PI3USB221AZUAEX

Pb A product Line of Diodes Incorporated Lead-free Green PI3USB221A High-Speed USB2.0 1:2 Multiplexer/DeMultiplexer Switch with Signal Enable Features Description ¼¼VDD Operation at 2.5 V and 3.3 V ¼¼VI/O Accepts Signals up to 5.5 V ¼¼1.8-V Compatible Control-Pin Inputs ¼¼Low-Power Mode When OE Is Disabled (2 µA) ¼¼rON = 6Ω Maximum ¼¼ΔrON = 0.2Ω Typical ¼¼Cio(on) = 4pF Typical ¼¼Support Over Voltage Protection ¼¼Low Power Consumption (50 µA Maximum) ¼¼ESD Performance - IO Pins - 12KV HBM - 1KV CDM - VDD, GND, S, OE Pins - 4KV HBM - 1KV CDM ¼¼High Bandwidth (1.6 GHz Typical) ¼¼Totally Lead-Free & Fully RoHS Compliant (Notes 1 & 2) ¼¼Halogen and Antimony Free. “Green” Device (Note 3) ¼¼For automotive applications requiring specific change control (i.e. parts qualified to AEC-Q100/101/200, PPAP capable, and manufactured in IATF 16949 certified facilities), please contact us or your local Diodes representative. https://www.diodes.com/quality/product-definitions/ ¼¼Packaging (Pb-free & Green): - 10-contact, UDFN (ZW10) - 10-contact, UQFN (ZUA10) The PI3USB221A is a high-bandwidth switch specially designed for the switching of high-speed USB 2.0 signals in handset and consumer applications, such as cell phones, digital cameras, and notebooks with hubs or controllers with limited USB I/ Os. The wide bandwidth (1.1 GHz) of this switch allows signals to pass with minimum edge and phase distortion. The device multiplexes differential outputs from a USB host device to one of two corresponding outputs. The switch is bidirectional and offers little or no attenuation of the high-speed signals at the outputs. It is designed for low bit-to-bit skew and high channel-to-channel noise isolation, and is compatible with various standards, such as high-speed USB 2.0 (480 Mbps). The PI3USB221A offer over voltage protection for the D+/D- pins as per the USB 2.0 specification. With the chip power on or off if D+/D- pins are shorted to VBus (5V+/-5%), a less than 3.8V (typical) signal will transmit through 1D+/1D- and 2D+/2Doutput. Applications ¼¼Routes Signals for USB 1.0, 1.1, and 2.0 ¼¼Mobile Industry Processor Interface (MIPI) Signal Routing Block Diagram D+ 1D+ D- 1D- 2D+ Truth Table 2D- S OE Function X H Disconnect L L D = 1D H L D = 2D CONTROL LOGIC S OE Notes:       1. No purposely added lead. Fully EU Directive 2002/95/EC (RoHS), 2011/65/EU (RoHS 2) & 2015/863/EU (RoHS 3) compliant. 2. See https://www.diodes.com/quality/lead-free/ for more information about Diodes Incorporated’s definitions of Halogen- and Antimony-free, "Green" and Lead-free. 3. Halogen- and Antimony-free "Green” products are defined as those which contain