AR30N60PPA-13

AR30N60 ACTIVE/SYNCHRONOUS RECTIFIER Description Pin Assignments The AR30N60 is a high-performance Active/Synchronous Rectifier used for secondary-side synchronous rectification with the output voltage at less than 10V. (Top View) By integrating MOSFET and controller, the AR30N60 emulates the characteristics of a near-ideal diode rectifier. The combination not only reduces the energy consumption of the secondary-side synchronous rectifier, it also improves the power dissipation of the sub-system on the primary side. The SYNC feature allows the embedded MOSFET of the AR30N60 to immediately turn OFF as soon as the primary-side switch turns ON, preventing the unfavorable reverse condition of the synchronous rectifier. The AR30N60 is ideally suited for AC/DC power converters implemented in either the flyback or the LLC-resonant topology. For the ease of use, the design of AR30N60 is flexible enough to facilitate operation in one of the following modes: Discontinuous Conduction (DCM), Continuous Conduction (CCM), Quasi Resonant (QR). To further improve conversion efficiency and to ensure system integrity, AR30N60 integrates many innovative features. These include: light-load detection to reduce standby power consumption, TON and TOFF/EN pins to prevent run-away ON-time due to the open-circuit or short-circuit fault conditions, SFB pin to provide overtemperature protection, low RDSON of the embedded MOSFET, and wide output voltage (VCC) range. TON 1 22 TOFF/EN 2 21 GND SFB 3 20 NC 4 19 SYNC VS 5 18 NC VS 6 17 VD VS 7 VS 8 VS 9 14 VD VS 10 13 VD VS 11 12 VD GND VCC NC 16 VD VD 15 VD DFN6040-22 Applications  AC/DC Battery Charger  USB Type-C Charger  Flyback Conversion  PC Power Supply  Switched-Mode Power Supply (SMPS) The small footprint of the DFN6040-22 package makes it ideally suited for space constrained applications. Features  Secondary-side synchronous rectification  Low turn-OFF threshold at -4mV  -40°C to +150°C temperature range  Supports both DCM, CCM, and QR (Quasi-Resonant)  Built-in over-temperature protection (OTP) and Undervoltage Lock-Out (UVLO) to ensure system reliability  Light-load detection to reduce the standby power consumption  Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2)  Halogen and Antimony Free. “Green” Device (Note 3) Notes: 1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS) & 2011/65/EU (RoHS 2) compliant. 2. See http://www.diodes.com/quality/lead_free.html for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green" and Lead-free. 3. Halogen- and Antimony-free "Green” products are defined as those which contain