AZ8463S-12

AZ8463 MICROMINIATURE POLARIZED RELAY FEATURES • Microminiature size: up to 50% less board area than previous generation telecom relays • High dielectric and surge voltage: 2.5 KV surge (per Bellcore TA–NWT–001089) 1.5 KV surge (per FCC Part 68) 1,000 Vrms, open contacts • Monostable and bistable (latching) versions available • Low power consumption: 79 mW pickup • Stable contact resistance for low level signal switching • Epoxy sealed for automatic wave soldering and cleaning • UL, CUR file E43203 SMT Version - UL Pending • All plastics meet UL94 V–0, 30 min. oxygen index GENERAL DATA Life Expectancy Mechanical Electrical Operate Time (max) Release Time (max) Dielectric Strength Minimum operations 1 x 108 at 3Hz 1 x 105 at 0.5 A, 125 VAC, Res. 1 x 105 at 2.0 A, 30 VDC, Res. 4 ms at nominal coil voltage 4 ms at nominal coil voltage (with no coil suppression) See table CONTACTS Arrangement Ratings DPDT (2 Form C) Bifurcated crossbar contacts Resistive load: Max. switched power: 60 W or 62.5 VA Max. switched current: 2.0 A Max. switched voltage: 220 VDC or 250 VAC Rated Load UL/CUR pending Material Resistance 0.5 A at 125 VAC 2.0 A at 30 VDC Silver alloy, gold plated < 75 milliohms initially at 6 V, 1 A (at sea level) Dropout Insulation Resistance Ambient Temperature Operating Storage Vibration Shock Max. Solder Temp. 260°C (500°F) for 5 seconds Max. Solvent Temp. Max. Immersion Time 80°C (176°F) 30 seconds 2 grams P.B.T. polyester Tinned copper alloy, P.C. Greater than 10% of nominal coil voltage 109 ohms min. at 25°C, 500 VDC, 50% RH At nominal coil voltage -40°C (-40°F) to 85°C (185°F) -40°C (-40°F) to 115°C (239°F) Operational, 3.3 mm DA, 10–55 Hz Non-destructive, 5.5 mm DA, 10–55 Hz Operational, 75 g min., 11 ms Non-destructive, 100 g min., 11 ms COIL (Polarized) Power At Pickup Voltage (typical) Max. Continuous Dissipation Temperature Rise 79 mW Weight Enclosure Terminals 0.32 W at 20°C (68°F) At nominal coil voltage 30° (54° F) max NOTES 1. All values at 20°C (68°F). 2. Relay may pull in with less than “Must Operate” value. 3. Relay has fixed coil polarity. 4. Specifications subject to change without notice. Temperature Max. 115°C (239°F) 10-/31/08W AZ8463 RELAY ORDERING DATA STANDARD VERSION Nominal Coil VDC 3 4.5 5 6 9 12 24 Nominal Coil VDC 3 4.5 5 6 9 12 24 Must Operate VDC 2.25 3.38 3.75 4.50 6.75 9.00 18.00 Set Voltage 2.25 3.38 3.75 4.50 6.75 9.00 18.00 Max. Continuous VDC 4.5 6.7 7.5 9.0 13.5 18.0 36.0 Max. Continuous VDC 4.5 6.7 7.5 9.0 13.5 18.0 36.0 Coil Resistance ± 10% 64.3 145 178 257 579 1028 2880 Coil Resistance ± 10% 90 203 250 360 810 1440 3840 ORDER NUMBER ORDER NUMBER THT AZ8463–3 AZ8463–4.5 AZ8463–5 AZ8463–6 AZ8463–9 AZ8463–12 AZ8463–24 SMT* AZ8463S–3 AZ8463S–4.5 AZ8463S–5 AZ8463S–6 AZ8463S–9 AZ8463S–12 AZ8463S–24 SINGLE COIL LATCHING VERSION ORDER NUMBER ORDER NUMBER THT AZ8463P1–3 AZ8463P1–4.5 AZ8463P1–5 AZ8463P–-6 AZ8463P1–9 AZ8463P1–12 AZ8463P1–24 SMT* AZ8463P1S–3 AZ8463P1S–4.5 AZ8463P1S–5 AZ8463P1S–-6 AZ8463P1S–9 AZ8463P1S–12 AZ8463P1S–24 *Add “1” after S for SA SMT version. INITIAL DIELECTRIC STRENGTH (minimum) VRMS, 1 min. 1,000 1,000 1,500 Peak (V) 1,500 1,500 2,500 SURGE Rise Time (µS) 10 2 2 Decay Time* (9µS) (1/2 peak) 160 160 10 Between open contacts Between contact sets Between coil and contacts * Decay time measured from beginning of surge. 10/31/08W AZ8463 Mechanical Data Outline Dimensions 0.591MAX [15.00] 0.295MAX [7.50] 0.591MAX [15.00] Wiring Diagram SA 0.295MAX [7.50] 0.370MAX [9.40] 0.386MAX [9.80] 0.014 [0.35] 0.394 [10.0] + 1 3 4 5 0.138 [3.50] 0.047 [1.20] 0.020 [0.50] 0.010 [0.25] 0.020 [0.50] 0.014 [0.35] 0.010 [0.25] Index mark 12 10 9 8 0.047 [1.20] 0.200 [5.08] 0.100 [2.54] 0.200 [5.08] 0.370 [9.40] SINGLE SIDE STABLE 0.200 [5.08] 0.100 [2.54] SL 0.598MAX [15.20] 0.200 [5.08] 0.295MAX [7.50] + 1 SR 3 4 5 S = SET R = RESET 0.386MAX [9.80] 0.014 [0.35] 0.457 [11.6] Index mark 0.010 [0.25] + 10 9 12 8 1 COIL LATCHING 0.047 [1.20] 0.200 [5.08] 0.100 [2.54] 0.020 [0.50] 0.200 [5.08] 0.370 [9.40] PC Board Layout Viewed toward terminals SL .039 [1.0] .012 [0.3] SA .039 [1.0] .124 [3.16] .285 [7.24] .063 [1.6] 0.200 [5.08] 0.100 [2.54] .124 [3.16] 0.200 [5.08] 8-Ø0.039 [Ø1.00] .285 [7.24] SINGLE SIDE STABLE & 1 COIL LATCHING .200 [5.08] .100 [2.54] 0.591 [15.0] .200 [5.08] .100 [2.54] Temporary glue Pad Soldering Pad Maximum Switching Capacity 2.0 Cont. Current 1.0 0.5 AC RESISTIVE LOAD 0.3 DC RESISTIVE LOAD 0.1 0 30 100 200 Contact Voltage 10/31/08W