PI5A100Q

A product Line of Diodes Incorporated PI5A100 Precision, Wide-Bandwidth Quad SPDT Analog Switch Description Features ¼¼ Single Supply Operation (+2V to +6V) The PI5A100 is an improved Quad Single-pole double-throw (4SPDT) CMOS analog switch designed to operate with a single +2V to +6V power supply. The EN pin may be used to place all switches in a high-impedance state. This high precision device is ideal for low-distortion audio, video, and data switching and routing. ¼¼ Rail-to-Rail Analog Signal Dynamic Range ¼¼ Low On-Resistance (6Ω typ with 5V supply) Minimizes Distortion and Error Voltages ¼¼ On-Resistance Matching Between Channels, 0.4Ω Typ. Each switch conducts current equally well in either direction when on. In the off state each switch blocks voltages up to the powersupply rails. ¼¼ On-Resistance Flatness, 100mA ¼¼ TTL/CMOS Logic Compatible ¼¼ Low Power Consumption (0.5µW typ.) Block Diagram/Pin Configuration ¼¼ Packaging (Pb-free & Green Available): -16-pin SOIC (W) -16-pin QSOP (Q) IN 1 Applications ¼¼ Audio, Video Switching and Routing ¼¼ LAN Switches ¼¼ Telecommunication Systems ¼¼ Battery-Powered Systems Truth Table EN 0 0 1 PI5A100 IN 0 1 X Document Number DS40515 Rev 1-2 Decoder NC1 2 15 EN NO1 3 14 NC4 COM1 4 13 NO4 NC2 5 12 COM4 NO2 6 11 NC3 COM2 7 10 NO3 GND 8 ON Switch NC1, NC2, NC3, NC4 NO1, NO2, NO3, NO4 None. Disabled 16 VCC 9 COM3 Notes: 1. Switches shown for logic "0" input. 2. NC = Normally Closed; NO = Normally Open 1 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Absolute Maximum Ratings Thermal Information Voltages Referenced to Gnd VCC.........................................................................-0.5V to +7V Continuous Power Dissipation Narrow SOIC & QSOP (derate 8.7mW/ºC above +70ºC) . . . . . . . . . . . . . . . . . . 650mW VIN, VCOM, VNC, VNO (1)...............................-0.5V to VCC +2V ..................................................or 30mA, whichever occurs first Current (any terminal except COM, NO, NC)................... 30mA Current, COM, NO, NC (pulsed at 1ms, 10% duty cycle)...................................... 120mA Storage Temperature . . . . . . . . . . . . . . . . . . . . . -65ºC to +150ºC Lead Temperature (soldering, 10s). . . . . . . . . . . . . . . . . +300ºC Notes: 1. Signals on NC, NO, COM, or IN exceeding VCC o.r GND are clamped by internal diodes. Limit forward diode current to 30mA. 2. Caution: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress .only rating and operation of the device at these or any other conditions beyond those indicated in the operational sections of this speci fication is not implied. Electrical Specifications - Single +5V Supply (VCC = +5V ±10%, GND = 0V, VINH = 2.4V, VINL = 0.8V) Symbol Parameter TestConditions Temp. Min.(1) Full 0 Typ.(2) Max.(1) Units VCC V Analog Switch VANALOG Analog Switch Range(1) RON On-Resistance ∆RON On-Resistance Match Between Channels(6) RFLAT(ON) On-Resistance Flatness(5) INO(OFF) or INC(OFF) NO or NC OFF Leakage(6) 25 VCC = 4.5V, ICOM = -30mA, VNO or VNC = +2.5V VCC = 5V, ICOM = -30mA, VNO or VNC = +2.5V VCC = 5.5C, ICOM = 0V, VNO or VNC = 4.5V COM OFF Leakage Current(6) VCC = 5.5V, ICOM = 4.5V, VNO or VNC = ± 4.5V ICOM(ON) COM ON Leakage Current(6) VCC = 5.5V, ICOM = 4.5V, VNO or VNC = ± 4.5V Document Number DS40515 Rev 1-2 Full 10 12 25 0.8 2 Full ICOM(OFF) PI5A100 8 2 4 25 2 3 Full 4 25 Full 0.07 -80 25 Full 80 0.01 -80 25 Full Ω 80 nA 0.016 -80 80 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Electrical Specifications - Single +5V Supply (VCC = +5V ±10%, GND = 0V, VINH = 2.4V, VINL = 0.8V) CONTINUED Symbol Parameter TestConditions VIH Input High Voltage Guaranteed logic High Level VIL Input Low Voltage Guaranteed logic Low Level IINH Input Current with Input Voltage High VIN = 2.4V, all others = 0.8V IINL Input Current with Input Voltage Low VIN = 0.8V, all others = 2.4V Temp. Min.(1) Full 2 Typ.(2) Max.(1) Units Logic Input 0.8 Full -1 0.005 1 -1 0.005 1 8 15 V µA Dynamic tON 25 Turn-On Time VCC = 5V, See Figure 1 Full 20 25 3.5 tOFF Turn-Off Time Q Charge Injection(3) CL = 1nF, VGEN = 0V, RGEN = 0Ω, See Figure 2 OIRR Off Isolations RL = 50Ω, CL = 5pF, f = 10MHz, See Figure 3 -57 XTALK Crosstalk(8) RL = 50Ω, CL = 5pF, f = 10MHz, See Figure 4 -100 C(OFF) NC or NO Capacitance f=1kHz, See Figure 5 CCOM(OFF) COM OFF Capacitance CCOM(ON) COM ON Capacitance f = 1kHz, See Figure 6 BW -3db Bandwidth RL = 50Ω See Figure 7 D Distortion RL = 10kΩ 7 Full 10 25 10 ns pC dB 8 pF 14 18 Full 230 MHz 0.2 % Supply VCC Power-Supply ICC Postitive Supply Current Full 2 VCC = 5.5V, VIN = 0V or VCC, all channels on or off 6 V 1 µA Notes: 1. The algebraic convention, where the most negative value is a minimum and the most positive is a maximum, is used in this data sheet. 2. Typical values are for DESIGN AID ONLY, not guaranteed or subject to production testing. 3. Guaranteed by design 4. ΔRΟΝ = RΟΝ max - RΟΝ min 5. Flatness is defined as the difference between the maximum and minimum value of On-Resistance measured. 6. Leakage parameters are 100% tested at maximum rated hot temperature and guaranteed by correlation at +25ºC. 7. Off Isolation = 20log10 [ VCOM / (VNO or VNC) ]. See figure 3. 8. Between any two switches. See figure 4.- PI5A100 Document Number DS40515 Rev 1-2 3 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Electrical Specifications - Single +3.3V Supply (VCC = +5V ±10%, GND = 0V, VINH = 2.4V, VINL = 0.8V) Symbol Parameter TestConditions Temp. Min.(1) Typ.(2) Max.(1) Units VCC V Analog Switch Analog Switch Range(1) RON On-Resistance ∆RON On-Resistance Match Between Channels(6) RFLAT(ON) On-Resistance Flatness(5) 0 25 VCC = 4.5V, ICOM = -30mA, VNO or VNC = +2.5V 12 18 Full 25 5 Ω Full VCC = 5V, ICOM = -30mA, VNO or VNC = +2.5V 25 2 4 Full 5 Dynamic tON 25 Turn-On Time VCC = 5V, See Figure 1 14 Full 25 tOFF Turn-Off Time Q Charge Injection(3) CL = 1nF, VGEN = 0V, RGEN = 0Ω, See Figure 2 25 Postitive Supply Current VCC = 3.6V, VIN = 0V or VCC, all channels on or off Full 25 40 4.5 Full 12 ns 20 5 10 pC 1 µA Supply ICC PI5A100 Document Number DS40515 Rev 1-2 4 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Typical Operating Characteristics (Ta=+25ºC, unless otherwise noted) RON vs. VCOM RON vs. VCOM and Temperature 16 40 A: TA = 90°C B: TA = 25°C C: TA = -40°C VCC = +5V Vcc = +2V 12 RON RON 30 20 A 8 B +3.3V 10 +5V 1 2 3 4 VCOM (V) 4 +7V 5 6 0 7 1 0 Leakage Currents vs. Analog Voltage 2 3 5 4 Leakage Current vs. Temperature 10nA 20 VCC = +5V 1nA 16 IA(ON) ) or IB(ON ) ON M( I CO 100pA 8 IA(ON) or IB(ON) Leakage Leakage (pA) C 0 F) OF M( O IC 10pA 1pA -8 0.1pA -16 0 1 2 3 4 0.01pA -40 5 0 Temperature (˚C) 80 Crosstalk and Off-Isolation vs. Frequency Charge Injection vs. Analog Voltage 15 -100 10 Crosstalk -80 VCC = 5V -60 5 (dB) Q-Charge Injection (pC) 40 Temperature (˚C) Off Isolation -40 VCC = 3.3V 0 -20 VCC = 5V -5 0 0 1 2 3 4 5 1 VCOM (V) PI5A100 Document Number DS40515 Rev 1-2 2 4 6 8 10 20 40 60 80 100 200 Frequency (MHz) 5 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Insertion Loss vs. Frequency Input Switching Threshold vs. Supply Voltage 0 5 -1 4 -3 -3dB Point -4 3 VIN, (V) Insertion Loss (dB) -2 -5 -6 2 -7 VCC = +5V R L= 50! -8 -9 1 0 -10 1 3 30 6 10 Frequency (MHz) 300 60 100 3 RON vs. VCOM and Single Supply VCC (V) 20 20 tON tOFF (ns) 15 15 10 t ON, 10 tON 5 5 0 7 6 Switching Times vs. Temperature 25 t ON, t OFF (ns) 5 4 tOFF t OFF 3 3.5 4 4.5 5 5.5 V CC (V) 6 6.5 0 7 -40 0 40 80 120 Temperature (°C) Supply Current vs. Temperature 10 VCC = +5V ICC (nA) 1 0.1 0.01 0.001 -40 0 40 80 Temperature (°C) PI5A100 Document Number DS40515 Rev 1-2 6 www.diodes.com December 2017 Diodes Incorporated A product Line of Diodes Incorporated PI5A100 Test Circuits/Timing Diagrams +5V Logic +3V Input 0V Vcc Switch Input +3V* NO or NC COM RL 100Ohm IN Logic Input VOUT tr