BG13D

BeRex 5-4000 MHz Cascadeable InGaP HBT Gain Block Device Features  32dBm Output IP3 at 7dBm/tone at 900MHz  24.5dB Gain at 900 MHz  19dBm P1dB at 900MHz  Highly Reliable InGaP/GaAs HBT Technology  Temperature Compensation Circuit patent  SOT-89 Surface Mount Package  50 ohm Cascadeable  Lead-free/Green/RoHS compliant Application: commercial, space, military wireless system Electrical Specifications (Ta = 25C, Vs = 5.0V) Parameters Frequency Range Gain 900 MHz 1900 MHz 2450 MHz 900 MHz 1900 MHz 2450 MHz 900 MHz 1900 MHz 2450 MHz 900 MHz 1900 MHz 2450 MHz 900 MHz 1900 MHz 2450 MHz Vc = 5.0V BG13D Test Conditions Min 5 23.5 20.5 19.0 Typ 24.5 21.5 20.0 -15.0 -14.0 -13.0 -11.0 -11.0 -11.0 32.0 32.0 31.5 19.0 19.0 19.0 65 5.0 -0.007 85 Max 4000 25.5 22.5 21.5 Unit MHz dB S11 dB S22 dB OIP3 P1dB Ic Vc dG/dT Rth 30.0 30.0 29.5 18.0 18.0 18.0 57 dBm dBm 75 mA V dB/C C/W Thermal Resistance Test conditions unless otherwise noted. 1. Device performance is measured on BeRex evaluation board at 25C, 50 ohm system 2. OIP3 measured with two tones at an output power of 7dBm/tone separated by 1MHz. http: //www.berex.com BeRex Absolute Maximum Ratings Parameters Operating Case temperature Storage Temperature Junction Temperature Operating Voltage Supply Current Input RF Power BG13D Rating -40 to +85C -55 to +155C +220C +5.5V 150mA 23dBm Operation of this device above any of these parameters may result in permanent damage. [I-V Characteristics] [Generic SOT89 Evaluation Board] BeRex Evaluation Board MMIC Innovator *Dielectric constant is 4.2 *RF pattern width 52mil *31mil thick FR4 PCB Application Circuit: 5-4000 MHz Schematic Diagram C3 C4 C5 +5V BOM C1 C2 100pF 100pF 100pF 1000pF 10uF 39nH Tolerance ± 5% ± 5% ± 5% ± 5% ± 20% 5% L1 C3 RFin C1 BG13D C2 RFout C4 C5 L1* *Note: Less than 20nH improves RF performance at frequencies over 1.9GHz. 40nH or higher value L1 improves RF performance at frequencies under 500MHz. Optimum value of L1 may vary with board design. http: //www.berex.com BeRex Typical Device Data BG13D S-parameters (Vc=5V, Ic=65mA, T=25C) (Vdevice = 5.0V, Icc = 65mA, T = 25 C, calibrated to device leads) Freq [MHz] 100 500 1000 1500 2000 2500 3000 3500 4000 S11 [Mag] 0.371 0.184 0.148 0.176 0.271 0.377 0.392 0.340 0.208 S11 [Ang] -46.71 -47.05 -79.53 -125.09 -163.96 163.00 135.99 101.23 39.13 S21 [Mag] 17.980 19.135 17.280 14.637 12.220 10.452 9.372 8.821 8.471 S21 [Ang] -142.37 144.06 96.74 56.43 18.73 -13.09 -39.99 -74.62 -109.01 S12 [Mag] 0.028 0.031 0.032 0.033 0.032 0.034 0.035 0.040 0.047 S12 [Ang] 44.36 -4.24 -23.22 -41.49 -58.31 -75.27 -82.89 -107.30 -131.75 S22 [Mag] 0.506 0.374 0.314 0.321 0.378 0.431 0.440 0.368 0.203 S22 [Ang] 106.93 -26.08 -90.77 -140.62 -171.51 167.630 145.411 119.240 78.293 S-Parameter http: //www.berex.com BeRex BG13D Typical Performance (Vc = 5V, Ic = 65mA, T = 25C) Freq MHz 500 900 1900 S21 dB 25.4 24.5 21.5 S11 dB -13.0 -15.0 -12.0 S22 dB -8.4 -10.1 -8.8 P1 dBm 19.0 19.0 19.0 OIP3 dBm 32.0 32.0 32.0 NF dB 4.0 4.0 4.2 Typical Performance (Vc = 4.7V, Ic = 44mA, T = 25C) Freq MHz 70 500 900 1900 S21 dB 25.1 24 23.6 21.2 S11 dB -11.0 -9.5 -10.4 -10.3 S22 dB -4.8 -5.5 -6.2 -7.5 P1 dBm 14.8 15.2 15.2 16.1 OIP3 dBm 28.0 26.0 26.5 27.5 NF dB 4.0 4.0 4.2 Typical Performance (Vc = 4.5V, Ic = 34mA, T = 25C) Freq MHz 70 500 900 1900 S21 dB 24.8 23.1 23.1 20.6 S11 dB -9.8 -8.6 -9.4 -9.5 S22 dB -4.3 -5.0 -5.5 -6.7 P1 dBm 14.4 14.1 14.1 13.8 OIP3 dBm 26.0 23.0 23.0 23.5 NF dB 4.0 4.0 4.0 4.2 2140 20.7 -12.0 -8.5 19.0 31.5 4.3 2450 20.0 -10.0 -8.0 19.0 31.0 4.5 3500 19.0 -8.5 -7.4 19.0 30.0 4.8 2140 20.5 -10.0 -7.4 13.5 26.5 4.3 2450 19.8 -10.1 -7.9 16.1 27.5 4.5 3500 17.9 -8.6 -9.2 15.4 26.5 4.8 2140 20.5 -9.3 -6.6 13.8 23.0 4.3 2450 19.3 -9.4 -7.2 15.2 23.5 4.5 3500 17.7 -8.1 -8.5 15.4 22.5 4.8 http: //www.berex.com BeRex WCDMA 4FA 2140 -60dBc BG13D WCDMA 6FA 2140 -60dBc http: //www.berex.com BeRex ACLR BG13D Device Performance Pin-Pout-Gain 30 25 20 45% 40% 35% 30% 20% 15% 10% 5% 0% -20 -15 -10 -5 0 25 20 15 10 5 0 -16 -11 -6 -1 4 Po/G 15 10 5 0 Pin [dBm ] PAE Pin [dBm ] 900MHz, 5V/65mA 1900 MHz, 5V/65mA http: //www.berex.com PAE 25% 20% 18% 16% 14% 12% 10% 8% 6% 4% 2% 0% Po/G BeRex OIP3 BG13D http: //www.berex.com BeRex ACPR BG13D Gain Flatness http: //www.berex.com BeRex BG13D Package Outline Dimension Suggested PCB Land Pattern and PAD Layout PCB Land Pattern PCB Mounting 0.40 1.30 0.40 Ø0.40 0.40 0.75 1.20 1.20 1.20 1.20 1.50 1.00 0.65 2.80 2.00 0.50 Note : All dimension are in millimeters Visit http://www.berex.com for PCB layout http: //www.berex.com BeRex BG13D Tape & Reel SOT89 Packaging information: Tape Width (mm): 12 Reel Size (inches): 7 Device Cavity Pitch (mm): 8 Devices Per Reel: 1000 Lead plating finish 100% Tin Matte finish. (All BeRex products undergoes a 1 hour, 150 degree C, Anneal bake to eliminate thin whisker growth concerns) MSL / ESD Rating ESD Rating: Value: Test: Standard: MSL Rating: Standard: Class 1C Passes