ATH06T033-9SJ

6Amps ATH06 Total Power: Input Voltages: No. of Outputs: 33W 3.3V, 5V, 12V Single Electrical Specs Input Input Range 3.0 - 3.6V 4.5 - 5.5V 10.8 - 13.2V Under Voltage Lockout with hysterisis Efficiency up to 95% Output Overall Regulation Noise/Ripple Remote sense Transient Response 1% of Vo Typ 30mV Typ (2.5Vo and below) 1% Vo Typ (Vo > 2.5V) Up to 300mV max 100mV typical for 3.3Vo for 50% to 100% IO,MAX step change 70us recovery time (Co = 330uF) 160% IO,MAX typical (autorecovery) Special Features • • • • • • • • • Point-of-Load Alliance product Open frame TH or SMT termination Auto-Track™ Sequencing Output Voltage Adjust (Resistor Programming) Under Voltage Lockout Pre-Biased start-up2 Output On/Off Inhibit -40°C to +85°C Ambient Air Operation Non Isolated module Over Current Protection Control Inhibit On/Off Negative Logic (OPEN = Normal Operation) (GROUND = Function Active) See output range on page 2 ±5% VO,NOM (See Note 5) Output Voltage Adjust Output Margin Output Auto-Track™ Environmental Ambient air operating temperature range: -40°C to +85°C Storage temperature: -40°C to +125°C Demonstrated MTBF: 3.7M Hrs Specifications subject to change without notice Safety UL, cUL 60950 Recognition EN 60950 through TUV or VDE (Pending) 2 North America (USA): 1-888-41-ASTEC Europe (UK): 44 (1384) 842-211Asia (HK): 852-2437-9662 AMERICAS 5810 Van Allen Way Carlsbad, CA 92008 Telephone: 760-930-4600 Facsimile: 760-930-0698 EUROPE Astec House, Waterfront Business Park Merry Hill, Dudley West Midlands, DY5 1LX, UK Telephone: 44 (1384) 842-211 Facsimile: 44 (1384) 843-355 ASIA Units 2111-2116, Level 21 Tower1, Metroplaza 223, Hing Fong Road Fwai Fong, New Territories Hong Kong Telephone: 852-2437-9662 Facsimile: 852-2402-4426 Ordering Information Input Voltage 3.0V to 3.6V 4.5V to 5.5V 10.8V to 13.2V Output Voltage 0.8V to 2.5V 0.8V to 3.6V 1.2V to 5.5V Output3 Current 6A 6A 6A Efficiency4 Model Number 94% 95% 93% ATH06T033- 9(S)(J) ATH06T05 - 9(S)(J) ATH06K12 - 9(S)(J) OPTIONS: “-9J” - Output Trim, TH termination, Tray Packaging “-9SJ” - Output Trim, SMT termination, Tray Packaging “-9S” - Output Trim, SMT Ternination, T&R packaging Pin Assignments Single Output GND Track Vin Inhibit Vo Adjust Vout : : : : : : PINS 1 2 3 4 5 6 Notes: 1. Nominal values apply with sense pins connected to +Vout and Ground Return with other control pins unconnected. 2. Pre-Bias startup capability exists for 3.3Vin and 5Vin devices. 3. Output derating applies at elevated ambient temperature. 4. Typical efficiency taken at 4A load, 2.5V output (3.3Vin device); 4A load, 3.3V output (5Vin device); 5A load, 5V output (12Vin device). 5. Consult the technical reference notes when available. 6. Mechanical Dimensions are nominal values. 7. Auto-Track™ is a trademark of Texas Instruments. 8. Specification subject to change without notice. Astec reserves the right to make changes to the information contained herein without notice and assumes no liability as a result of its use or application. (REV02: OCTOBER 21, 2004) Through-hole and SMT Outline [in (mm)] www.astecpower.com 3