12103D226KAT2A

X5R Dielectric General Specifications GENERAL DESCRIPTION • General Purpose Dielectric for Ceramic Capacitors • EIA Class IIDielectric • Temperature variation of capacitance is within ±15% from -55°C to +85°C • Well suited for decoupling and filtering applications • Available in High Capacitance values (up to 100µF) PART NUMBER (see page 2 for complete part number explanation) 1210 4 D 107 M A T 2 A Size (L" xW") 0101** 0201 0402 0603 0805 1206 1210 1812 Voltage 4 =4V 6 =6.3V Z =10V Y= 16V 3 =25V D =35V 5 =50V 1 =100V Dielectric D =X5R Capacitance Code (In pF) 2 Sig. Digits + Number ofZeros Capacitance Tolerance K =±10% M =±20% Failure Rate A = N/A Terminations T = PlatedNi andSn Packaging 2=7"Reel 4 = 13"Reel U = 4mm TR (01005) Special Code A = Std. **EIA 01005 NOTE: Contact factory for availability of Tolerance Options for Specific PartNumbers. Contact factory for non-specified capacitancevalues. TYPICAL ELECTRICAL CHARACTERISTICS Insulation Resistance vs Temperature Temperature Coefficient 10,000 20 % � Capacitance 10 1,000 5 0 -5 -10 -15 -20 -60 -40 -20 0 +20 +40 Temperature °C 26 Insulation Resistance (OhmFarads) 15 +60 +80 100 0 0 20 40 60 80 100 120 Temperature °C 100917 X5R Dielectric Specifications and Test Methods Parameter/Test Operating Temperature Range Capacitance Dissipation Factor Insulation Resistance Dielectric Strength Resistance to Flexure Stresses Appearance Capacitance Variation Dissipation Factor Insulation Resistance Solderability Resistance to Solder Heat Thermal Shock Load Life Load Humidity 100917 Appearance Capacitance Variation Dissipation Factor Insulation Resistance Dielectric Strength Appearance Capacitance Variation Dissipation Factor Insulation Resistance Dielectric Strength Appearance Capacitance Variation Dissipation Factor Insulation Resistance Dielectric Strength Appearance Capacitance Variation Dissipation Factor Insulation Resistance Dielectric Strength X5R Specification Limits -55ºC to +85ºC Within specified tolerance ≤ 2.5% for ≥ 50V DC rating ≤ 12.5% for 25V, 35V DC rating ≤ 12.5% Max. for 16V DC rating and lower Contact Factory for DF by PN 10,000MΩ or 500MΩ - µF, whichever is less No breakdown or visual defects No defects ≤ ±12% Measuring Conditions Temperature Cycle Chamber Freq.: 1.0 kHz ± 10% Voltage: 1.0Vrms ± .2V For Cap > 10 µF, 0.5Vrms @ 120Hz Charge device with rated voltage for 120 ± 5 secs @ room temp/humidity Charge device with 250% of rated voltage for 1-5 seconds, w/charge and discharge current limited to 50 mA(max) Deflection: 2mm Test Time: 30 seconds Meets Initial Values (As Above) ≥ Initial Value x 0.3 ≥ 95% of each terminal should be covered with fresh solder No defects,