SRM356VF

Semiconductor SRM-356VF Receiver Module Features • Photo detector and preamplifier in one package • Enhanced immunity against all kinds of disturbance light • High performance photo diode and built-in I.C • High speed response and output • Low power consumption and easy use • Light detecting portion of remote control • TVs, VCRs, Audio equipments, CATV Set Top boxes, Multi-media equipments Application Outline Dimensions unit : mm PIN Connections 1.Output 2.Vcc(+5V) 3.Gnd KMM-1011-000 1 SRM-356VF Absolute maximum ratings Characteristic Supply Voltage Power Dissipation Operating Temperature Storage Temperature * Soldering Temperature 1 Symbol VCC PD Topr Tstg Tsol Ratings 6.0 0.27 -10 ~ 60 -20 ~ 75 260 ℃ within 5 seconds Unit V W ℃ ℃ *1.Keep the distance more than 2.0mm from PCB to the bottom of package Electrical Characteristics Parameter Supply Voltage Current Consumption Resonance Frequency Peak sensitivity wavelength H level output voltage L level output voltage H level pules width L level pules width Arrival distance (Ta=25°C) Symbol Vcc ICC fC λP VOH VOL Twh Twl Test Condition #1 - Min. 4.5 0.3 4.5 Typ. 5.0 38 980 5.0 0.2 20 15 10 Max. 5.5 1.5 0.4 700 700 - Unit V mA KHz nm V V us us m #2 500 500 ±0 ˚ - L #2,3,4 ± 30 ˚ ± 45 ˚ Output form Active low KMM-1011-000 2 Characteristic Diagrams Fig. 1 Relative Spectral Sensitivity - Wavelength SRM-356VF Fig. 2 drel-Relative Transmission Distance Directivity tsop S(λ ) - Relative Spectral Sensitivity Fig. 3 System Gain - Frequency Supply Voltage Vcc[V] Input Current [A] Wavelength [nm] drel-Relative Transmission Distance Directivity tsop System Gain [dB] Frequency [Hz] KMM-1011-000 3 # 1. No input signal. SRM-356VF # 2. The burst wave forms shown below in the Fig 1. Shall be transmitted by the standard transmitter. Transmitter Output Waveform Receiver Module Output Waveform Fig 1. Transmitter & Receiver wave forms # 3. The test condition of arrival distance. #4. The arrival distance is measured in the darkness without disturbing noises. KMM-1011-000 4 SRM-356VF Reliability Test Test items High temp & High humid Heat cycle Fall test Test condition Ta=40℃, RH=90%, t=96Hr’s #2, 3 #4 Remarks #1, 2 - #1. Supply voltage 5V at the load test. #2. Electro-optical characteristics shall be satisfied after 2hr’s at normal temperature. #3. Heat cycle test as below Fig2. For 20 cycles under no load. Fig 2. Heat cycle test #4. Fall test The test devices to fall three time onto hard wooden board from a level 75 ㎝ The others In case of noisy power supply, please serially insert about 47Ω resistance an about 47 ㎌ electrolytic capacitance in line as follows. Remocon Preamp KMM-1011-000 5