AT91SO101

Features General • High-performance, Low-power 32-bit ARM®-SC100™ Enhanced RISC Architecture • Von Neumann Load / Store Architecture • • • • • – single 32-bit Data Bus for Instructions and Data Memory Protection unit Internal Oscillator (VFO) (up to 50 MHz) ESD Protection to ± 2000V (± 6000V on the ISO interfaces) Operating Ranges: 3.3V (+/- 10%) Compliant with EMV Level 1, VISA PED, APACS, ZKA, Common Criteria (EAL4+), FINREAD Memory • 256 bits of Key Storage (battery backup) • 32K Bytes of internal ROM Memory (Bootstrap & Crypto library) • 256K Bytes of Internal EEPROM, Including 128 OTP Bytes and 384-byte Bitaddressable Bytes – 1 to 128-byte Program/Erase – 2 ms Program, 2 ms Erase – Endurance: 100,000 Write/Erase Cycles at temperature of 25 degrees C – 10 Years Data Retention • 100K Bytes of Internal RAM (4KB Crypto RAM) • up to 16M Bytes of External Memory (AT91SO100/101 only) Secure Microcontroller for Electronic Transaction Terminal / Reader AT91SO100/101 AT91SO50/51 AT91SO25 Summary Peripherals • Page Unit to access External Memory Page (AT91SO100/101 only) • Static Memory Controller (AT91SO100/101 only) • Two ISO 7816 controllers with DC/DC (one of them can be multiplexed to address 4 • • • • • • • • • • • • • • • SAM). The DC/DC converter AT83C26 is not included in the versions AT91SO100, AT91SO50 and AT91SO25. But the two ISO 7816 controllers are still available USB 2.0 Full Speed (8 endpoints) SPI Controller (up to 6Mbps) and Two Wire Interface Two Universal Synchronous/Asynchronous Receiver Transmitters (USART) Triple Track Magstripe Logical Interface 5 8-bit I/O Port Interface (LEDs, Keyboard, LCD, spare...) Real Time Clock (RTC) with Alarm interrupt System Timer including a 16-bit Counter, Watchdog and Second Counter Six-channel 16-bit Timer/counter 2-level, 28-interrupt Controller Hardware DES and Triple DES DPA Resistant Hardware AES 128-192-256 Hardware SHA-1, SHA-256 True Random Number Generator (RNG) Two CRC 16 Engines and one CRC 32 Engine (Compliant with ISO/IEC 3309) AdvX - Advanced crypto multiplier for cryptography and authentication (including RSA, DSA, Key Generation, ECC) Security • • • • • • • Dedicated Hardware for Protection Against SPA/DPA Attacks Advanced Protection Against Physical Attack, Including Active Shield Intrusion sensors (mesh and switches). Environmental Protection Systems (Voltage, Frequency, UV andTemperature) Secure Memory Management/Access Protection (MPU) Real time clock and battery back up Compliant with EMV standard, VISA PED and FINREAD 6514BS–SPD–10 May 07 Note: This is a summary document. A complete document will be available under NDA. For more information, please contact your local Atmel sales office. Description The AT91SO100/101, AT91SO50/51 and the AT91SO25 are a low-power, high-performance, SC100 32-bit microcontroller based on the ARM® enhanced RISC architecture. This new SC100 core allows the linear addressing of up to 1M bytes of code and data as well as a number of new functional and security features. A 3-level instruction pipeline allows the performance of one instruction in a single clock cycle, the SC100 achieves throughputs close to 1 MIPS per MHz. The SC100 processor employs a unique architectural strategy known as Thumb® a super reduced instruction set that is ideally suited for high volume applications with memory restrictions and applications where code density is an important factor. The AT91SO100/101, AT91SO50/51 and the AT91SO25 have internal EEPROM that can be used as program or data memory. It also includes a ROM (for the bootstrap and crypto library and some native functions) and a large SRAM. The AT91SO100/101 can also address up to 16Mbytes of external memory. The AT91SO100/101, AT91SO50/51 and the AT91SO25 also comprises of strong security mechanisms and has a impressive set of crytography features , hardware DES/TDES, hardware AES, hardware SHA-n, hardware cryptography accelerator for asymmetric algorithms (RSA, Elliptic Curve, Key generation) and a true random number generator. The AT91SO100/101, AT91SO50/51 and the AT91SO25 includes a lot of dedicated peripherals as ISO 7816 controller and mag- netic stripe card interface, as well as USB, SPI, TWI, USARTs and I/O ports. The AT91SO101 is a single package solution in BGA256 embedding two chips, the secure controller and the AT83C26 which physically interface with up to 2 smart cards and 3 secure access module, or 1 smart card and 4 secure access module. The AT91SO100 is available using the same package (BGA256) pin to pin compatible with the AT91SO101 but without the AT83C26. The AT91SO51 is a single package solution in BGA208 (cost effective solution) embedding two chips, the secure controller and the AT83C26 which physically interface with up to 2 smart cards and 3 secure access module, or 1 smart card and 4 secure access module. The external bus is not connected on this product. The AT91SO50 is available using the same package (BGA208) pin to pin compatible with the AT91SO51 but without the AT83C26. The external bus is not connected on this product. The AT91SO25 is a single package solution in BGA144 (low cost solution) embedding one chip, the secure controller only. The external bus is also not connected on this product. 2 AT91SO100 6514BS–SPD–10 May 07 AT91SO100 Figure 1. Block Diagram (Secure controller) Intrusion Switch Sensors CP15 (MPU) 256 bit User Key Security Intrusion Mesh Sensors Page Unit A0 - A23 D0 - D15 CS0 - CS3 nrd nwe_nwe0 nbs1_nwe1 ext_nwait DPRAM SCK MOSI MISO NSS 24 16 4 ARM SC100 USB Clock Management 48 MHz 6 Mhz SMC ROM 32 KB EEPROM 256 KB RAM 96 KB Crypto RAM 4KB Interrupt Controller System Timers Power Management 32KHz from RTC VBat Vcc SPI USB Device USART0 RTC 32.768 Khz USB + USB - 8 bits PortA USART1 IO, CLK, VCC, RST, C4, C8, Card_Pres IO, CLK, VCC, RST IO, CLK, VCC, RST IO, CLK, VCC, RST IO, CLK, VCC, RST Smart Card interface 0 ADVX Crypto Coprocessor RSA, ECC 8 bits PortB 8 bits PortC Smart Card Interface 1 RNG 16 bit Timer/Counter TC0 TC1 Channel0 Channel0 MAGSTRIPE AES SHA Channel1 Channel1 Channel2 Channel2 BRIDGE 8 bits PortE DES / TDES 8 bits PortD CRC 16/32 3 6514BS–SPD–10 May 07 Figure 2. BGA256 (AT91SO100/101) All dimensions are in mm 4 AT91SO100 6514BS–SPD–10 May 07 AT91SO100 Figure 3. BGA208 (AT91SO50/51) 5 6514BS–SPD–10 May 07 Figure 4. BGA144 (AT91SO25) 6 AT91SO100 6514BS–SPD–10 May 07 A tmel Corporation 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 487-2600 Atmel Operations Memory 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 RF/Automotive Theresienstrasse 2 Postfach 3535 74025 Heilbronn, Germany Tel: (49) 71-31-67-0 Fax: (49) 71-31-67-2340 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Regional Headquarters Europe Atmel Sarl Route des Arsenaux 41 Case Postale 80 CH-1705 Fribourg Switzerland Tel: (41) 26-426-5555 Fax: (41) 26-426-5500 Microcontrollers 2325 Orchard Parkway San Jose, CA 95131, USA Tel: 1(408) 441-0311 Fax: 1(408) 436-4314 La Chantrerie BP 70602 44306 Nantes Cedex 3, France Tel: (33) 2-40-18-18-18 Fax: (33) 2-40-18-19-60 Biometrics/Imaging/Hi-Rel MPU/ High Speed Converters/RF Datacom Avenue de Rochepleine BP 123 38521 Saint-Egreve Cedex, France Tel: (33) 4-76-58-30-00 Fax: (33) 4-76-58-34-80 Asia Room 1219 Chinachem Golden Plaza 77 Mody Road Tsimshatsui East Kowloon Hong Kong Tel: (852) 2721-9778 Fax: (852) 2722-1369 ASIC/ASSP/Secure Products Zone Industrielle 13106 Rousset Cedex, France Tel: (33) 4-42-53-60-00 Fax: (33) 4-42-53-60-01 1150 East Cheyenne Mtn. Blvd. Colorado Springs, CO 80906, USA Tel: 1(719) 576-3300 Fax: 1(719) 540-1759 Scottish Enterprise Technology Park Maxwell Building East Kilbride G75 0QR, Scotland Tel: (44) 1355-803-000 Fax: (44) 1355-242-743 Japan 9F, Tonetsu Shinkawa Bldg. 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan Tel: (81) 3-3523-3551 Fax: (81) 3-3523-7581 Literature Requests www.atmel.com/literature Disclaimer: T he information in this document is provided in connection with Atmel products. No license, express or implied, by estoppel or otherwise, to any intellectual property right is granted by this document or in connection with the sale of Atmel products. EXCEPT AS SET FORTH IN ATMEL’S TERMS AND CONDITIONS OF SALE LOCATED ON ATMEL’S WEB SITE, ATMEL ASSUMES NO LIABILITY WHATSOEVER AND DISCLAIMS ANY EXPRESS, IMPLIED OR STATUTORY WARRANTY RELATING TO ITS PRODUCTS INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTY OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR NON-INFRINGEMENT. IN NO EVENT SHALL ATMEL BE LIABLE FOR ANY DIRECT, INDIRECT, CONSEQUENTIAL, PUNITIVE, SPECIAL OR INCIDENTAL DAMAGES (INCLUDING, WITHOUT LIMITATION, DAMAGES FOR LOSS OF PROFITS, BUSINESS INTERRUPTION, OR LOSS OF INFORMATION) ARISING OUT OF THE USE OR INABILITY TO USE THIS DOCUMENT, EVEN IF ATMEL HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. Atmel makes no representations or warranties with respect to the accuracy or completeness of the contents of this document and reserves the right to make changes to specifications and product descriptions at any time without notice. Atmel does not make any commitment to update the information contained herein. Atmel’s products are not intended, authorized, or warranted for use as components in applications intended to support or sustain life. © Atmel Corporation 2007. A ll rights reserved. A tmel®, logo and combinations thereof, Everywhere You Are ® a nd others, are registered trademarks or trademarks of Atmel Corporation or its subsidiaries. Other terms and product names may be trademarks of others. 6514BS–SPD–10 May 07