SRBA-03A1A0

NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output SRBA-03A1Ax Series • • • • • Non-Isolated Fixed Frequency High Efficiency High Power Density Active Low/High (option) RoHS Compliant • • • • • Under-Voltage Lockout (UVLO) OCP/SCP Remote On/Off Wide Trim Range Wide Input Range Description The Bel SRBA-03A1Ax modules are a series of non-isolated dc/dc converters that deliver up to 3 A of output current with full load efficiency of 93% at 5.0 V output. These modules provide precisely regulated voltage programmable via external resistor from 0.75 V to 5.5 V over a wide range of input voltage. Their open-frame construction and small footprint enable designers to develop cost and space-efficient solutions. Standard features include remote On/Off, programmable output voltage, over-temperature protection, over current protection, short circuit protection, and under-voltage lockout. Part Selection Output Voltage 0.75 V - 5.0 V Input Voltage 8.3 V - 14 V Max. Output Current 3A Max. Output Power 15 W Typical Efficiency at 5.0V 93% Model Number Active High SRBA-03A1A0 Model Number Active Low SRBA-03A1AL Note: Add “G” suffix at the end of the model number to indicate Tray Packaging. Absolute Maximum Ratings Parameter Input Voltage (continuous) Output Enable Terminal Voltage Ambient Temperature Storage Temperature Min -0.3 V -0.3 V -40 °C -55 °C Typ Max 15 V 15 V 85 °C 125 °C Notes Note: All specifications are typical at 25°C unless otherwise stated. Input Specifications Parameter Input Voltage Input Current (full load) Vo=5.0 V Vo=3.3 V Vo=0.75 V Input Current (no load) Vo=5.0 V Vo=3.3 V Vo=0.75 V 55 mA 40 mA 15 mA 65 mA 50 mA 20 mA Min 8.3 V Typ 12 V 1.35 A 0.90 A 0.24 A Max 14 V 2.00 A 1.30 A 0.35 A Notes Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output Input Specifications (continued) Parameter Remote Off Input Current Input Reflected Ripple Current (pk-pk) Vo=5.0 V Vo=3.3 V Vo=0.75 V Input Reflected Ripple Current (rms) Vo=5.0 V Vo=3.3 V Vo=0.75 V 2 I t Inrush Current Transient Turn-on Voltage Threshold Turn-off Voltage Threshold Min 7.6V 7.0V Typ 3 mA 75 mA 50 mA 20 mA 20 mA 15 mA 5 mA 2 0.01 A s 7.9 V 7.8 V Max 6 mA 120 mA 90 mA 35 mA 60 mA 30 mA 15 mA 2 0.02 A s 8.2 V 8.1 V Notes Tested with two 100 uF/25 V tantalum input capacitors & simulated source impedance of 1 uH, 5 Hz to 20 MHz. Output Specifications Parameter Output Voltage Set Point Output Voltage Set Point Load Regulation Line Regulation Regulation Over Temperature (-40 °C to +85 °C) Output Current Current Limit Threshold Short Circuit Surge Transient Ripple and Noise (pk-pk) Vo=5.0 V Vo=3.3 V Vo=0.75 V Ripple and Noise (rms) Vo=5.0 V Vo=3.3 V Vo=0.75 V Turn on Time Overshoot at Turn on Output Capacitance Transient Response 50% ~ 100% Max Load Settling Time 100% ~ 50% Max Load Settling Time All 200 mV 50 uS 200 mV 50 uS 300 mV 80 uS 300 mV 80 uS di/dt=2.5 A/uS; Vin=12 V; and with 10 uF/10 V tantalum capacitor and 1 uF/10 V ceramic capacitor at the output 0 uF 20 mV 10 mV 5 mV 5 mS 0% 40 mV 25 mV 15 mV 8 mS 3% 1200 uF 65 mV 45 mV 20 mV 100 mV 80 mV 35 mV Tested with 0-20 MHz, with 10 uF/10 V tantalum capacitor and 1uF/10 V ceramic capacitor at the output Min -2% Vo,set -2.5% Vo,set 0.5% Vo,set 0.4% Vo,set 0A 5A Typ 0.4% Vo,set 0.3% Vo,set 0.5% Vo,set 0.15 A s 2 Max 2% Vo,set 3.5% Vo,set 0.5% Vo,set 0.4% Vo,set 0.8% Vo,set 3A 12 A - Notes Vin=12 V, lo=lomax, full load Over all operating input voltages, resistive loads and temperature conditions Io=Io, min to Io, max Vin=Vin, min to Vin, max Note: All specifications are typical at nominal input (Vin=12 V), full load at 25 °C unless otherwise stated. Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output General Specifications Parameter Efficiency Vo=5.0 V Vo=3.3 V Vo=0.75 V Switching Frequency Over Temperature Shutdown MTBF Dimensions (Surface Mount) Inches (L × W × H) Millimeters (L × W × H) Weight 90% 88% 76% 93% 91% 80% 300 kHz 135 °C 6,740,000 hours 0.8 x 0.45 x 0.251 20.32 x 11.42 x 6.38 3g Calculated Per Bell Core SR-332 (IO = Nominal; Ta = 25 °C) Measured at Vin=12 V, full load (Current Source) Min Typ Max Notes - - Note: All specifications are typical at 25 °C unless otherwise stated. Control Specifications Parameter Remote On/Off Signal Low (Unit Off) Signal High (Unit On) Signal Low (Unit On) Signal High (Unit Off) Output Voltage Trim Range (Wide Trim) Min -0.3 V 2.5 V -0.3 V 2.5 V 0.7525 V Typ Max 0.4 V 14 V 0.4 V 14 V 5.0 V Notes SRBA-03A1A0; Remote On/Off pin open, Unit on. SRBA-03A1AL; Remote On/Off pin open, Unit on. Output Trim Equations Equation for calculating the trim resistor (in kΩ) given the desired adjusted voltage (Vadj) is shown below. The Trim Up resistor should be connected between the Trim pin and Ground. Vout Rtrim = 10.507 −1 Vadj − 0.7525 Module Trim GND Rtrim Equation for calculating the trim voltage (in V) given the desired adjusted voltage (Vadj) is shown below. The Trim Up voltage should be connected between the Trim pin and Ground. Vout Vtrim = 0.7 − 0.0667 × (Vadj − 0.7525) Module Trim Vtrim GND Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output Efficiency Data MODULE 5.0V 100.0% 95.0% 90.0% 85.0% 80.0% 75.0% 70.0% 65.0% 60.0% 0.30A 0.75A 1.50A 2.25A OUTPUT CURRENT EFFICIENCY 8.3V 12.0V 14.0V 3.00A MODULE 3.3V 95.0% 90.0% 85.0% 80.0% 75.0% 70.0% 65.0% 60.0% 0.30A EFFICIENCY 8.3V 12.0V 14.0V 0.75A 1.50A 2.25A OUTPUT CURRENT 3.00A MODULE 0.75V 85.0% 80.0% 75.0% 70.0% 65.0% 60.0% 55.0% 50.0% 0.30A 1.75A 1.50A 2.25A OUTPUT CURRENT EFFICIENCY 8.3V 12.0V 14.0V 3.00A Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output Thermal Derating Curves Vin=12 V, Vo=5.0 V Vin=12 V, Vo=3.3 V Vin=12 V, Vo=0.75 V Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel 201-432-0463 • Fax 201-432-9542 • www.belfuse.com NON-ISOLATED DC/DC CONVERTERS 8.3 V-14 V Input 0.75 V-5.0 V/3 A Output Mechanical Outline Pin Connections Pin 1 2 3 4 5 Function Remote On/Off Vin Ground Trim Vout PAD SIZE: MIN: 0.12"* 0.095" (3.05mm * 2.41mm) MAX: 0.135"* 0.11" (3.43mm * 2.79mm) RoHS Compliance Complies with the European Directive 2002/95/EC, calling for the elimination of lead and other hazardous substances from electronic products. ©2005 Bel Fuse Inc. Specifications subject to change without notice. 120205 CORPORATE Bel Fuse Inc. 206 Van Vorst Street Jersey City, NJ 07302 Tel 201-432-0463 Fax 201-432-9542 www.belfuse.com FAR EAST Bel Fuse Ltd. 8F/ 8 Luk Hop Street San Po Kong Kowloon, Hong Kong Tel 852-2328-5515 Fax 852-2352-3706 www.belfuse.com EUROPE Bel Fuse Europe Ltd. Preston Technology Management Centre Marsh Lane, Suite G7, Preston Lancashire, PR1 8UD, U.K. Tel 44-1772-556601 Fax 44-1772-888366 www.belfuse.com