistance range. qMeasurable conductor diameter: 3282 ; ø46mm max. 3281 ; ø33mm max. qOperatable locations: up to 2000 m above sea level qOperatable temperature and humidity range: 0˚C to 40˚C, 80%rh or lower qAuxiliary functions: recording (for V, A, Hz measurements displays maximum value (MAX), minimum value (MIN), and average value (AVE)), data hold (holds display), auto power off (approx. 10 minutes, buzzer sounds just before power is turned off, can be extended or cancelled) q Display refresh rate: digital display FAST; approx. 4 times/second, NORMAL; approx. 2 times/second , SLOW; 1 time/ 3 seconds, bar graph display approx. 4 times/second q Frequency characteristic: 4 0Hz to 1kHz q Effect of conductor position: At any position based on the center of the core 3281 ; within ±4.0%, 3282 ; within ±1.0% q Effect of external magnetic field: In an external magnetic field of 400 A AC/m 3281 ; 1.5A max. 3282 ; 0.2A max.qCircuit dynamic: when performing full-scale input to the range 2.5 or less (600 A [3282 is 1000 A], 600 V range is 1.7 or less)qMaximum useable circuit voltage: 6 00 V rms (insulated conductor) q Standards applying: Safety E N61010-1:2001 Pollution degree 2 over voltage category IV (predicted transitory excess voltage 8000 V), EN61010-2-031:2002, EN61010-2-032:1995 EMC EN61326:1997 +A1:1998+A2:2001 qVoltage resistance: case-input terminal, between clamp cores 6.68 kV AC for 15 seconds q Power supply: Layered magnesium battery (6F22) ✕1, 45 hours or less (continuous use) q Dimensions /mass: 3281 ; Approx 62W ✕ 218H ✕ 39Dmm,350g 3282 ; Approx. 62W ✕ 2 30H ✕39Dmm, 400 g Accessories 3281 DIGITAL CLAMP ON HiTESTER 3282 DIGITAL CLAMP ON HiTESTER (All include 9207-10 TEST LEAD, 9399 CARRYING CASE and HAND STRAP ) Lead length approx. 70 cm CAT IV 600V Option 9462 THERMISTER TEMPERATURE PROBE 9207-10 TEST LEAD DISTRIBUTED BY 9399 CARRYING CASE HEAD OFFICE : 81 Koizumi, Ueda, Nagano, 386-1192, Japan TEL +81-268-28-0562 / FAX +81-268-28-0568 E-mail: os-com@ hioki.co.jp HIOKI USA CORPORATION : 6 Corporate Drive, Cranbury, NJ 08512 USA TEL +1-609-409-9109 / FAX +1-609-409-9108 E-mail: hioki@ hiokiusa.com Shanghai Representative Office : 1704 Shanghai Times Square Office 93 Huaihai Zhong Road Shanghai, 200021, P.R.China TEL +86-21-6391-0090, 0092 FAX +86-21-6391-0360 E-mail: info@hioki.cn All information correct as of Dec.17, 2004. All specifications are subject to change without notice. 3281E5-4ZM-02U Printed in Japan