FRC280001

ADVANCED INFORMATION FR Series Voltage Controlled Crystal Oscillator (VCXO) Legacy ST1307 Series 7.0 x 5.0mm FR 3.3V CMOS Ultra Low Jitter VCXO Package: Recommended Land Pattern: 7.0 x 5.0mm Ceramic SMD Product Features • 1 - 32MHz Frequency Range • Cost-effective design Pin Functions: • Commercial and industrial operation Pin Function • ±50 ppm stability (or as specified) 1 Voltage Control • ±50 to ±100 ppm absolute (net) pull range 2 OE or NC • RoHS Compliant 3 Ground 4 Output Product Description 5 NC The FR Series voltage controlled crystal oscillator achieves wide pullability over a broad range of operating conditions and frequencies. The device is constructed with a hermetically sealed, quartz crystal resonator and low noise clock IC. The device, available on tape and reel, is contained in a 7.0 x 5.0mm ceramic package. 6 VCC Part Ordering Information: FR XXX YYYY Applications The FR Series VCXO is an ideal component in phase locked loop circuits that perform clock smoothing, clock/data recovery, or frequency translation and card synchronization functions, such as: Following the above format, Saronix-eCera part numbers will be assigned upon confirmation of exact customer requirements. Legacy Ordering Information - For Reference Only: S T1307 B A B - 19.4400 (T) Packaging blank = bulk packaged (T) = Tape & Reel* SaRonix • SD/HD Video decoding Model • SONET/SDH timing control and line cards • T3/E3 Platforms *full reel increments only (500pcs) Stability Tolerance B = ±50 ppm, 0 to +70°C E = ±50 ppm, -40 to +85°C • Satellite and microwave communications • Wireless base stations • xDSL and DSLAM Frequency (MHz) Linearity B = 10% Pullability (minimum APR) A = ±50 ppm B = ±100 ppm • VoIP SaRonix-eCera™ is a Pericom® Semiconductor company A: ProductFamily B: XXX = FrequencyCode C: YYYY = SpecificationCode • US: +1-408-435-0800 TW: +886-3-4518888 • All specifications are subject to change without notice. www.saronix-ecera.com FR 3.3V REV2009_MAR16_01.6 1 3.3V CMOS Ultra Low Jitter VCXO FR FR Series Voltage Controlled Crystal Oscillator (VCXO) Legacy ST1307 Series | 7.0 x 5.0mm Electrical Performance Parameter Output Frequency (F N) Supply Voltage Min. Typ. 1 +2.97 Units 32 MHz +3.63 V Supply Current 15 mA Frequency Stability ±50 ppm Operating Temperature Range +3.3 Max. -40 Output Logic 0, VOL Output Logic 1, VOH As specified See #1 and #2 below +85 °C As specified 10% V DD V Capacitive load 30 pF 90% V DD V Output Load Duty Cycle Notes 55 % Rise and Fall Time 45 8 ns Jitter, Total 20 ps pk-pk measured 50% V DD measured 20/80% V DD Notes: 1. 2. Stability includes all combinations of operating temperature, load changes, rated input (supply) voltage changes, initial calibration tolerance (25°C), aging (10 year at 40°C average effective ambient temperature), shock and vibration. For specifications othere than those listed, please contact sales. Frequency Modulation Function Parameter Absolute Pull Range (APR) Min. Typ. Max. Units ±50 to ±100 Control Voltage Range +0.3 Center Control Voltage ppm See #1 below +3.0 V DC As rated V For RMT center frequency 10 % Positive transfer slope +1.65 Monotonic Linearity Notes Input Impedance 50 kΩ Control voltage pin Modulation Bandwidth 50 kHz -3dB Notes: 1. As specified. APR is relative to the nominal output frequency FN; APR is inclusive (net) of frequency deviation due to stability. Output Enable / Disable Function Parameter Min. Input Voltage, Output Enable Typ. Max. Units 3.0 Input Voltage, Output High Impedance 0.3 Notes V or open V Output is high impendance Absolute Maximum Ratings Parameter Storage Temperature Min. Typ. -55 SaRonix-eCera™ is a Pericom® Semiconductor company • Max. Units +125 °C US: +1-408-435-0800 TW: +886-3-4518888 Notes • All specifications are subject to change without notice. www.saronix-ecera.com FR 3.3V REV2009_MAR16_01.6 2 3.3V CMOS Ultra Low Jitter VCXO FR FR Series Voltage Controlled Crystal Oscillator (VCXO) Legacy ST1307 Series | 7.0 x 5.0mm Test Circuit Test Point POWER SUPPLY 6 5 4 1 2 3 *15pF 0.01MF Control Voltage Output Control *15pF including probe and test fixturing Reflow Soldering Profile As per IPC/JEDEC J-STD-020C Temperature – °C 1 to 3°C/sec max 260 Peak 260°C for 10 sec max 1 to 3°C/sec 217 Time 60 to 90 sec 4 to 6 minutes max Output Waveform SaRonix-eCera™ is a Pericom® Semiconductor company • US: +1-408-435-0800 TW: +886-3-4518888 • All specifications are subject to change without notice. www.saronix-ecera.com FR 3.3V REV2009_MAR16_01.6 3 3.3V CMOS Ultra Low Jitter VCXO FR FR Series Voltage Controlled Crystal Oscillator (VCXO) Legacy ST1307 Series | 7.0 x 5.0mm Reliability Test Ratings This product is rated to meet the following test conditions: Type Parameter Test Condition Mechanical Shock MIL-STD-883, Method 2002, Condition B Mechanical Solderability JESD22-B102-D Method 2 (Preconditioning E) Mechanical Terminal strength MIL-STD-883, Method 2004, Condition D Mechanical Gross leak MIL-STD-883, Method 1014, Condition C Mechanical Fine leak MIL-STD-883, Method 1014, Condition A2 (R1 = 2x10 -8 atm cc/s) Mechanical Solvent resistance MIL-STD-202, Method 215 Environmental Thermal shock MIL-STD-883, Method 1011, Condition A Environmental Moisture resistance MIL-STD-883, Method 1004 Environmental Vibration MIL-STD-883, Method 2007, Condition A Environmental Resistance to soldering heat J-STD-020C Table 5-2 Pb-free devices (2 cycles max) Mechanical Drawing SaRonix-eCera™ is a Pericom® Semiconductor company • US: +1-408-435-0800 TW: +886-3-4518888 • All specifications are subject to change without notice. www.saronix-ecera.com FR 3.3V REV2009_MAR16_01.6 4