PI74LCX16244AE

PI74LCX16244 Fast CMOS 3.3V 16-Bit Buffer/Line Driver Features Description • Functionally compatible with FCT3, LVT, and 74 series 16244 families of products • 3-State outputs • 5V Tolerant inputs and outputs • 2.0V – 3.6V VDD supply operation • Balanced sink and source output drives (24mA) • Low ground bounce outputs • Power Down High Impedance inputs and outputs • Supports live insertion • ESD Protection exceeds 2000V, Human Body Model 200V, Machine Model • Packaging (Pb-free & Green Available): – 48-pin 300-mil wide plastic SSOP (V) – 48-pin 240-mil wide plastic TSSOP (A) Pericom Semiconductor’s PI74LCX16244 is a 16-bit buffer/line driver designed for driving memory loads. With its balanced-drive characteristics, this high-speed, low power device provides lower ground bounce, transmission line matching of signals, fewer line reflections and lower EMI and RFI effects. This makes it ideal for driving on-board buses and transmission lines. This device is designed with three-state controls to operate in a Quad-Nibble, Dual-Byte, or a single 16-bit word mode. The PI74LCX16244 can be driven from either 3.3V or 5.0V devices allowing this device to be used as a translator in a mixed 3.3V/5.0V system. Block Diagram 1OE 3OE 1A0 1Y0 3A0 3Y0 1A1 1Y1 3A1 3Y1 1A2 1Y2 3A2 3Y2 1A3 1Y3 3A3 3Y3 2OE 09-0005 4OE 2A0 2Y0 4A0 4Y0 2A1 2Y1 4A1 4Y1 2A2 2Y2 4A2 4Y2 2A3 2Y3 4A3 4Y3 1 PS2087H 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver Maximum Ratings (Above which the useful life may be impaired. For user guidelines, not tested.) Storage Temperature ............................................................. –65°C to +150°C Ambient Temperature with Power Applied ............................ –40°C to +85°C Supply Voltage to Ground Potential (Inputs & VDD Only) ..... –0.5V to +7.0V Supply Voltage to Ground Potential (Outputs & D/O Only) ... –0.5V to +7.0V DC Input Voltage ..................................................................... –0.5V to +7.0V DC Output Current............................................................................... 120 mA Note: Stresses greater than those listed under MAXIMUM RATINGS may cause per ma nent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability. Power Dissipation .................................................................................... 1.0W Recommended Operating Conditions Parameter VDD Supply Voltage VI Input Voltage VO Output Voltage IOH/IOH Output Current TA ∆t/∆V 09-0005 Description Min. Max. Operating 2.0 3.6 Data Retention 1.5 3.6 0 5.5 HIGH or LOW state 0 VDD 3-state 0 5.5 VDD = 3.0V - 3.6V ±24 VDD = 2.7V ±12 Operating Temperature Input Edge Rate V = 0.8V - 2.0V, VDD = 3.0V 2 Units V mA -40 85 °C 0 10 ns/V PS2087H 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver Truth Table(1) Pin Description Pin Name Description Inputs Output XOE 3-State Output Enable Inputs (Active LOW) XOE XA X X YX XAX Inputs L L L XYX 3-State Outputs L H H GND Ground H X Z VDD Power Notes: 1. H = High Voltage Level, X = Don’t Care, L = Low Voltage Level, Z = High Impedance Pin Configuration 1OE 1 2 48 47 2OE 3 4 46 45 1A1 44 43 1A2 1Y3 5 6 VDD 7 42 VDD 8 9 10 41 40 39 2A0 11 12 38 37 2A2 13 14 15 16 36 35 34 33 3A0 17 18 32 31 19 30 20 21 22 29 28 27 23 24 26 25 1 Y0 1 Y1 GND 1 Y2 2Y0 2Y1 GND 2 Y2 2 Y3 3 Y0 3 Y1 GND 3Y2 3Y3 VDD 4Y0 4Y1 GND 4 Y2 4 Y3 4OE 09-0005 1A0 GND 1A3 2A1 GND 2A3 3A1 GND 3A2 3A3 VDD 4A0 4A1 GND 4A2 4A3 3OE 3 PS2087H 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver DC Electrical Characteristics (Over the Operating Range, TA = –40°C to +85°C, VDD = 2.7V to 3.6V) Parameters Test Conditions(1) Description VIH Input HIGH Voltage Guaranteed Logic HIGH Level VIL Input LOW Voltage Guaranteed Logic LOWLevel VOH Output HIGH Voltage Output LOW Voltage Typ.(2) Max. 0.8 VDD = 2.7 - 3.6 IOH = -0.1mA VDD -0.2 IOH = -12mA 2.2 IOH = -18mA 2.4 IOH = -24mA 2.2 V VDD =2.7 - 3.6 IOL = 0.1mA 0.2 VDD = 2.7 IOL = 12mA 0.4 IOL = 16mA 0.4 IOL = 24mA 0.55 VDD = 3.0 Units 2.0 VDD = 2.7 VDD = 3.0 VOL Min. VIK Clamp Dioide Voltage VDD = Min., IIN = -18mA II Input Leakage Current 0 ≤ VI ≤ 5.5V VDD = 2.7 -3.6 ±5 IOZ Tri-State Output Leakage 0 ≤ VO ≤ 5.5V VI = VIH or VIL VDD = 2.7 -3.6 ±5 IOFF Power Down Disable VDD = 0V, VIN or VOUT ≤ 5.5V IDD Quiescent Power supply current VDD = Max. VIN = GND or VDD ∆IDD Quiescent Power supply current TTL Inputs High VDD = Max. VIN = VDD =0.6V(3) -0.7 -1.2 10 0.1 μA 10 500 Notes: 1. For Max. or Min. conditions, use appropriate value specified under Electrical Characteristics for the applicable device type. 2. Typical values are at VDD = 3.3V, +25°C ambient. 3. Per TTL driven input; all other inputs at VDD or GND. Capacitance Parameters Description Test Conditions Typ. CIN Input Capacitance VDD = Open, VI = 0V or VDD 3 COUT Output Capacitance VDD = 3.3V, VI = 0V or VDD 3 CPD Power Dissipation Capacitance VDD = 3.3V, VI = 0V or VDD, F = 10 MHz 20 09-0005 4 PS2087H Units pF 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver Switching Characteristics over Operating Range Parameters Description tPHL Propagation Delay, DXX to OXX tPZH Output Enable time tPHZ Output Disable time tsk(0) Output Skew(1) Test Conditions CL = 50pF RL = 500Ω VDD = 3.3V±0.3 VDD = 2.7V Min. Max. Min. Max. 1.5 4.5 1.5 5.2 1.5 5.5 1.5 6.3 1.5 5.4 1.5 5.7 Units ns 1.0 Notes: 1. Skew between any two outputs, of the same package, switching in the same direction. Dynamic Switching Characteristics (TA = +25°C) Parameters Description VOLP Dynamic LOW peak voltage VOLV Dynamic LOW valley voltage Test Conditions(1) VDD = 3.3V, CL = 50pF, VIH = 3.3V, VIL = 0V Typ. Units 0.8 V Notes: 1. Measured with 15 outputs switching from High-to-Low or Low-to-High. The remaining output is measured in the LOW state. 09-0005 5 PS2087H 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver DOCUMENT CONTROL NO. PD - 1501 48 REVISION: G DATE: 03/09/05 .236 .244 6.0 6.2 See Note 4 1 .488 12.4 .496 12.6 See Note 3 .047 1.20 Max SEATING PLANE .004 0.09 .008 0.20 X.XX X.XX DENOTES DIMENSIONS IN MILLIMETERS .0197 BSC 0.50 .002 .006 0.05 0.15 .007 .010 0.17 0.27 Note: 1. Controlling dimensions in millimeters. 2. Ref: JEDEC MO-153F/ED 3. Dimension does not include mold flash, protrusions or gate burrs. Mold flash, protrusions and gate burrs shall not exceed 0.15mm per side. 4. Dimension does not include interlead flash or protrusion. Interlead flash or protrusion shall not exceed 0.25mm per side. 0.45 .018 0.75 .030 .319 BSC 8.1 Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 • www.pericom.com DESCRIPTION: 48-Pin 240-Mil Wide TSSOP PACKAGE CODE: A 09-0005 6 PS2087H 11/10/09 PI74LCX16244 3.3V 16-Bit Buffer/Line Driver DOCUMENT CONTROL NO. PD - 1401 48 REVISION: E DATE: 03/09/05 .291 .299 7.39 7.59 .395 .420 10.03 10.67 Gauge Plane .010 0.25 .02 0.51 .04 1.01 1 .015 0.381 x 45˚ .025 0.635 .008 0.20 Nom. .620 .630 15.75 16.00 .110 2.79 Max 0-8˚ .008 0.20 .016 0.40 .008 0.20 .0135 0.34 .025 BSC 0.635 X.XX DENOTES DIMENSIONS X.XX IN MILLIMETERS Pericom Semiconductor Corporation 3545 N. 1st Street, San Jose, CA 95134 1-800-435-2335 • www.pericom.com Notes: 1) Controlling dimensions in inches. 2) Ref: JEDEC MO-118B/AA DESCRIPTION: 48-Pin, 300-Mil Wide, SSOP PACKAGE CODE: V Note: • For latest package info, please check: http://www.pericom.com/products/packaging/mechanicals.php Ordering Information Ordering Code PI74LCX16244AEX PI74LCX16244VEX Package Code A V Package Description Pb-free & Green, 48-pin 240 mil wide Plastic TSSOP Pb-free & Green, 48-pin 300-mil wide plastic SSOP Notes: • Thermal characteristics can be found on the company web site at www.pericom.com/packaging/ • E = Pb-free & Green • Adding an X suffix = Tape/Reel Pericom Semiconductor Corporation • 1-800-435-2336 • www.pericom.com 09-0005 7 PS2087H 11/10/09